Pioneer VSX-521-K manual

Pioneer VSX-521-K
8.5 · 9
PDF manual
 · 120 pages
English
manualPioneer VSX-521-K
2
En
The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance.The lightning flash with arrowhead symbol, within an equilateral triangle, is intended toalert the user to the presence of uninsulated“dangerous voltage” within the product’s enclosure that may be of sufficientmagnitude to constitute a risk of electric shock to persons.CAUTION:TO PREVENT THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER-SERVICEABLE PARTSINSIDE. REFER SERVICING TO QUALIFIEDSERVICE PERSONNEL.

CAUTION

RISK OF ELECTRIC SHOCKDO NOT OPEN

IMPORTANT

D3-4-2-1-1_A1_En
NOTE:This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However,there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on,the user is encouraged to try to correct the interference by one or more of the following measures:— Reorient or relocate the receiving antenna.— Increase the separation between the equipment and receiver.— Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.— Consult the dealer or an experienced radio/TV technician for help.
D8-10-1-2_A1_En
Information to UserAlterations or modifications carried out without appropriate authorization may invalidate the user’s right to operatethe equipment. D8-10-2_A1_En
WARNING
This equipment is not waterproof. To prevent a fire orshock hazard, do not place any container filled withliquid near this equipment (such as a vase or flower pot) or expose it to dripping, splashing, rain ormoisture. D3-4-2-1-3_A1_En
WARNING
Before plugging in for the first time, read the followingsection carefully.The voltage of the available power supply differsaccording to country or region. Be sure that the power supply voltage of the area where this unit will be used meets the required voltage (e.g., 230 V or 120 V) written on the rear panel.D3-4-2-1-4*_A1_En

VENTILATION CAUTION

When installing this unit, make sure to leave space around the unit for ventilation to improve heat radiation (at least 40 cm at top, 20 cm at rear, and 20 cm at eachside).

WARNING

Slots and openings in the cabinet are provided for ventilation to ensure reliable operation of the product,and to protect it from overheating. To prevent firehazard, the openings should never be blocked orcovered with items (such as newspapers, table-cloths, curtains) or by operating the equipment on thick carpetor a bed.D3-4-2-1-7b*_A1_En
WARNING
T
o prevent a fire hazard, do not place any naked flamesources (such as a lighted candle) on the equipment.D3-4-2-1-7a_A1_En
Operating EnvironmentOperating environment temperature and humidity:+5 °C to +35 °C (+41 °F to +95 °F); less than 85 %RH (cooling vents not blocked)Do not install this unit in a poorly ventilated area, or inlocations exposed to high humidity or direct sunlight (or strong artificial light) D3-4-2-1-7c*_A1_En
CautionTo prevent fire hazard, the Class 2 Wiring Cable should be used for connection with speaker, and should be routed away from hazards to avoid damageto the insulation of the cable.D3-7-13-67*_A1_En
VSX-521_UCSMXCN_En.book 2 ページ 󲃟󲃝󲃞󲃝年󲃞󲃟月󲃟󲃞日 火曜日 午後󲃟時󲃠5分

View the manual for the Pioneer VSX-521-K here, for free. This manual comes under the category receivers and has been rated by 9 people with an average of a 8.5. This manual is available in the following languages: English. Do you have a question about the Pioneer VSX-521-K or do you need help? Ask your question here

Need help?

Do you have a question about the Pioneer and is the answer not in the manual?

  • Receive updates on solutions
  • Get answers to your question

Question and answer

Number of questions: 4
V
Varga istvánSeptember 2, 2020

Hi, I have a question. I connected the receiver to the TV via HDMI-1, and when I turn off the TV or unplug the receiver, the receiver also turns off and doesn't turn back on unless I reconnect it to the TV. Thank you very much in advance for your response, it's very important.

This message has been automatically translated
A
Alvin BergJanuary 16, 2022

How can I choose between the various sound options, such as concert or rock, using the IR unit or directly on the receiver?

How can I choose between the various sound options, such as concert or rock, using the IR unit or directly on the receiver?
zoom-in
View photo
This message has been automatically translated
J
Jim LowDecember 29, 2022

Does this model have the option of selecting between A or B speakers?

T
TitoFebruary 4, 2024

Where do connect a turntable

Where do connect a turntable
zoom-in
View photo

The Pioneer VSX-521-K is an audio receiver that delivers a RMS rated power of 550 watts. With a Signal-to-Noise Ratio (SNR) of 79 dB, it offers clear and high-quality sound. The Total Harmonic Distortion (THD) is impressively low at 0.05%, ensuring accurate audio reproduction without any noticeable distortion. This receiver has an impedance of 8 Ω, which is a commonly used standard for audio equipment. It supports 5.1 channels, providing an immersive audio experience with multiple speakers for surround sound. In terms of connectivity, the Pioneer VSX-521-K offers various options. It has multichannel audio input and output terminals, allowing for convenient connection to compatible devices. Additionally, it features two digital audio optical inputs and one digital audio coaxial input, enabling the transmission of high-quality digital audio signals. For video connectivity, the receiver is equipped with two component video inputs, four HDMI inputs, and one composite video input. These inputs allow for the integration of video components into the audio setup. The Pioneer VSX-521-K includes one HDMI output, which can be connected to a compatible display device. This output allows for seamless video transmission. Overall, the Pioneer VSX-521-K is a versatile audio receiver with ample power and connectivity options. Its low distortion and high SNR ensure accurate and clear audio reproduction, while the multiple input and output options make it suitable for a variety of audio and video setups.

General
BrandPioneer
ModelVSX-521-K | VSX-521-K
Productreceiver
LanguageEnglish
FiletypeUser manual (PDF)
Audio
RMS rated power550 W
Signal-to-Noise Ratio (SNR)79 dB
Total Harmonic Distortion (THD)0.05 %
Impedance8 Ω
Audio output channels5.1 channels
Frequency range20 - 20000 Hz
Power output per channel (20-20KHz@8 Ohm)- W
Power output per channel (1KHz@6 Ohm)125 W
Receiver type-
Technical details
Audio decodersDolby Digital EX, Dolby Digital Plus, Dolby Pro Logic IIz, Dolby TrueHD, DTS-HD
Product colorBlack
Handheld remote controlYes
Display-
EqualizerYes
Apple docking compatibilityNot supported
AirPlayNo
Inputs
Multichannel audio input typeTerminals
Digital audio optical in2
Digital audio coaxial in1
Component video (YPbPr/YCbCr) in2
HDMI in4
Composite video in1
Outputs
Multichannel audio output typeTerminals
Number of HDMI outputs1
Composite video out1
Headphone outputs2
Headphone connectivity3.5 mm
Ports & interfaces
Connectivity technologyWired
Speakers connectivity type-
Radio
Supported radio bandsAM, FM
AM band range530 - 1700 kHz
FM band range87.5 - 108 MHz
Preset stations quantity30
Video
3DYes
Weight & dimensions
Weight9000 g
Width435 mm
Depth363 mm
Height168 mm
Network
Ethernet LANNo
Wi-FiNo
Power
AC input voltage120 V
AC input frequency60 Hz
Power consumption (typical)415 W
Power consumption (standby)0.4 W
Optical drive
Optical drive includedNo
Storage
Card reader integrated-
Packaging content
ManualYes
Warranty cardYes
User guideYes
show more

Can't find the answer to your question in the manual? You may find the answer to your question in the FAQs about the Pioneer VSX-521-K below.

When is my volume too loud?

A volume above 80 decibels can be harmful to hearing. When the volume exceeds 120 decibels, direct damage can even occur. The chance of hearing damage depends on the listening frequency and duration.

Can bluetooth devices of different brands be connected to each other?

Yes, bluetooth is a universal method that allows different devices equipped with bluetooth to connect to each other.

What is bluetooth?

Bluetooth is a way of exchanging data wirelessly between electronic devices via radio waves. The distance between the two devices that exchange data can in most cases be no more than ten metres.

What is HDMI?

HDMI stands for High-Definition Multimedia Interface. An HDMI cable is used to transport audio and video signals between devices.

How can I best clean my receiver?

A slightly damp cleaning cloth or soft, dust-free cloth works best to remove fingerprints. Dust in hard-to-reach places is best removed with compressed air.

Wat is Dolby Atmos?

Dolby Atmos is a technology that ensures that the sound is reflected from the ceiling to where you are listening. This makes it possible to create a 5.1 effect with only 1 speaker.

What is the weight of the Pioneer VSX-521-K?

The Pioneer VSX-521-K has a weight of 9000 g.

What is the height of the Pioneer VSX-521-K?

The Pioneer VSX-521-K has a height of 168 mm.

What is the width of the Pioneer VSX-521-K?

The Pioneer VSX-521-K has a width of 435 mm.

What is the depth of the Pioneer VSX-521-K?

The Pioneer VSX-521-K has a depth of 363 mm.

How do I connect my speakers to the Pioneer VSX-521-K receiver?

Make sure you connect the positive and negative terminals of each speaker to the corresponding terminals on the receiver. Remember to match the correct impedance and polarity for optimal sound performance.

How can I set up the auto-calibration feature on the receiver?

To use the auto-calibration feature, make sure you connect the included microphone to the receiver and place it at your listening position. Then, access the receiver's menu and follow the on-screen instructions to run the auto-calibration process, which will optimize the audio settings for your specific room.

How do I adjust the bass and treble settings on the Pioneer VSX-521-K?

To adjust the bass and treble settings, go to the receiver's menu and navigate to the audio settings. From there, you can easily modify the levels of bass and treble to suit your personal preferences.

How can I program the remote control to work with my TV?

To program the remote control to operate your TV, locate the remote's setup button and press it. Then, follow the on-screen instructions to enter the specific code for your TV brand. Once successfully programmed, the remote should control basic functions such as power, volume, and input selection for your TV.

How do I connect external devices, such as a Blu-ray player or game console, to the Pioneer receiver?

Connect the HDMI output of your external device to one of the HDMI inputs on the receiver. Then, using an HDMI cable, connect the HDMI output of the receiver to your TV or video display. Finally, select the appropriate HDMI input on the receiver to enjoy audio and video from your external device.

What is the RMS rated power of Pioneer VSX-521-K?

The RMS rated power of Pioneer VSX-521-K is 550 W. This means that it has a high power output, making it suitable for larger rooms or for those who want a louder audio experience.

What is the Signal-to-Noise Ratio (SNR) of Pioneer VSX-521-K?

The Signal-to-Noise Ratio (SNR) of Pioneer VSX-521-K is 79 dB. A higher SNR indicates that the receiver produces less background noise, resulting in clearer and more accurate audio playback.

What is the Total Harmonic Distortion (THD) of Pioneer VSX-521-K?

The Total Harmonic Distortion (THD) of Pioneer VSX-521-K is 0.05%. This means that the receiver maintains a low distortion level, ensuring that the audio is reproduced with high fidelity and minimal distortion.

What is the Impedance of Pioneer VSX-521-K?

The Impedance of Pioneer VSX-521-K is 8 Ω. This indicates the compatibility of the receiver with various speakers. Most speakers have an 8 Ω impedance rating, so this receiver should work well with a wide range of speakers.

How many audio output channels does Pioneer VSX-521-K have?

Pioneer VSX-521-K has 5.1 audio output channels. This means that it supports surround sound systems with five speakers and one subwoofer, resulting in a more immersive audio experience for the user.

Is the manual of the Pioneer VSX-521-K available in English?

Yes, the manual of the Pioneer VSX-521-K is available in English .

Is your question not listed? Ask your question here

No results