Pioneer VSX-1020 manual

Pioneer VSX-1020
7.7 · 6
PDF manual
 · 400 pages
English
manualPioneer VSX-1020
The exclamation point within an equilateral
triangle is intended to alert the user to the
presence of important operating and
maintenance (servicing) instructions in the
literature accompanying the appliance.
The lightning flash with arrowhead symbol,
within an equilateral triangle, is intended to
alert the user to the presence of uninsulated
“dangerous voltage” within the product’s
enclosure that may be of sufficient
magnitude to constitute a risk of electric
shock to persons.
CAUTION:
TO PREVENT THE RISK OF ELECTRIC
SHOCK, DO NOT REMOVE COVER (OR
BACK). NO USER-SERVICEABLE PARTS
INSIDE. REFER SERVICING TO QUALIFIED
SERVICE PERSONNEL.

CAUTION

RISK OF ELECTRIC SHOCK
DO NOT OPEN

IMPORTANT

D3-4-2-1-1_A1_En

WARNING

This equipment is not waterproof. To prevent a fire or
shock hazard, do not place any container filled with
liquid near this equipment (such as a vase or flower
pot) or expose it to dripping, splashing, rain or
moisture.
D3-4-2-1-3_A1_En

WARNING

Before plugging in for the first time, read the following
section carefully.
The voltage of the available power supply differs
according to country or region. Be sure that the
power supply voltage of the area where this unit
will be used meets the required voltage (e.g., 230 V
or 120 V) written on the rear panel.
D3-4-2-1-4*_A1_En

WARNING

To prevent a fire hazard, do not place any naked flame
sources (such as a lighted candle) on the equipment.
D3-4-2-1-7a_A1_En

VENTILATION CAUTION

When installing this unit, make sure to leave space
around the unit for ventilation to improve heat radiation
(at least 40 cm at top, 10 cm at rear, and 20 cm at each
side).

WARNING

Slots and openings in the cabinet are provided for
ventilation to ensure reliable operation of the product,
and to protect it from overheating. To prevent fire
hazard, the openings should never be blocked or
covered with items (such as newspapers, table-cloths,
curtains) or by operating the equipment on thick carpet
or a bed.
D3-4-2-1-7b*_A1_En
D3-4-2-1-2-2*_A1_En
Replacement and mounting of an AC plug on the power supply cord of this unit should be performed only by qualified
service personnel.
IMPORTANT: THE MOULDED PLUG
This appliance is supplied with a moulded three pin mains plug for your safety and convenience. A 10 amp fuse is fitted in this plug. Should
the fuse need to be replaced, please ensure that the replacement fuse has a rating of 10 amps and that it is approved by ASTA or BSI to
BS1362.
Check for the ASTA mark or the BSI mark on the body of the fuse.
If the plug contains a removable fuse cover, you must ensure that it is refitted when the fuse is replaced. If you lose the fuse cover the plug
must not be used until a replacement cover is obtained. A replacement fuse cover can be obtained from your local dealer.
If the fitted moulded plug is unsuitable for your socket outlet, then the fuse shall be removed and the plug cut off and disposed of
safely. There is a danger of severe electrical shock if the cut off plug is inserted into any 13 amp socket.
If a new plug is to be fitted, please observe the wiring code as shown below. If in any doubt, please consult a qualified electrician.
IMPORTANT: The wires in this mains lead are coloured in accordance with the following code:
Blue : Neutral Brown : Live
As the colours of the wires in the mains lead of this appliance may not correspond with the coloured markings identifying the terminals in
your plug, proceed as follows;
The wire which is coloured BLUE must be connected to the terminal which is marked with the
letter N or coloured BLACK.
The wire which is coloured BROWN must be connected to the terminal which is marked with the
letter L or coloured RED.
How to replace the fuse: Open the fuse compartment with a screwdriver and replace the fuse.
VSX-1020_SYXCN.book 2 ページ 2010年3月12日 金曜日 午前9時10分

View the manual for the Pioneer VSX-1020 here, for free. This manual comes under the category receivers and has been rated by 6 people with an average of a 7.7. This manual is available in the following languages: English. Do you have a question about the Pioneer VSX-1020 or do you need help? Ask your question here

Need help?

Do you have a question about the Pioneer and is the answer not in the manual?

  • Receive updates on solutions
  • Get answers to your question

Question and answer

Number of questions: 6
K
Karel wijnenDecember 1, 2023

I can't figure out how to connect the TV to the amplifier to have the TV sound come out of my speakers.

I can't figure out how to connect the TV to the amplifier to have the TV sound come out of my speakers.
zoom-in
View photo
This message has been automatically translated
K
keith trishwoodMay 22, 2022

i have a vsx 1020 I'm having trouble trying to figure out how to hook up the internet and showing the screen on the tv

D
Derek MartinSeptember 16, 2022

How due I adjust what speakers and how to adjust bass and treble

B
BobMarch 24, 2016

Where can I find the schematic for VSX 1020 ?

B
BobMarch 24, 2016

MY remote dosnt work Why?

S
Sathish April 10, 2024

All speaker oms and watts?

The Pioneer VSX-1020 is a receiver designed for wired connectivity technology, offering a range of audio input options. It has a signal-to-noise ratio (SNR) of 100 dB, ensuring clear and high-quality audio playback. With a total harmonic distortion (THD) of 1%, it maintains accurate sound reproduction. The receiver features 7.1 audio output channels, providing an immersive audio experience. It has an impedance of 6 Ω, which is suitable for a variety of speaker setups. The output power of 140 W ensures ample volume and dynamic range. In terms of connectivity, the Pioneer VSX-1020 offers a multitude of options. It includes two digital audio optical inputs and two digital audio coaxial inputs, allowing for convenient connection to various audio sources. Furthermore, it has seven HDMI ports, enabling seamless integration with HDMI-compatible devices such as TVs and gaming consoles. For ease of use, a remote control is included with the receiver, providing convenient access to its functions. The receiver boasts a sleek and modern design, complementing any home entertainment setup. Please note that the information provided is solely focused on the specifications and objective features of the Pioneer VSX-1020 receiver.

General
BrandPioneer
ModelVSX-1020 | VSX-1020-K
Productreceiver
EAN0884938109222, 4988028109218
LanguageEnglish
FiletypeUser manual (PDF)
Audio
Signal-to-Noise Ratio (SNR)100 dB
Total Harmonic Distortion (THD)1 %
Audio D/A Converter (DAC)24-bit/192kHz
Impedance6 Ω
Audio A/D Converter (ADC)24-bit/96kHz
Audio output channels7.1 channels
Frequency range5 - 100000 Hz
Other features
Audio systemDolby TrueHD, DTS-HD Master Audio
Output power140 W
Channels quantity63 channels
HDMI ports quantity7
Dimensions (WxDxH)420 x 379 x 158 mm
Power requirementsAC 220 - 230 V, 50/60 Hz
Ports & interfaces
Connectivity technologyWired
Inputs
Digital audio optical in2
Digital audio coaxial in2
Technical details
Handheld remote controlYes
Product colorBlack
Weight & dimensions
Weight10200 g
Power
Power consumption (typical)245 W
Power consumption (standby)0.6 W
Packaging content
ManualYes
Outputs
Headphone connectivity3.5 mm
show more

Can't find the answer to your question in the manual? You may find the answer to your question in the FAQs about the Pioneer VSX-1020 below.

When is my volume too loud?

A volume above 80 decibels can be harmful to hearing. When the volume exceeds 120 decibels, direct damage can even occur. The chance of hearing damage depends on the listening frequency and duration.

Can bluetooth devices of different brands be connected to each other?

Yes, bluetooth is a universal method that allows different devices equipped with bluetooth to connect to each other.

What is bluetooth?

Bluetooth is a way of exchanging data wirelessly between electronic devices via radio waves. The distance between the two devices that exchange data can in most cases be no more than ten metres.

What is HDMI?

HDMI stands for High-Definition Multimedia Interface. An HDMI cable is used to transport audio and video signals between devices.

How can I best clean my receiver?

A slightly damp cleaning cloth or soft, dust-free cloth works best to remove fingerprints. Dust in hard-to-reach places is best removed with compressed air.

Wat is Dolby Atmos?

Dolby Atmos is a technology that ensures that the sound is reflected from the ceiling to where you are listening. This makes it possible to create a 5.1 effect with only 1 speaker.

What is the weight of the Pioneer VSX-1020?

The Pioneer VSX-1020 has a weight of 10200 g.

Why is there no sound coming from my Pioneer VSX-1020 receiver?

Make sure the input source is correctly selected on the receiver, check that the volume level is not set to minimum or muted, verify that the speakers are properly connected, and ensure that the audio cables are securely plugged in. Additionally, check if the audio settings on the source device are correctly configured.

How can I enhance the bass output on my Pioneer VSX-1020?

Access the receiver's equalizer settings and increase the low-frequency (bass) levels. You can adjust the bass output to your preference by adjusting the values until it achieves the desired effect. Experiment with the settings and listen to various audio sources to find the optimal bass balance.

What can I do if my Pioneer VSX-1020 receiver keeps turning off unexpectedly?

Firstly, check if the receiver is overheating by ensuring it has sufficient ventilation and is not blocked by any objects. Disconnect all the speakers and peripherals, and then try turning on the receiver. If it powers on normally, one of the speakers or devices may be causing a short circuit, so you should reconnect them one by one to identify the problematic component.

How do I set up the multi-zone feature on my Pioneer VSX-1020 receiver?

Activate the receiver's multi-zone output function through the menu settings. Select the audio sources you want to play in a different zone, and connect the speakers or audio devices to the corresponding zone outputs on the receiver. Adjust the volume levels for each zone independently to achieve the desired listening experience in different areas of your home.

What should I do if I am experiencing distorted audio on my Pioneer VSX-1020?

Start by checking if the speaker wiring is correctly connected, ensuring no loose connections or frayed wires. Verify that the speakers' impedance matches the receiver's specifications. If the issue persists, check the audio settings on both the receiver and the source device, ensuring they are configured appropriately. Experiment with different audio modes on the receiver to see if any specific mode reduces the distortion.

Does the Pioneer VSX-1020 have a high Signal-to-Noise Ratio (SNR) of 100 dB?

Yes, the Pioneer VSX-1020 has a high Signal-to-Noise Ratio (SNR) of 100 dB. This means that the receiver is capable of producing clear and high-quality audio with minimal background noise.

Is the Total Harmonic Distortion (THD) of the Pioneer VSX-1020 acceptable at 1%?

Yes, the Total Harmonic Distortion (THD) of 1% is acceptable for the Pioneer VSX-1020. While lower THD values are generally preferred, a THD of 1% is still within acceptable limits and should not significantly impact the audio quality.

Can the Pioneer VSX-1020 support 6 Ω impedance speakers?

Yes, the Pioneer VSX-1020 can support 6 Ω impedance speakers. This makes it compatible with a wide range of speakers, allowing users to connect and enjoy their preferred speakers without any issues.

How many audio output channels does the Pioneer VSX-1020 have?

The Pioneer VSX-1020 has 7.1 audio output channels. This means that users can enjoy immersive surround sound audio with separate channels for front, center, surround, and subwoofer speakers.

Does the Pioneer VSX-1020 have a good number of HDMI ports for connectivity?

Yes, the Pioneer VSX-1020 has 7 HDMI ports, which is a good number for connectivity. This allows users to connect multiple HDMI-enabled devices such as game consoles, Blu-ray players, and media streaming devices, providing a convenient and versatile setup.

Is the manual of the Pioneer VSX-1020 available in English?

Yes, the manual of the Pioneer VSX-1020 is available in English .

Is your question not listed? Ask your question here

No results