Pioneer TS-WX010A manual

Pioneer TS-WX010A
7.5 · 1
PDF manual
 · 9 pages
English
manualPioneer TS-WX010A
Important Warnings About TS-WX010A Installation
To avoid possible electrical shock, disconnect the vehicle's negative (-) battery power cable before
starting installation.
Although the TS-WX010A is designed for optimum performance when installed in the front passenger
seat foot space, it can be installed effectively in other locations as well. If installing in the passenger
compartment, make sure it is securely anchored in place where it will not cause a hazard in case of a
sudden stop.
The most important factor in installation location is where the TS-WX010A can be installed
securely without interfering with the safe operation of the vehicle or impairing the
performance of operating systems or safety features, including air bags, controls and
indicators (lights), which will depend on the vehicle model. DO NOT INSTALL ANYWHERE IN
THE DRIVER'S AREA. Interfering with the safe operation of a vehicle is extremely dangerous
and could result in serious injury, including death. For a secure fit, select a flat installation
location with no surface irregularities.
Do not install on the floor mat alone as it is easy to move/remove. The TS-WX010A must
remain secure in case of sudden stops, and it will not stay in place if installed only on the
floor mat, which may result in serious injury.
Ensure that the entire TS-WX010A unit will be out of direct sunlight in all situations and will
not get wet. Direct sunlight can make surfaces inside the vehicle, including this unit, very hot, which
could result in a risk of burns if the unit comes into direct contact with skin. This product is not water
resistant and must be kept dry.
Before drilling any mounting holes, check behind where you want to drill the holes to make sure you
DO NOT drill into anything such as the gas lines, brake lines, electrical wiring or vehicle battery and
battery charging system (for hybrid and electric vehicles).
When wiring this unit, use the supplied connecting cords and DO NOT remove or bypass the fuses.
Modification or removal of these parts will disable the protection circuit, which is needed in case of an
electrical short or over-current situation.
When routing leads and cords, secure them with cable retainers and electricians adhesive tape or
shrink tubing wherever they may touch sharp edges. Do not install the unit or its wiring near hot
surfaces or heater outlets, which could lead to short circuits or damage, or in a place where a
passenger might trip on it getting in or out of the vehicle.
When using the included installation brackets, make sure the carpet, or both the carpet and floor mat,
is between the TS-WX010A and the brackets as indicated in the HOW TO INSTALL section of the
instruction manual.
After-sales Service in the U.S. and Canada
Please contact the authorized Pioneer dealer from which you purchased this unit or an authorized
Pioneer service company for aftersales service or questions you may have about the product. You may
contact Pioneer directly as follows:
Do not ship your unit in for repair without contacting Pioneer first. Units sent without a return
authorization number will be refused.
Pioneer Electronics (USA) Inc.
CUSTOMER SUPPORT DIVISION
P.O. Box 1760
Long Beach, CA 90801-1760 U.S.A.
800-421-1404

Visit our website

U.S.: https://www.pioneerelectronics.com
Canada: https://www.pioneerelectronics.ca

View the manual for the Pioneer TS-WX010A here, for free. This manual comes under the category subwoofers and has been rated by 1 people with an average of a 7.5. This manual is available in the following languages: English. Do you have a question about the Pioneer TS-WX010A or do you need help? Ask your question here

Need help?

Do you have a question about the Pioneer and is the answer not in the manual?

  • Receive updates on solutions
  • Get answers to your question

Question and answer

Number of questions: 0

The Pioneer TS-WX010A is an active subwoofer that delivers powerful bass to enhance your audio experience. With a RMS power of 50 W and a peak power of 160 W, this subwoofer is capable of producing deep and resonant low frequencies. Measuring 116 mm in width, 230 mm in depth, and 70 mm in height, the TS-WX010A has a compact design that allows for easy installation in various locations. The subwoofer's diameter is 1710 mm, providing ample surface area for the generation of sound waves. Equipped with a 4 Ω impedance, this subwoofer is designed to efficiently utilize the power from the amplifier. The sensitivity rating of 98 dB ensures that even subtle details in the bass frequencies are reproduced accurately. Featuring a Class D amplifier, the TS-WX010A optimizes power efficiency and minimizes distortion, resulting in clean and distortion-free audio performance. The Pioneer TS-WX010A is constructed with high-quality materials that ensure reliability and durability over time, allowing it to withstand the demands of continuous use. The subwoofer's design is sleek and modern, seamlessly blending in with any car audio setup. Overall, the Pioneer TS-WX010A is an active subwoofer that combines power, efficiency, and durability to deliver impressive and immersive bass reproduction. It is a fitting addition to any car audio system, enhancing the overall audio quality and providing a more immersive listening experience.

General
BrandPioneer
ModelTS-WX010A | TS-WX010A
Productsubwoofer
EAN0884938478373
LanguageEnglish
FiletypeUser manual (PDF), Installation Guide (PDF)
Subwoofer
Product typePre-loaded subwoofer
Subwoofer typeActive subwoofer
Subwoofer RMS power50 W
Subwoofer frequency range20 - 200 Hz
Subwoofer peak power160 W
Subwoofer sensitivity98 dB
Subwoofer impedance4 Ω
Subwoofer crossover frequencies50 - 125 Hz
Technical details
Amplifier classD
Weight & dimensions
Width116 mm
Depth230 mm
Height70 mm
Diameter1710 mm
show more

Can't find the answer to your question in the manual? You may find the answer to your question in the FAQs about the Pioneer TS-WX010A below.

When is my volume too loud?

A volume above 80 decibels can be harmful to hearing. When the volume exceeds 120 decibels, direct damage can even occur. The chance of hearing damage depends on the listening frequency and duration.

What is the height of the Pioneer TS-WX010A?

The Pioneer TS-WX010A has a height of 70 mm.

What is the width of the Pioneer TS-WX010A?

The Pioneer TS-WX010A has a width of 116 mm.

What is the depth of the Pioneer TS-WX010A?

The Pioneer TS-WX010A has a depth of 230 mm.

How do I connect the subwoofer to my audio system?

Ensure that you have the appropriate RCA cables and connect them from the subwoofer's input to the corresponding output on your audio system. Make sure to match the left and right channels correctly.

Why is my subwoofer not producing any sound?

Check the power connection and ensure that the subwoofer is receiving electricity. Additionally, verify that the audio source is correctly connected, the volume is turned up, and the input settings on your audio system are properly configured.

Is it possible to adjust the bass level of the subwoofer to suit my preferences?

Yes, you can fine-tune the bass output according to your liking. On the subwoofer, locate the bass level adjustment knob usually labeled as "Gain" or "Level," and adjust it clockwise to increase the bass or counterclockwise to decrease it.

How do I install the subwoofer in my vehicle?

Find a suitable location in your vehicle that ensures proper air circulation and secure the subwoofer using the provided brackets or screws. Ensure that it is mounted securely to prevent any rattling or movement while driving.

What is the optimal power output for the subwoofer?

The Pioneer TS-WX010A subwoofer has a maximum power handling of XX Watts RMS (Root Mean Square) and XX Watts Peak. It is recommended to match the subwoofer's power handling capabilities with an amplifier that provides a clean and appropriate power output for optimal performance.

Is the Pioneer TS-WX010A an active subwoofer?

Yes, the Pioneer TS-WX010A is an active subwoofer. This means that it has a built-in amplifier, making it easier to connect to an audio system without the need for an external amplifier.

What is the RMS power of the Pioneer TS-WX010A subwoofer?

The Pioneer TS-WX010A has an RMS power of 50 Watts. This indicates the average amount of power the subwoofer can handle continuously, providing a decent level of bass performance for the user.

What is the peak power of the Pioneer TS-WX010A subwoofer?

The Pioneer TS-WX010A has a peak power of 160 Watts. This represents the maximum power output the subwoofer can handle in short bursts. It indicates the potential for impactful bass, ensuring an immersive audio experience for the user.

What is the sensitivity of the Pioneer TS-WX010A subwoofer?

The Pioneer TS-WX010A has a sensitivity of 98 dB. This high sensitivity rating means that the subwoofer can produce powerful bass with less input power, resulting in efficient and impactful sound reproduction.

What is the impedance of the Pioneer TS-WX010A subwoofer?

The Pioneer TS-WX010A has an impedance of 4 Ω. This low impedance level allows the subwoofer to draw more power from the amplifier, enhancing its ability to deliver deep and rich bass response. It is important to ensure compatibility with the audio system's amplifier.

Is the manual of the Pioneer TS-WX010A available in English?

Yes, the manual of the Pioneer TS-WX010A is available in English .

Is your question not listed? Ask your question here

No results