Pioneer SP-FS51-LR manual

Pioneer SP-FS51-LR
7.5 · 1
PDF manual
 · 16 pages
English
manualPioneer SP-FS51-LR

Speaker System Système d’enceintes Sistema de Bocinas

Operating Guide Guide d’utilisation Guía de Operaciones

SP-FS51-LR, SP-BS21-LR & SP-C21

IMPORTANT NOTICE: The serial number for the equipment is located on the rear of the product.
Please write this serial number on the warranty sheet and keep it in a secure area for future reference.

BEFORE USE

Thank you for buying this Pioneer product.
Please read through this operating guide before using your
speaker system to optimize performance. After you have
finished reading this operating guide, store it in a safe place
for future reference.
The nominal impedance of this speaker system is 8 ohms.
Connect the speaker system to a stereo amplifier with a load
impedance rating ranging from 4 to 16 ohms (a model with
“4-16Ω” displayed on the speaker output terminals).
In order to prevent damage to the speaker system resulting
from input overload, please observe the following precautions:
Do not supply power to the speaker system in excess of
the maximum permissible input.
When connecting or disconnecting cables, be sure
amplifier power is OFF.
Do not use excessive amplifier volume if using a graphic
equalizer to emphasize high or low frequencies.
REMARQUE IMPORTANTE: Le numéro de série pour l’équipement se trouve sur l’arrière du produit. Veuillez écrire le numéro
de série sur la carte de garantie et le conserver dans un lieu sûr pour éventuellement le consulter plus tard.

AVANT TOUTE UTILISATION

Merci d’avoir acheté ce produit Pioneer.
Veuillez lire le présent guide d’utilisation dans son intégralité
avant d’utiliser le système d’enceintes pour en optimiser
sa performance. Après avoir fini la lecture de ce guide
d’utilisation, conservez-le dans un lieu sûr pour éventuelle-
ment le consulter plus tard.
L’impédance nominale de ce système d’enceintes est de 8
ohms. Raccordez les enceintes acoustiques à un amplifica-
teur stéréophonique dont la valeur nominale d’impédance de
charge va de 4 à 16 ohms (un modèle pour lequel « 4-16Ω »
est indiqué sur les bornes de sortie aux haut-parleurs).
Pour éviter d’endommager les enceintes acoustiques par une
surcharge à l’entrée, observez les précautions suivantes :
Ne fournissez pas aux enceintes acoustiques une puis-
sance électrique dépassant l’entrée maximale autorisée.
Lors de la connexion ou de la déconnexion des câbles,
veillez à mettre l’amplificateur hors tension.
N’utilisez pas de volume d’amplificateur excessif lors de
l’utilisation d’un égaliseur graphique pour accentuer les
hautes ou basses fréquences.
AVISO IMPORTANTE: El número de serie del equipo está ubicado en la parte posterior del producto. Por favor anote el
número de serie en la hoja de garantía y guárdelo en un lugar seguro para usarlo como futura referencia.

ANTES DE USARLO

Gracias por comprar este producto Pioneer.
Por favor lea esta guía de operaciones antes de usar su
sistema de bocinas, a fin de optimizar el funcionamiento.
Una vez que haya terminado de leer esta guía de opera-
ciones, guárdela en un lugar seguro para usarla como
referencia en el futuro.
La impedancia nominal de este sistema de bocinas es 8 ohmios.
Conecte el sistema de bocinas a un amplificador estéreo con
una impedancia de carga de 4 a 16 ohmios (un modelo que
indique “4-16Ωen los terminales de salida a bocinas).
Para evitar dañar el sistema de bocinas por una sobrecarga
a la entrada, tome las siguientes precauciones:
No suministre más potencia de entrada al sistema de
bocinas que la máxima permitida.
Cuando conecte o desconecte cables, verifique que la
corriente al amplificador esté APAGADA.
No use un volumen excesivo del amplificador si usa
un ecualizador gráfico para enfatizar las altas o bajas
frecuencias.

SP-C21

SP-BS21
(180.68 mm x 320 mm)

SP-FS51-LRSP-BS21-LR

View the manual for the Pioneer SP-FS51-LR here, for free. This manual comes under the category speakers and has been rated by 1 people with an average of a 7.5. This manual is available in the following languages: English. Do you have a question about the Pioneer SP-FS51-LR or do you need help? Ask your question here

Need help?

Do you have a question about the Pioneer and is the answer not in the manual?

  • Receive updates on solutions
  • Get answers to your question

Question and answer

Number of questions: 0

General
BrandPioneer
ModelSP-FS51-LR
Productspeaker
EAN0012562904719, 0012562904740
LanguageEnglish
FiletypeUser manual (PDF)

Can't find the answer to your question in the manual? You may find the answer to your question in the FAQs about the Pioneer SP-FS51-LR below.

When is my volume too loud?

A volume above 80 decibels can be harmful to hearing. When the volume exceeds 120 decibels, direct damage can even occur. The chance of hearing damage depends on the listening frequency and duration.

Can bluetooth devices of different brands be connected to each other?

Yes, bluetooth is a universal method that allows different devices equipped with bluetooth to connect to each other.

Wat is Dolby Atmos?

Dolby Atmos is a technology that ensures that the sound is reflected from the ceiling to where you are listening. This makes it possible to create a 5.1 effect with only 1 speaker.

What is bluetooth?

Bluetooth is a way of exchanging data wirelessly between electronic devices via radio waves. The distance between the two devices that exchange data can in most cases be no more than ten metres.

Is the manual of the Pioneer SP-FS51-LR available in English?

Yes, the manual of the Pioneer SP-FS51-LR is available in English .

Is your question not listed? Ask your question here

No results