Pioneer S-RS33TB manual

Pioneer S-RS33TB
9.5 · 1
PDF manual
 · 12 pages
English
manualPioneer S-RS33TB
1
En

S-RS33TB

S-RS77TB

Operating Instructions

Speaker System

WHAT’S IN THE BOX

BEFORE USE

Thank you for buying this Pioneer product.
Please read through these operating instructions before
using your speaker system to optimize performance.
The nominal impedance of this speaker system is
8 Ω. Connect the speaker system to an amplifier with
a load impedance ranging from 6 Ω to 16 Ω (a model
with “6 Ω to 16 Ω” displayed on the speaker output
terminals).
In order to prevent damage to the speaker system
resulting from input overload, please observe the
following precautions:
-Be sure to turn the connected devices off and
remove the power cord from the wall outlet
beforehand when changing the connection or
installation method.
-Do not use excessive amplifier volume if using a
tone control to emphasize high or low frequencies.
Do not use the speaker to output distorted sound for
long periods of time. This can result in a fire hazard.

INSTALLATION PRECAUTIONS

Do not install these units near a stove or other
heating appliance, or put them in a place exposed to
the sun. Such locations may cause the cabinet to
change color and the speaker system to break down.
FRONT / CENTER SPEAKERS
Do not attach the front and center speakers to the
wall or ceiling. It may fall off and cause injury.
This speaker system is magnetically shielded.
However, depending on the installation location,
color distortion may occur if the speaker system is
installed extremely close to the screen of a television
set.
If this happens, turn off the television, then turn it on
again after 15 min to 30 min. If the problem persists,
place the speaker system away from the television
set.
Do not attach these speakers to the wall or ceiling, as
they may cause injury in the event of a fall.
SURROUND SPEAKERS
The surround speakers are not magnetically shielded
and so should not be placed near a TV or monitor, as
the interaction of magnetic materials can cause
distortion of the colors on your TV screen. Magnetic
storage media (such as floppy discs and tape or video
cassettes) should also not be kept close to these
speakers.

PLACEMENT AND FINE TUNING

FRONT SPEAKERS
For best results the speakers should be separated a
distance approximately equal to the listening distance.
Angling the speakers inward towards the listener will
improve the image stability for non-central listeners.
Close proximity to a side or rear wall will enhance the
midbass performance, although too close (particularly a
corner location) and the bass may be unnaturally high
and image performance may be degraded.
Front speakers x 2
Surround speakers x 2
Speaker cords x 5
Center speaker x 1
Non-skid pads x 12
(4 pcs x 3 sheets)
Operating instructions
Center
(2 m, Tie color : Black)
Front right / left
(3 m, Tie color : Blue)
Surround right / left
(6 m, Tie color : White)
S-RS77TBS-RS33TB
S-RS33TB_77TB_En.fm 1 ページ 2010年4月13日 火曜日 午前11時25分

View the manual for the Pioneer S-RS33TB here, for free. This manual comes under the category speakers and has been rated by 1 people with an average of a 9.5. This manual is available in the following languages: English. Do you have a question about the Pioneer S-RS33TB or do you need help? Ask your question here

Need help?

Do you have a question about the Pioneer and is the answer not in the manual?

  • Receive updates on solutions
  • Get answers to your question

Question and answer

Number of questions: 0

General
BrandPioneer
ModelS-RS33TB
Productspeaker
LanguageEnglish
FiletypeUser manual (PDF)

Can't find the answer to your question in the manual? You may find the answer to your question in the FAQs about the Pioneer S-RS33TB below.

When is my volume too loud?

A volume above 80 decibels can be harmful to hearing. When the volume exceeds 120 decibels, direct damage can even occur. The chance of hearing damage depends on the listening frequency and duration.

Can bluetooth devices of different brands be connected to each other?

Yes, bluetooth is a universal method that allows different devices equipped with bluetooth to connect to each other.

Wat is Dolby Atmos?

Dolby Atmos is a technology that ensures that the sound is reflected from the ceiling to where you are listening. This makes it possible to create a 5.1 effect with only 1 speaker.

What is bluetooth?

Bluetooth is a way of exchanging data wirelessly between electronic devices via radio waves. The distance between the two devices that exchange data can in most cases be no more than ten metres.

How do I properly install the Pioneer S-RS33TB speaker to ensure optimal performance?

To properly install the Pioneer S-RS33TB speaker and ensure optimal performance, follow these steps: 1. Choose the installation location: Select a suitable location for the speakers, away from heating appliances and direct sunlight. Placing them near a side or rear wall can enhance midbass performance, but avoid corner locations as it may result in unnaturally high bass and degraded image performance. 2. Position the front speakers: Separate the front speakers at a distance approximately equal to the listening distance. Angling the speakers inward towards the listener will improve image stability for non-central listeners. 3. Connect the speakers: Use the supplied speaker cords to connect the front speakers to the appropriate speaker output terminals on your amplifier or receiver. Ensure that the load impedance of the amplifier is within the range of 6 Ω to 16 Ω. 4. Place the center speaker: Position the center speaker on a stable surface near your TV or screen. Do not attach it to the wall or ceiling to prevent injury in case of a fall. 5. Set up the surround speakers: Place the surround speakers on bookshelves or stands, ensuring they are not too close to a TV or monitor to avoid color distortion. Keep magnetic storage media away from the speakers. By following these steps, you can properly install the Pioneer S-RS33TB speaker and enjoy optimal performance.

Why is there no sound coming from the front/center speakers of my Pioneer S-RS33TB speaker?

If there is no sound coming from the front/center speakers of your Pioneer S-RS33TB speaker, you can troubleshoot the issue by following these steps: 1. Check the speaker connections: Ensure that the speaker cords are securely connected to the appropriate speaker output terminals on your amplifier or receiver. Make sure the striped half of the speaker cord is connected to the red (+) terminal and the other half to the black (–) terminal. 2. Verify the amplifier settings: Refer to the operating instructions of your amplifier to confirm that the speaker setting for the front/center speakers is correctly configured. The front speakers should be set to "LARGE," while the center speaker should be set to "SMALL." 3. Check the volume control: Make sure the volume control on your amplifier or receiver is not set to zero. Gradually increase the volume to a suitable level. 4. Troubleshoot the speaker cords: If the sound issue persists, check the speaker cords for any damage or loose connections. Replace the cords if necessary. 5. Address extreme signal conditions: If the sound is distorted, lower the output level of your amplifier by adjusting the volume, bass control, or bass boost settings. By following these steps, you can troubleshoot and resolve the issue of no sound coming from the front/center speakers of your Pioneer S-RS33TB speaker.

How should I position the surround speakers of my Pioneer S-RS33TB speaker for the best audio experience?

To position the surround speakers of your Pioneer S-RS33TB speaker for the best audio experience, follow these steps: 1. Determine the speaker placement: Decide whether you want to position the surround speakers on the side walls just behind the listening position or on the rear walls. Consider your room layout and personal preferences. 2. Position at or above ear level: Place the surround speakers at or slightly above ear level when seated in the listening position. This helps to create an immersive sound experience. 3. Maintain proper distance: Ensure that the surround speakers are positioned at an appropriate distance from the listening area. Avoid placing them too close to the listener, as it may result in an unbalanced soundstage. 4. Avoid obstructions: Make sure there are no obstructions blocking the sound path between the surround speakers and the listening area. Objects or furniture in front of the speakers can interfere with the sound dispersion. 5. Experiment and fine-tune: Once the speakers are positioned, listen to various audio content and make adjustments if necessary. You may need to slightly reposition the speakers or adjust the speaker angle to achieve the desired surround sound effect. By following these steps, you can position the surround speakers of your Pioneer S-RS33TB speaker for the best audio experience.

Why is the sound quality or image stability of my Pioneer S-RS33TB speaker affected even after positioning the front speakers correctly?

The sound quality or image stability of your Pioneer S-RS33TB speaker may be affected even after positioning the front speakers correctly due to the following reasons: 1. Magnetic interference: If the front speakers are placed extremely close to a television or monitor, magnetic interference can occur, resulting in color distortion on the screen. To resolve this, turn off the television and turn it on again after 15 to 30 minutes. If the problem persists, move the speaker system away from the television. 2. Improper placement: If the front speakers are positioned too close to a side or rear wall, the bass performance may become unnaturally high, and the image stability may be degraded. To optimize performance, ensure that the speakers are separated at a distance approximately equal to the listening distance and angle them inward towards the listener. 3. Speaker attachment: It is important not to attach the front speakers to the wall or ceiling, as this can lead to potential injury in the event of a fall. Always place the speakers on stable surfaces. By addressing these factors, you can improve the sound quality and image stability of your Pioneer S-RS33TB speaker.

Is the manual of the Pioneer S-RS33TB available in English?

Yes, the manual of the Pioneer S-RS33TB is available in English .

Is your question not listed? Ask your question here

No results