Pioneer MVH-X380BT manual

Pioneer MVH-X380BT
8.2 · 16
PDF manual
 · 204 pages
English
manualPioneer MVH-X380BT

20En

Important
When installing this unit in a vehicle
without an ACC (accessory) position
on the ignition switch, failure to
connect the red cable to the terminal
that detects operation of the ignition
key may result in battery drain.
Use of this unit in conditions other
than the following could result in fire
or malfunction.
Vehicles with a 12-volt battery and
negative grounding.
Speakers with 50 W (output value)
and 4 Ω to 8 Ω (impedance value).
To prevent a short-circuit,
overheating or malfunction, be sure
to follow the directions below.
Disconnect the negative terminal
of the battery before installation.
Secure the wiring with cable
clamps or adhesive tape. Wrap
adhesive tape around wiring that
comes into contact with metal
parts to protect the wiring.
Place all cables away from moving
parts, such as the shift lever and
seat rails.
Place all cables away from hot
places, such as near the heater
outlet.
Do not connect the yellow cable to
the battery by passing it through
the hole to the engine
compartment.
Cover any disconnected cable
connectors with insulating tape.
Do not shorten any cables.
Never cut the insulation of the
power cable of this unit in order to
share the power with other devices.
The current capacity of the cable is
limited.
Use a fuse of the rating prescribed.
Never wire the negative speaker
cable directly to ground.
Never band together negative
cables of multiple speakers.
When this unit is on, control signals
are sent through the blue/white
cable. Connect this cable to the
system remote control of an external
power amp or the vehicles auto-
antenna relay control terminal (max.
300mA 12 V DC). If the vehicle is
equipped with a glass antenna,
connect it to the antenna booster
power supply terminal.
Never connect the blue/white cable
to the power terminal of an external
power amp. Also, never connect it to
the power terminal of the auto
antenna. Doing so may result in
battery drain or a malfunction.

Connections/Installation

Connections

ACC position No ACC position
The black cable is ground. Ground
cables for this unit and other
equipment (especially, high-current
products such as power amps) must
be wired separately. If they are not,
an accidental detachment may result
in a fire or malfunction.
This unit
Microphone 4 m (Only for MVH-
X380BT)
Rear output or subwoofer output
Front output (Only for MVH-
X380BT/180UI)
Antenna input
Power cord input
Fuse (10 A)
Wired remote input (Only for MVH-
X380BT/180UI)
Hard-wired remote control adapter
can be connected (sold separately).
Microphone input (Only for MVH-
X380BT)
Power cord
To power cord input
Depending on the kind of vehicle,
the function of and may be
different. In this case, be sure to
connect to and to .
Yel low
Back-up (or accessory)
Yel low
Connect to the constant 12 V
supply terminal.
Red
Accessory (or back-up)
Red
Connect to terminal controlled by
the ignition switch (12 V DC).
Connect leads of the same color to
each other.
Black (chassis ground)
MVH-X380BT/180UI/180UBG/180UB/
181UB

View the manual for the Pioneer MVH-X380BT here, for free. This manual comes under the category car radios and has been rated by 16 people with an average of a 8.2. This manual is available in the following languages: English. Do you have a question about the Pioneer MVH-X380BT or do you need help? Ask your question here

Need help?

Do you have a question about the Pioneer and is the answer not in the manual?

  • Receive updates on solutions
  • Get answers to your question

Question and answer

Number of questions: 3
K
Kapronczai Andreea - Alexandra July 6, 2023

I also have this Pioneer car radio model and I don't know how my friend messed with it and accidentally set it to Russian language... I don't know how to put it back to the original settings... Can someone help me? I've attached a picture when adjusting the volume.

I also have this Pioneer car radio model and I don't know how my friend messed with it and accidentally set it to Russian lan...
zoom-in
View photo
This message has been automatically translated
I
ILARIOSeptember 23, 2016

How do I restore the factory settings? Where is the reset button? The Russian language appeared on my car radio Pioneer MVH-X380BT by mistake.

This message has been automatically translated
C
Christina Eileen BillingsMay 17, 2022

Hi. What’s error code #10?

The Pioneer MVH-X380BT is a car radio that offers MP3 playback, allowing users to enjoy their favorite music on the go. It does not support CD-R or CD-RW playback, making it a more contemporary option. With a total of 24 preset station options, users have a variety of radio stations to choose from. One notable feature of the Pioneer MVH-X380BT is its built-in equalizer with five bands, allowing users to customize and adjust the audio output to their preferences. It also supports Radio Data System (RDS), which provides additional information such as traffic updates and song titles on compatible radio stations. The car radio operates on MOSFET technology, which ensures efficient power delivery and a clear audio signal. The built-in display, with a single line for information, provides basic visibility and functionality. The display type is LCD, which offers clear and easily readable information. The Pioneer MVH-X380BT also offers an AUX input, providing users with the flexibility to connect external devices such as smartphones or MP3 players. In summary, the Pioneer MVH-X380BT is a modern car radio that supports MP3 playback and offers 24 preset stations. It features a built-in equalizer with five bands for customizable audio output and supports RDS for additional radio information. The radio operates on MOSFET technology and has a one-line LCD display. Additionally, the AUX input allows for easy connectivity to external devices.

General
BrandPioneer
ModelMVH-X380BT | MVH-X380BT
Productcar radio
EAN4988028309823, 0884938309837
LanguageEnglish
FiletypeUser manual (PDF)
Multimedia
MP3 playbackYes
CD-R playbackNo
CD-RW playbackNo
Audio systemMOSFET
USB direct playbackYes
Audio formats supportedMP3, WAV, WMA
Radio
Preset stations quantity24
Radio Data System (RDS)Yes
Supported radio bandsAM, FM
FM band range87.9 - 107.9 MHz
AM band range530 - 1710 kHz
FM radioYes
Performance
EqualizerYes
Equalizer bands quantity5
Product colorBlack
Output power- W
Ready for iPodYes
DIN size1 DIN
Disc types supportedNo
Signal-to-Noise Ratio (SNR)91 dB
Mobile operating systems supportedAndroid, iOS
Volume controlRotary
iPod Direct ControlYes
Audio output channels4.0 channels
Maximum power per channel50 W
Display
Built-in displayYes
Display number of lines1 lines
Display typeLCD
Display digits12 digits
Ports & interfaces
AUX inYes
Line outputs (RCA)2
BluetoothYes
Bluetooth profilesA2DP, AVRCP, GAP, HFP, OPP, PBAP, SDAP, SPP
Bluetooth version3.0+HS
USB ports quantity1
USB version2.0
USB portYes
Weight & dimensions
Weight500 g
Dimensions (WxDxH)178 x 97 x 50 mm
Packaging content
Handheld remote controlYes
Technical details
Key illumination colorRed
MP3 bit rates48 - 320 Kbit/s
Peak Music Power Output (PMPO)200 W
show more

Can't find the answer to your question in the manual? You may find the answer to your question in the FAQs about the Pioneer MVH-X380BT below.

What is the weight of the Pioneer MVH-X380BT?

The Pioneer MVH-X380BT has a weight of 500 g.

What is the difference between FM and AM?

FM stands for Frequency Modulation and AM stands for Amplitude Modulation. The biggest difference between FM radio stations compared to AM radio stations is the sound quality.

When is my volume too loud?

A volume above 80 decibels can be harmful to hearing. When the volume exceeds 120 decibels, direct damage can even occur. The chance of hearing damage depends on the listening frequency and duration.

My car radio does not turn on, now what?

If your car radio does not turn on, it will not receive any power. Check that the red wire is connected to the contact power supply and the yellow wire to the constant power supply.

How can I best clean my car radio?

A slightly damp cleaning cloth or soft, dust-free cloth works best to remove fingerprints. Dust in hard-to-reach places is best removed with compressed air.

What is bluetooth?

Bluetooth is a way of exchanging data wirelessly between electronic devices via radio waves. The distance between the two devices that exchange data can in most cases be no more than ten metres.

How do I adjust the audio settings on my Pioneer MVH-X380BT car radio?

To adjust the audio settings, navigate to the "Audio" menu by pressing the corresponding button on the car radio interface. From there, you can fine-tune the bass, treble, balance, and fader settings to suit your preferences.

How can I connect my smartphone to the Pioneer MVH-X380BT car radio via Bluetooth?

Firstly, ensure that the Bluetooth function is activated on both your smartphone and the car radio. Then, on the car radio interface, select "Bluetooth" and choose the option to pair a new device. Follow the on-screen prompts to complete the pairing process and establish a wireless connection between your phone and the car radio.

Is it possible to customize the display colors on the Pioneer MVH-X380BT car radio?

Yes, you can customize the display colors according to your preference. Locate the "Display" menu on the car radio interface, and within this menu, you will find options to adjust the color of the display and buttons. Simply select your desired colors and save the changes.

How do I set the clock time on my Pioneer MVH-X380BT car radio?

To set the clock time, access the "Settings" menu on the car radio interface. Within the settings, navigate to the "Clock" option. From there, you can manually input the correct time using the provided controls. Remember to save the changes to ensure the accurate clock display.

Can I play music from a USB device on the Pioneer MVH-X380BT car radio?

Absolutely! The car radio supports playback from USB devices. Connect your USB device to the appropriate port on the car radio, and it should automatically detect the music files. Using the interface controls, navigate to the USB playback menu and select the desired songs or playlists to enjoy your favorite tunes.

Does the Pioneer MVH-X380BT have MP3 playback?

Yes, the Pioneer MVH-X380BT has MP3 playback. This means that users can listen to their favorite music in MP3 format.

Can the Pioneer MVH-X380BT play CDs?

No, the Pioneer MVH-X380BT cannot play CDs. This means that users will need to use other devices or formats to play their CDs.

How many preset stations can the Pioneer MVH-X380BT store?

The Pioneer MVH-X380BT can store up to 24 preset stations. This allows users to quickly access their favorite radio stations.

Does the Pioneer MVH-X380BT have an equalizer?

Yes, the Pioneer MVH-X380BT has an equalizer. This means that users can adjust the sound settings to their preference.

What type of display does the Pioneer MVH-X380BT have?

The Pioneer MVH-X380BT has a 1-line LCD display. This provides users with basic information about the radio and music playback.

Is the manual of the Pioneer MVH-X380BT available in English?

Yes, the manual of the Pioneer MVH-X380BT is available in English .

Is your question not listed? Ask your question here

No results