• Front speakers x 2 • Center speaker x 1 • Surround speakers x 2 • Subwoofer x 1 • Speaker cords x 6Front left (White)
Taiwan model All other models
This is a standard multichannel surround
sound speaker setup for optimal 5.1
channel home theater sound.
1
Attach the smaller non-skid pads to the base of each of the front and center speakers.Use the adhesive to attach 4 pads to the base of each speaker.
2
Connect the speaker system.Refer to Setting up your DVD/CD Receiver
(the other part of this setup guide) to
connect the speakers properly. Place
them as shown in the diagram at far left
for optimal surround sound.
2
Connect the speaker system.Refer to Setting up your DVD/CD
Receiver (the other part of this setup
guide) to connect the speakers properly.
Place them as shown in the diagram at
far left for optimal surround sound.
The base of each surround speaker fits
into the circular groove on the top of the
front speakers as shown.
3
Secure the speaker wire.After testing for the slack necessary to
turn the speaker (see the following
step), use the groove provided to secure
the speaker wire as shown.
Leave 5 cm of slack from the speaker terminals so the upper (surround) speaker can turn freely.
Standard surround5-spot setup• Non-skid pads (large) Taiwan model x 4 All other models x 6• Non-skid pads (small) x 12• Mounting brackets x 4 *• Screws (for mounting brackets) x 4 *Front left
Subwoofer
Front right
4
Turn the surround speakers towards the closest wall, lining the arrows up for optimal Front Surround.Turn each surround speaker so that the arrow at the base is lined up with the FRONT
SURROUND arrow on the front speaker.
This is only necessary with the FrtMovie or FrtMusic modes. With ExtPower (Extra Power), line up the arrow with the EXTRA POWER arrow
(the surround speakers should be in the same direction as the front speakers). See the operating instructions for more on the Front Surround modes.This setup is ideal when rear surround speaker
placement isn’t possible or you want to avoid
running long speaker cables in your listening area.
Front surround 3-spot setupExtPowerFrtMovie / FrtMusicSurround
left
Surround
right
Speaker Setup guide
Check that you have all the speaker accessories.Center (Green) Front right (Red)
Surround left
(Blue)
Surround right
(Grey)
Subwoofer (Purple)
Front speakers Center speaker1
Attach the smaller non-skid pads to the base of each of the front and center speakers.Use the adhesive to attach 4 pads to the
base of each speaker.
Front speakersCaution
• To prevent accidents, make sure the
surround speaker is placed securely
on top of the front speaker.
• Please don't attach the speakers to
the wall or speaker stands for Front
surround 3-spot setup.
Center speakerAttach the large non-skid pads to the base of the subwoofer (
Singapore/Indonesia/Hong Kong/Phillipines/Malaysia models)
Use the supplied adhesive to attach 6
pads to the base of subwoofer.
: Non-skid pads
Center
Listening position
Center
Listening position
Surround
left
Surround
right
Front
left
Front
right
Subwoofer
Choose your subwoofer placement (Taiwan model only)The subwoofer supplied with this
system can be placed upright or on
its side (flat). Choose the position
that works best for your room, then
attach the large non-skid pads as
shown at right.
Upright position
Flat position
* Illustration shows the Taiwan model* Illustration shows the Taiwan model* Please refer to Wall-mounting the front and surround speaker system in the operating instructions for installation.
Setting up your DVD/CD Receiver
1
1 2
3
Check that you have all the accessories, then put the batteries in the remote control.Video cord
Batteries and
remote control
FM antenna
Microphone
(for Auto MCACC setup)
AM loop antenna
2
Connect the AM and FM antennas to the rear panel of the DVD/CD receiver.1
2
3
Push open the tabs, then insert
one wire fully into each terminal.
Release the tabs to secure the AM
antenna wires.
Pull off the protective shields
of both AM antenna wires.
4
Fix the AM loop antenna to the
attached stand.
To fix the stand to the antenna, bend in the
direction indicated by the arrow (fig. A) then
clip the loop onto the stand (fig. B).
Note: If you plan to mount the AM antenna
to a wall or other surface, secure the stand
with screws (fig. C) before clipping the loop
to the stand. Make sure the reception is clear.
5
6
Place the AM antenna on a flat
surface and point in the direction
giving the best reception.
Don’t let it come into contact with metal
objects and avoid placing near computers,
television sets or other electrical appliances.
Connect the FM wire antenna to the FM UNBAL 75Ω antenna terminal.
For best results, extend the FM antenna fully and fix to a wall or door
frame. Don’t drape loosely or leave coiled up.
Note: The signal earth (H) is designed to reduce noise that occurs when an
antenna is connected. It is not an electrical safety earth.
When connecting this system or changing connections, be sure to switch the power off with the STANDBY/ON button, and disconnect the power cord from the AC outlet.
Do not use these speakers with any other system or amplifier as this may result in damage or fire.3
Connect each speaker using the color-coded speaker cords. Match them to the colored speaker terminals on the rear panel of the DVD/CD receiver.1
2
3
Connect each speaker as shown below.Twist and pull off the protective
shields on each wire.
Connect the wires to the
speaker. Match the colored
wire with the color-coded
label (above the tabs), then
insert the colored wire into
the red (+) tab and the other
wire with the black (–) tab.
Connect the other end to the color-
coded speaker terminals on the
rear of the DVD/CD receiver (as
shown at left). Make sure to insert
completely.
The small lug at the wire-end of the
speaker plug should face up or
down depending on whether it's
being plugged into one of the
upper or lower three speaker
terminals. Please make sure to
connect correctly.
For the best surround sound, setup your speakers as above. The front left and right speakers should be about 1.8–2.7 m apart.Congratulations! You're done setting up.
Printed in <XRE3099-A>
These speaker terminals can be hazardous when live. When you connect or
disconnect the speaker cables, to prevent the risk of electric shock, do not
touch uninsulated parts before disconnecting the power cord.
Connect the DVD/CD receiver to your TV, then connect the supplied power cord.3
Connect the power cord to the AC inlet.
2
Connect one end to a video input on your TV.
Use the supplied video cord.
4
1
Using the remote controlThe remote control can be used within a range of about 7 meters from the remote sensor on the front panel, and within a 30 degree angle. Precautions:
• The remote control may not work if there is an obstacle between the remote control and the display unit, or if the remote control is not directed towards the remote sensor of the display unit at the correct angle.• The remote control may not work properly if strong light such as direct sunlight or fluorescent light is shining onto the unit’s remote sensor.• The remote control may not work properly when this unit is used near devices emitting infrared rays, or when remote controls of other devices which use infrared rays are used. Also, the use of this remote control may cause other devices to work improperly.• When the operating range of the remote becomes too short, replace the batteries. Remote control battery caution
Incorrect use of batteries may cause leakage or rupture. Always be sure to follow these guidelines:• Always insert batteries into the battery compartment correctly matching the positive ª and negative ·
polarities, as shown by the display inside the compartment.• Never mix new and used batteries.• Batteries of the same size may have different voltages, depending on brand. Do not mix different brands of batteries. • When disposing of used batteries, please comply with governmental regulations or environmental public instruction's rules that apply in your country or area.• In order to prevent battery leakage, remove the batteries when not using the remote control for an extended period (one month or more). If leakage occurs, carefully wipe away any battery fluid inside the compartment, and replace the batteries with new ones.• Do not allow books or other objects to rest on top of the remote control, since the buttons may be depressed, causing faster exhaustion of the batteries. Additional notes on connecting antennas
• Keep antenna cables away from the main unit and other cables.• To assure optimum reception, pull the FM antenna so that it is fully extended and not coiled or hanging at the rear of the unit.• If reception with the supplied antenna is poor, see the Other connections section in the main operating instructions for details on connecting outdoor antennas. Additional notes on speaker placement
If your listening room is of adequate size, place the speakers as shown in step 3 to achieve the optimum surround sound effect. If you are listening in a fairly small room and a typical surround speaker setup is not possible, see Home theater sound setup in the instruction manual and the Speaker Setup guide for information on the Front surround 3-spot setup option.When using the standard surround speaker setup as shown in step 3, please observe the following guidelines:• Install the main front left and right speakers at an equal distance from the TV.• For optimum effect, install the rear speakers slightly above ear level.• Install the center speaker above or below the TV so that the sound of the center channel is localized at the TV screen.Precautions:
• When installing the center speaker on top of the TV, be sure to secure it with tape or some other suitable means. Otherwise, the speaker may fall from the TV due to external shocks such as earthquakes, endangering those nearby or damaging the speaker. • Do not connect the supplied speakers with any other amplifier. This may result in malfunction or fire.• The front, center and surround speakers supplied with this system are magnetically shielded. However, depending on the installation location, color distortion may occur if the speaker is installed extremely close to the screen of a television set. If this happens case, turn the power switch of the television set OFF, and turn it ON after 15 to 30 minutes. If the problem persists, place the speaker system away from the television set. • The subwoofer is not magnetically shielded and so should not be placed near a TV or monitor. Since it is not magnetically shielded, do not place any magnetic storage media (such as floppy disks and tape or video cassettes) close to the subwoofer.• Do not fix the subwoofer and center speaker to the wall or ceiling; they could cause injury if they fell. Connect the other end to the video output of the DVD/CD receiver.
This player is equipped with copy protection technology. Do not connect this
player to your TV via a VCR using AV cables, as the picture from this player will not
appear properly on your TV.
ST+
TUNE+ENTERTUNE–MASTERVOLUMEST–STANDBY/ONCD FM/AMOPEN CLOSEDVD TUNER TV LINEL1/L21
4
4
¡
8
3
7
0
DVD MENURETURNBASS
MODE
TV CONTROLCH VOLINPUTOPEN
MUTE
Color-coded wire (Connect to speaker)Color-coded connector(Connect to rear panel)FRONTSURROUNDPower cord
*
ANTENNA3
1
2
4
6
fig. A fig. B fig. CFM
UNBAL 75Ω AMLOOP ANTENNA6
6
6 6
6
6
FM
UNBAL 75Ω AMLOOP ANTENNAOPTICAL INOUT
VIDEOOUT
IN
FRONTCENTERMCACCMIC
SURROUNDSUB
WOOFERR
L
RRL
L
LINE 1LINE 2AC INAUDIOANTENNASPEAKERSIN
TV
AUDIOIN
CONTROLS-VIDEOOUT
COMPONENTVIDEO OUTP
R
P
B
Y
VIDEO6
6
6 66
6
OUTINFRONTCENTERMCACCMIC
SURROUNDSUB
WOOFERR
L
RRL
L
LINE 1TVIN
AUDIOSPEAKERSVIDEO INTo AC outletAC INVIDEOOUT
VIDEOFront right (Red)Front left
(White)
Surround left
(Blue)
Surround right
(Grey)
Listening position
Center (Green)
Subwoofer (Purple)
Upper three terminals
Lower three terminals
* Illustration shows the Taiwan model* Illustration shows the Taiwan model* Illustration shows the Taiwan modelXRE3099A.En.ChH.p65 05.2.22, 3:58 PM1
Need help?
Do you have a question about the Pioneer and is the answer not in the manual?
Question and answer
Number of questions: 1How do I select a user zone 1-6 ?