Pioneer HTP-2500 manual

Pioneer HTP-2500
5.3 · 1
PDF manual
 · 2 pages
English
manualPioneer HTP-2500
1
RECEIVER
+
+
+ +
+
BASS
OFF SOUND TONE
MPX
AUTO
ROOM
SETUP
TEST
TONE
SYSTEM
SETUP CH LEVEL
TUNING STATION
FM/AM TAPE/VCR TV CLASS
DIGITAL
INPUT SELECTOR
STB DVD/DVR
TUNER
EDIT
SLEEP STATUS DIMMER
STANDBY/ON MUTE
SURROUND
ENTER
VOLUME
STEREO
TREBLE
Check that you have all the
accessories.
Speaker cord (x1)FM wire antennaYou should also have: • Speakers (x5)• Subwoofer• Operating instructions• Warranty cardAM loop antennaNon-skid pads(1x20, 1x4)Batteries (x2)Remote controlBrackets (x4)Screws (x4)
2
Front and surround speakersCenter speakerSubwooferPut the batteries in the remote control and stick the non-skid pads to the base of the speakers.
1
Open the battery compartment on the rear of the remote control.Insert the supplied batteries following the markings inside the battery compartment to align them correctly.Replace the battery compartment cover.Stick the self-adhesive non-skid pads to the underside of each speaker, and to the underside of the subwoofer. Use four pads per speaker (see below).
2
3
4
5
DIGITAL
OUT
+
+
DIGITAL INPUT
(COAXIAL)
DVD/DVR
OUT
RL
IN
TV IN
AUDIO
AUDIO
OUT
VIDEO
IN
VIDEO
OUT
R
L
Connect the receiver to your DVD player/ recorder.
1
Use a coaxial digital cord (not supplied) to connect the digital output of your DVD player/ recorder to the DIGITAL INPUT (COAXIAL) DVD/DVR jack.
2
Use a red/white stereo audio cord (not supplied) to connect the AUDIO TV IN jack on the receiver to the audio output on your TV.* This will allow you to listen to your TV through this speaker system.* Note that you must also connect the DVD player/ recorder's video output to your TV's video input to watch a DVD video (video cable is not supplied).DVD player/ recorderReceiver
TV
ANTENNA
FM
UNBAL
75
AM
LOOP
AM loop antennaFM wire antenna3/8 in. (10mm)
4
Connect antennas
1
Connect the FM wire antenna and fully extend along a window frame or another suitable place that gives good reception.
2
To connect the AM loop antenna, twist the exposed wire strands together and insert into the terminal, then snap the connector shut as shown below.Receiver
6
VIDEO 1
STANDBY/ON
STANDBY/ON
STANDBY/ON
STANDBY/ONVIDEO SELECTPlug the receiver, DVD player/ recorder and TV into a convenient AC outlet.
1
Press STANDBY/ON to switch on the receiver.
2
Switch on your DVD player/ recorder and TV, and set the TV to the correct video input.DVD player/ recorderReceiver
TV
7
+
VOLUMEAUTO SURROUND STEREO
FM/AM TAPE/VCR TV
DIGITAL
INPUT SELECTOR
STB DVD/DVR
After switching on, make any necessary settings required by the DVD player/ recorder, then you're ready to start enjoying your home theater system.Refer to the receiver's operating instructions for a detailed explanation of this system's surround sound features.
3
For the best surround sound, set up your
speakers like this. The front left and right
speakers should be about 6–9 feet apart.
Connect each speaker to the receiver using the
supplied speaker wires.
To connect, insert the colored wire into the matching colored (+) tab and the other wire into the black () tab as shown below. Connect the center speaker the same way (matching the wire the color-coded label).Note that the color-coded tabs are as follows:
Red : Front right speaker Purple : Subwoofer
White : Front left speaker Grey : Surround right speaker
Green : Center speaker Blue : Surround left speaker
Listening positionSPEAKERS
+
+
RL RLCENTER
SUB
WOOFERFRONTSURROUNDFront leftFront rightSurround leftSurround rightCenterSubwooferReceiver

HTP-2500/2600 Quick Start Guide

For detailed instructions, see the Operating Instructions supplied and / or contact one of our knowledgeable Pioneer Customer Service Representatives at 1 - (800) 421-1404.
HTP2500.p65 05.1.17, 4:59 PM1

View the manual for the Pioneer HTP-2500 here, for free. This manual comes under the category home cinema sets and has been rated by 1 people with an average of a 5.3. This manual is available in the following languages: English. Do you have a question about the Pioneer HTP-2500 or do you need help? Ask your question here

Need help?

Do you have a question about the Pioneer and is the answer not in the manual?

  • Receive updates on solutions
  • Get answers to your question

Question and answer

Number of questions: 0

General
BrandPioneer
ModelHTP-2500
Producthome cinema set
LanguageEnglish
FiletypeUser manual (PDF)

Can't find the answer to your question in the manual? You may find the answer to your question in the FAQs about the Pioneer HTP-2500 below.

What is HDMI?

HDMI stands for High-Definition Multimedia Interface. An HDMI cable is used to transport audio and video signals between devices.

How can I best clean my home cinema set?

A slightly damp cleaning cloth or soft, dust-free cloth works best to remove fingerprints. Dust in hard-to-reach places is best removed with compressed air.

Wat is Dolby Atmos?

Dolby Atmos is a technology that ensures that the sound is reflected from the ceiling to where you are listening. This makes it possible to create a 5.1 effect with only 1 speaker.

Is the manual of the Pioneer HTP-2500 available in English?

Yes, the manual of the Pioneer HTP-2500 is available in English .

Is your question not listed? Ask your question here

No results