Please read through these operating instructions for proper assembly and use.
After you have finished reading the instructions, put them away in a safe place
for future reference.
Before you start
Before setting up your speaker system, we recommend reading
the operating instructions for your system thoroughly.
Only use the screws supplied when fixing the speaker to the speaker stand.
Do not place the stand on an unstable and/or sloping surface. The stand
and speaker may fall and cause injury.
Do not use with any speaker system other than the one for which the unit
was designed. The stand may collapse and be damaged and/or the speaker
may fall and cause injury.
When moving the speaker and stand, first remove the speaker from the
stand, and then move the stand, holding it by the stems.
Place the stand on a stable, level surface; placing the stand on an unstable
surface can be dangerous.
Be careful not to tighten screws excessively.
If excessive force is used to tighten screws, the threads of screw and/or nut
may be damaged. Use a middle-sized manual screwdriver during assembly.
Do not use power screwdrivers or oversized screwdrivers that may exert
excessive force on the screws and nuts.
Confirm that no foreign matter is stuck to the stand base, stand posts, or
the speaker support during assembly.
If the unit is assembled with foreign matter stuck between the stand base
and stand posts, or between the stand posts and the speaker support, the
unit may not be assembled securely, resulting in tipping or falling.
Do not stand on the speaker stand base of the tall speaker to
push or swing
the speaker. The speaker may fall and break, or
someone may be injured.
Pay special attention to children.
To be safe, make sure to adjust the height of the speaker and firmly tighten
the adjuster before fixing the speaker.
Make sure to tighten the adjuster so that it does not wobble. Further, if the
stand is moved to another location, check to see that the stand post does
not wobble. If it does wobble, make sure to tighten it again.
Pioneer assumes no liability whatsoever for damages resulting from
assembly, improper mounting, insufficient reinforcement, misuse of the
product, acts of nature, etc.
Stand maintenance
Use a polishing cloth or dry cloth to wipe off dust and dirt.
If the stand is very dirty, use a soft cloth dipped in some neutral cleanser
diluted five or six times with water. Finally, wipe again using a dry cloth. Do
not use furniture wax or cleaners.
Never use thinners, benzine, insecticide sprays and other chemicals on or
near the stand, since these will corrode the surfaces.
View the manual for the Pioneer CP-31B here, for free. This manual comes under the category not categorized and has been rated by 1 people with an average of a 7.5. This manual is available in the following languages: English. Do you have a question about the Pioneer CP-31B or do you need help? Ask your question here
Need help?
Do you have a question about the Pioneer and is the answer not in the manual?
Need help?
Do you have a question about the Pioneer and is the answer not in the manual?
Question and answer
Number of questions: 0