28 Advanced settings
If no base is found within a certain period,
NO BAS E
will be displayed with an error
tone to indicate failed regist ration and the
handset re turns to idle mode .
8.3 Unregister
Press
m key in idle mode, scroll : to ADVANCED SET
and press
<
OK
, scroll : to
UNREGISTER
and press <
OK
.
Enter the Master PIN when
prompted and
CONFIRM?
is
displayed on the screen. Press
<
OK
to confirm.
Scroll
: to select the handset number to unregister and press
<
OK
.
• A validat ion tone is emitted to indica te
successful unregistration and the
screen r e turns to prev ious menu.
Note
If no action is taken on the handset within
15 seconds, the unregistration procedure
will be aborted and the handset returns
to idle mode.
To unregi ster a ha ndset th at does not
belong to your new phone range, you can
only use your new phone to unregister it.
8.4 Country selection
The availability of this menu is dependent
on your country. You can select another
country different from the one chosen
during WELCOME mode.
Note
Once the country is selected, the default
line settings for t he selected count ry will
be applied to the phone automatically (e.g.
Recall time, Dial mode, La nguage, etc).
Press
m key in idle mode, scroll : to ADVANCED SET
and press
<
OK
, scroll : to
COUNT RY
and press <
OK
.
Enter the Master PIN when prompted
and press
<
OK
to confirm.
Note
By default, the Master PIN is 0000.
Scroll
: to the country of your choice and press
<
OK
to confirm.
• A validation tone is emitted a nd the
screen returns to previous menu.
8.5 R eset un it
You can reset your phone to its default
settings with this fe ature.
Warning
Upon reset, all your personal settings, call
log and redial list entries will be deleted
and the phone will return to its defau lt
settings. However, your phonebook will
remain unchanged after reset.
Note
You may have to configure your phone
once again. In this case the W ELCOME
mode will appear again after master reset.
(see chapter 3.4)
Press
m key in idle mode, scroll : to ADVANCED SET
and press
<
OK
, scroll : to
RESET
and
press
<
OK
.
CONFIRM?
is displayed on th e screen.
Press
<
OK
again
to conf irm.
• A validation tone is emitt ed.
• The unit is re set to its defa ult
settings. (see “Default settings” on
chapter 8.10)
1
2
3
1
2
3
!
1
2
3
CD150_IFU_master_UK. book Page 28 Tu esday, February 19, 2 008 9:11 AM
Need help?
Do you have a question about the Philips and is the answer not in the manual?
Question and answer
Number of questions: 0