Philips LX8300SA manual

Philips LX8300SA
(1)
  • Number of pages: 51
  • Filetype: PDF
2
3139 115 23261

Norge

Typeskilt finnes på apparatens underside.
Observer: Nettbryteren er sekundert
innkoplet. Den innebygde netdelen er
derfor ikke frakoplet nettet så lenge
apparatet er tilsluttet nettkontakten.
For å redusere faren for brann eller elektrisk
støt, skal apparatet ikke utsettes for regn eller
fuktighet.

Italia

DICHIARAZIONE DI CONFORMITA’
Si dichiara che l’apparecchio LX8300SA, Philips
risponde alle prescrizioni dell’art. 2 comma 1 del
D.M. 28 Agosto 1995 n. 548.
Fatto a Eindhoven
Philips Consumer Electronics
Philips, Glaslaan 2
5616 JB Eindhoven, The Netherlands

CAUTION

Use of controls or adjustments or

performance of procedures other than

herein may result in hazardous

radiation exposure or other unsafe

operation.

VAROITUS

Muiden kuin tässä esitettyjen

toimintojen säädön tai asetusten

muutto saattaa altistaa vaaralliselle

säteilylle tai muille vaarallisille

toiminnoille.

Important notes for users in the

U.K.
Mains plug
This apparatus is fitted with an approved 13
Amp plug. To change a fuse in this type of plug
proceed as follows:

1 Remove fuse cover and fuse.

2 Fix new fuse which should be a BS1362 5 Amp,

A.S.T.A. or BSI approved type.

3 Refit the fuse cover.

If the fitted plug is not suitable for your socket
outlets, it should be cut off and an appropriate
plug fitted in its place.
If the mains plug contains a fuse, this should
have a value of 5 Amp. If a plug without a fuse
is used, the fuse at the distribution board
should not be greater than 5 Amp.
Note: The severed plug must be disposed of to
avoid a possible shock hazard should it be
inserted into a 13 Amp socket elsewhere.
How to connect a plug
The wires in the mains lead are coloured with
the following code: blue = neutral (N),
brown = live (L).
As these colours may not correspond with the
colour markings identifying the terminals in
your plug, proceed as follows:
Connect the blue wire to the terminal
marked N or coloured black.
Connect the brown wire to the terminal
marked L or coloured red.
Do not connect either wire to the earth
terminal in the plug, marked E (or e) or
coloured green (or green and yellow).
Before replacing the plug cover, make certain
that the cord grip is clamped over the sheath
of the lead - not simply over the two wires.
Copyright in the U.K.
Recording and playback of material may
require consent. See Copyright Act 1956 and
The Performer’s Protection Acts 1958 to 1972.
001-047-LX83-22-Eng 6/9/04, 2:01 PM2
Philips LX8300SA

Need help?

Number of questions: 0

Do you have a question about the Philips LX8300SA or do you need help? Ask your question here. Provide a clear and comprehensive description of the issue and your question. The more detail you provide for your issue and question, the easier it will be for other Philips LX8300SA owners to properly answer your question.

View the manual for the Philips LX8300SA here, for free. This manual comes under the category Home cinema sets and has been rated by 1 people with an average of a 7.5. This manual is available in the following languages: English. Do you have a question about the Philips LX8300SA or do you need help? Ask your question here

Philips LX8300SA specifications

Convenience in the palm of your hand with a remote control that makes controlling your display easier than ever.
General
Brand Philips
Model LX8300SA
Product Home cinema set
EAN 8710895807197
Language English
Filetype PDF
Audio
Signal-to-Noise Ratio (SNR) 95 dB
RMS rated power 400 W
MP3 bit rates 32 - 256 Kbit/s
Audio output channels - channels
Audio decoders Dolby Digital,Dolby Pro Logic II,DTS
Audio D/A Converter (DAC) 24-bit/192kHz
Audio formats supported MP3,PCM
Sound enhancement technology
Satellite speakers
Satellite speaker frequency range 120 - 50000 Hz
Satellite speaker impedance 12 Ω
Satellite speaker tweeter diameter 3 "
Satellite speaker mid-range driver diameter 3 "
Wireless satellite speakers
Center speaker
Center speaker frequency range 120 - 30000 Hz
Center speaker impedance 12 Ω
Center speaker type 2-way
Center speaker tweeter diameter 1.75 "
Center speaker mid-range driver diameter 2 "
Subwoofer
Subwoofer frequency range 30 - 120 Hz
Subwoofer impedance 4 Ω
Wireless subwoofer
Subwoofer driver diameter (imperial) 6.5 "
Power
Power consumption (standby) 2 W
AC input frequency 50 - 60 Hz
AC input voltage 200-240 V
Optical drive
Number of optical discs 1 discs
Disc loading type Tray
Optical disc player type DVD player
Disc types supported CD,CD-R,CD-RW,DVD+R,DVD+RW,DVD-R,DVD-RW
Playback disc formats CD video,SACD,SVCD
Other features
Built-in HDD
Apple docking compatibility Not supported
Image formats supported JPG
Parental control
Display FTD
TV tuner integrated
Video
3D
Video formats supported DIVX,MPEG1,MPEG2,MPEG4
Video D/A Converter (DAC) 12-bit/108MHz
Analog signal format system NTSC,PAL
Aspect ratio 4:3,16:9
Progressive scan
Video enhancement technology
Radio
FM radio
Supported radio bands FM,MW
Radio Data System (RDS)
Preset stations quantity 20
Technical details
Product colour Silver
Karaoke
Playback modes Repeat,Repeat all,Repeat one,Shuffle
Display
On Screen Display (OSD)
Built-in display
Network
Wi-Fi
Packaging content
Remote control included
Manual
Cables included AC
Quick start guide
Warranty card
Ports & interfaces
HDMI in 0
Number of HDMI outputs 0
SCART ports quantity 1
USB ports quantity 0
Component video (YPbPr/YCbCr) out 1
Composite video out 1
S-Video outputs quantity 1
Audio (L/R) in 1
FM antenna
Digital audio coaxial in 0
Digital audio optical in 0
AUX in
Digital audio optical out 0
Ethernet LAN (RJ-45) ports 0
Digital audio coaxial out 0
Weight & dimensions
Center speaker dimensions (WxDxH) 435 x 70 x 76 mm
Satellite speaker dimensions (WxDxH) 95 x 82 x 255 mm
Subwoofer dimensions (W x D x H) 300 x 300 x 400 mm
show more

Frequently Asked Questions

Below, you will find the most frequently asked questions about the Philips LX8300SA.

Is your question not listed? Ask your question here