English 1 Important Read these instr uctions for use carefully before using the appliance and sa ve them for future
reference.
Danger • Do not immer se the motor unit in water nor r inse
it under the tap. • Do not connect the appliance to a timer switch.
Warning • Before y ou connect the appliance to the pow er ,
make sure that the voltage indicated on the bottom of the appliance corresponds to the local power voltage. • If the pow er cord, the plug, or other par ts are
damaged, do not use the appliance. • If the pow er cord is damaged, you must ha v e it
replaced by Philips, a service center authorized by Philips,orasimilarlyqualiedpersontoavoida hazard. • This appliance is not intended for use b y per sons
(including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. • For their safety , do not allow children to pla y with
the appliance. • Be ver y careful when you handle the cutter ,
especially when you remove it from the worm shaft and during cleaning. The cutting edges are very sharp! • Before y ou remov e any accessor y , switch the
appliance off and unplug it. • Donotusey ournger soranobject(e .g. aspatula)
to push ingredients into the hopper while the appliance is running. Only the pushers are to be used for this purpose. • Donotinser ty ournger sinthemetaldr umwhile
the appliance is running. Caution • The appliance is intended for household use onl y .
• Before y ou connect the appliance to the mains,
make sure that the appliance is assembled correctly. • Never use an y accessor ies or par ts from other
manufacturersorthatPhilipsdoesnotspecically recommend. If you use such accessories or parts, your guarantee becomes invalid. • Alwa ys switch the appliance off by turning the
switch knob to . • Do not let the appliance r un unattended.
• Do not exceed the maximum operating time of
4 minutes under heavy load applications. Let the appliance cool down to room temperature before next operation. • Do not use the button with the plastic hopper .
• Noise level: Lc = 87 dB [A]
Safety system (Fig. 9) This appliance is equipped with ov erheat protection. If the appliance ov erheats, it switches
off automatically . Unplug the appliance and let it cool down until room temperature. Then,
put the mains plug back into the power outlet and switch on the appliance again. Please
contact your Philips dealer or an authorized Philips ser vice center if the overheat protection
is activated too often.
HR2732, HR2733 HR2734 and HR2735 only Theapplianceisttedwithasafetyfeaturewhichsaf eguardsagainstoverloading. Incasethe
appliance is ov er loaded, it automatically activates the o ver load protection and switches off.
If this occur s, set the switch knob to , unplug the appliance and let it cool down for 15
minutes. Remove the residue inside the hopper and then press the ov er load reset button on
the bottom of the motor unit (Fig. 9).
Electromagnetic elds (EMF) ThisPhilipsappliancecomplieswithallstandardsregardingelectromagneticelds(EMF). If
handled proper ly and according to the instructions in this user manual, the appliance is safe
tousebasedonscienticevidenceavailab letoday .
Recycling Y our product is designed and manufactured with high quality mater ials and
components, which can be recycled and reused.
When you see the crossed-out wheel bin symbol attached to a product, it means the
productiscov eredbytheEuropeanDirective2002/96/EC:
Never dispose of y our product with other household waste . Please inform yourself
about the local r ules on the separate collection of electr ical and electronic products.
The correct disposal of your old product helps prevent potentially negativ e
consequences on the environment and human health.
2 Introduction CongratulationsonyourpurchaseandwelcometoPhilips! T ofullybenetfromthesuppor t
that Philips offers, register your product at www .philips.com.
With this meat mincer , you can
• mince meat
• make sausages
• makekeb be(HR2730MiddleEast Asia, HR2732, HR2733HR2734andHR2735only)
• cutvegetables(HR2731, HR2733andHR2735only)
Tip
• For more recipes, go to www .kitchen.philips.com.
3 What’s in the box (Fig. 1) a Hopper release button
• Press and hold it when you remo ve the hopper .
b Motor unit
c Switch knob for power and re verse modes / /
• Switch off ( ) or on ( ) the meat mincer .
• Switch to to reverse the motor .
d Power cor d
e Pusher for the metal hopper
f Metal hopper
g Extra gear for the worm shaft (HR2730, HR2731, HR2733 and HR2735 only)
h W orm shaft
i Cutter/Knife
j Hygienic stainless steel grinding discs
• A : Coarsegr indingdisc(diameterof8mm)
• B : Mediumgrindingdisc(diameterof5mm)
• C : Finegrindingdisc(diameterof3mm)(HR2732, HR2733HR2734andHR2735
only)
k Screw ring
l Sausage horns
• A : Largesausagehorn(diameterof22mm)
• B : Smallsausagehorn(diameterof12mm)
m Sausage separator
n Kebbe mak er (HR2730 Middle East Asia, HR2732, HR2733 HR2734 and HR2735 only)
• A: Keb be separ ator
• B: Keb be shaper
o Pusher for the plastic hopper (HR2731, HR2733 and HR2735 only)
p Plastic hopper (HR2731, HR2733 and HR2735 only)
q Shield (HR2731, HR2733 and HR2735 only)
r Metal drums (HR2731, HR2733 and HR2735 only)
• A: Coarsegr aterdr um
• B: Slicer drum
s Dust cover (HR2732, HR2733 HR2734 and HR2735 only)
t Accessories tray (HR2732, HR2733 HR2734 and HR2735 only)
u Metal meat tray
v Innovative cleaning tool
• A: (HR2730andHR2731onl y)
• B: (HR2732, HR2733HR2734andHR2735only)
4 Mince meat Beforeyoustar t, makesurey ouassembleaccordingtoFig. 2-1.
Fordisassembly , ref ertoFig. 3-1.
Mince meat Note
• Never grind bones, nuts, or other hard items.
• Neverusefrozenmeat!Bef oreyougrindthemeat, defrostitrst.
• Do not overload the appliance by pushing too much meat into the hopper .
• Depending on the granular ity of minced meat, select the proper grinding disc. Y ou can also
grindformorethanoncefornertexture.
Tip
• Remove bones, gristle , and sinews out of the meat as much as possible.
• If the hopper is blocked, switch to to rever se the motor and clear the leftover meat.
5 Make sausages Beforeyoustar t, makesurey ouassembleaccordingtoFig. 2-2.
Fordisassembly , ref ertoFig. 3-2.
Make sausages Note
• Do not block the air outlet groo ves of the sausage horn.
• Do not make the sausages too thick in case the sausage skin is ov er stretched.
• Keep the sausage skin wet to prevent it from sticking on the sausage horn.
Recipe Sausages Ingredients:
• 800gpor kbelly
• 1.6kgpor kshoulder
• 4 m of por k sausage skin (wet)
• Seasoning such as Salt, pepper , spices and herbs of your choice
Directions:
1 Chopporkintopiecestotthehopperofthemeatmincer. 2 Grind the por k belly and shoulder together using the coar se screen.
3 Add seasoning and mix well (tip: fr y a spoonful of the mixture to check the taste).
4 Apply the wet sausage skin to the sausage horn, and attach to the meat mincer (no
blade needed).
5 Leav e adequate sausage skin at the beginning before turning on the meat mincer .
6 Make kebbe (HR2730 Middle East Asia, HR2732, HR2733 HR2734 and HR2735 only) Beforeyoustar t, makesurey ouassembleaccordingtoFig. 2-3.
Fordisassembly , ref ertoFig. 3-3.
Make kebbe Recipe Kebbe Yield: 5-8 ser vings
Ingredients:
• Outer casing
• 500glamborfat-freemutton, cutintostr ips
• 500gbulgurwheat, washedanddr ained
• 1 small onion and cooked
• Filling
• 400glamb, cutintostr ips
• 15 ml oil
• 2mediumonions, nel ychopped
• 5-10mlgroundallspice
• 15mlplainour
• salt and pepper
Directions:
• Outer casing
1)Mincethemeat, wheat, andoniontogetherwiththenegrindingdisc .
2) Thoroughly mix the minced ingredients, and then mince the mixture twice again.
3) Use the kebbe mak er to shape the mixture into kebbe casing.
• Filling
1)Mincethemeatwiththemediumgrindingdisc .
2) Fr y the onion chops until they turn golden brown.
3) Addthemincedmeatandotheringredientsin, andthencookfor1-2minutes.
4)Drainoffexcessivefatandcoolthellingdown.
• Cooking
1)Pushsomellingintotheoutercasing, andthenpinchbothendstosealit.
2)Heattheoilfordeepfr ying(190°C).
3)Deepfr ythekebbef or3-4minutes, oruntilitturnsgoldenbrown.
7 Cut vegetables (HR2731, HR2733 and HR2735 only) Beforeyouusetheappliancef orther sttime , thoroughlycleanthepar tsthatcomeinto
contact with food.
Beforeyoustar t, makesurey ouassembleaccordingtoFig. 2-4.
Fordisassembly , ref ertoFig. 3-4.
Fig. 7 indicates the f oods that each dr um is applicable to and the cutting shapes.
Note
• Only use the plastic hopper in combination with the metal drums and the pusher for plastic
hopper .
• Do not press the button during use of the plastic hopper .
Cut vegetables Cutvegetablesintopiecesorstripsthatcanbeeasilypushedintothehopper .
1 Switch on the appliance. 2 Push the vegetables into the hopper. Tip
• Y ou can also grate cheese .
8 Cleaning and maintenance (Fig. 4, Fig. 5 and Fig. 6) Note
• Beforeyouusetheappliancef orther sttime , thoroughlycleanthepar tsthatcomeinto
contact with food.
• Before you remo ve accessories or clean the motor unit, switch off and unplug the appliance.
• Do not immer se the motor unit in water nor rinse it under the tap.
• Do not clean the metal par ts in a dishwasher .
• Cleanthemainunitwithamoistcloth.
• Pass pieces of bread through the cutter housing to remo ve any meat left.
• W ash removable par ts with a soft br ush in soapy water , r inse them with clear water , and then
dr y them with soft cloth or tissues immediately .
• Lightly brush the metal par ts with fat or oil to prevent r usting.
• StoretheapplianceaccordingtoFig. 6.
Tip
• Use the innovativ e cleaning tool to remove the remains stuck in the grinding discs. rinse them
with clear water , and then dr y them with soft cloth or tissues immediately .
9 Replace the gear (Fig. 8) (HR2730, HR2731, HR2733 and HR2735 only) When you mince sticky or fatty meat, use the supplied plastic coupling. For instructions on
howtoreplacethecoupling, seeg8.
Register your pr oduct and get support at
HR2730 HR2731 HR2732 HR2733 HR2734 HR2735 www.philips.com/welcome Specifications are subject to change without notice
© 2013 K oninklijke Philips Electr onics N.V .
All rights reserved.
HR2730_2731_2732_2733_2734_2735_UM_WEU_V1.0
3-1
3-2
3-4
3
2
2-1
2-2
1
8
9
7
6
5
2-4
2-3
3-3
(HR2732, HR2733,
HR2734, HR2735)
(HR2730, HR2731)
(HR2732, HR2733, HR2734, HR2735)
r
o
p
q
A
B
A
B
v
b
a
e
k
h
g
c
d
A
B
C
j
i
l
B
A
A
B
m
n
t
s
u
f
4
(HR2732, HR2733 HR2734, HR2735) (HR2731, HR2733, HR2735) (HR2732, HR2733 HR2734, HR2735) (HR2732, HR2733 HR2734, HR2735) (HR2730_MEA, HR2732, HR2733 HR2734, HR2735) (HR2730, HR2731) (HR2731, HR2733, HR2735) IT Manuale utente NL Gebruiksaanwijzing NO Brukerhåndbok PT Manual do utilizador SV Användarhandbok TR Kullanım kılavuzu EN User manual DA Brugervejledning DE Benutzerhandbuch ES Manual del usuario FI Käyttöopas FR Mode d’emploi 1/4
3140 035 35591