Philips FC6908 manual

Philips FC6908
7.7 · 1
PDF manual
 · 5 pages
English
manualPhilips FC6908

Problem Possible cause Solution

The appliance does
not move smoothly
across the floor
when cleaning a
carpet.
You selected a too
high suction power.
Reduce the suction power by
choosing setting 1.
The brush does not
turn anymore.
The brush
encounters too much
resistance.
Clean the brush with a pair of
scissors or by hand.
The brush may stop
turning when it
encounters too much
resistance from high-
pile carpet.
Switch off the appliance ad
then switch it back on again.
You have not
installed the roller
brush in the nozzle
properly after
cleaning.
Follow the instructions in the
cleaning chapter of the user
manual to slide the roller
brush into the nozzle
properly and secure it inside
the nozzle by snapping home
the locking lever.
The LEDs in the
nozzle do not
come on.
You have not
attached the nozzle
to the appliance or
handheld properly.
Attach the nozzle to the
appliance or handheld
properly.
The appliance is
not charging.
The magnetic
connector is not not
connected correctly
to the charging disk
or the adapter is not
inserted into the wall
socket properly.
Make sure that the magnetic
connector is connected
properly to the charging disk
and that the adapter is
inserted into the wall socket
properly.
You have not
connected the
correct adapter and
cord.
Make sure that you use the
correct adapter and cord.
If you have checked the
above and the appliance still
does not charge, take it to a
Philips service center or
contact the Consumer Care
Center.
FC6908, FC6906:
The mini turbo
brush does not
function properly.
The roller brush is
blocked.
Remove hairs from the brush
with a pair of scissors (see
user manual).
The roller brush is
blocked by fabric or
surfaces during
cleaning.
Keep the mini turbo brush
aligned with the surface and
do not push the turbo brush
into soft surfaces.
The mini turbo brush
is not fully closed.
Make sure that the top and
bottom parts of the mini
turbo brush are properly
connected and there is no
gap between the two parts.
Check if the locking ring is in
closed position (see user
manual).
When I use my
vacuum cleaner I
sometimes feel
static electricity
shocks.
Your vacuum cleaner
builds up static
electricity. The lower
the air humidity, the
more static electricity
the appliance builds
up.
Discharge the appliance by
frequently holding the tube
against other metal objects in
the room (for example the
legs of a table or chair, etc.).
You can also raise the air
humidity level in the room.
The water flow
from the water tank
is reduced.
The wetting strip is
blocked by excessive
residue.
Remove the wetting strip and
clean it.
The microfiber
mopping pad is not
placed correctly and
blocks the wetting
strip as a result. This
prevents water from
flowing out of the
wetting strip.
Make sure that you place the
mopping pad correctly. Check
the user manual for proper
placement.
The water tank is
empty or nearly
empty.
Refill the water tank.
You use a microfiber
mopping pad that is
not supplied by
Philips.
Only use an original Philips
microfiber mopping pad. You
can buy these mopping pads
in the online Philips shop at
www.shop.philips.
com/service or at your Philips
dealer.
The output of
water is faster and
larger than normal.
If the water tank
produces an
uncontrolled and too
large amount of
water, the cap of the
tank is probably not
closed properly.
Check the cap and make sure
it is fully and properly closed.
The strip is not
placed properly in
the bottom of the
water tank.
Check the strip and make
sure that it is fitted properly
in the bottom plate of the
water tank.
The floor dries with
stripes when I use
the water tank.
You added too much
liquid cleaner to the
water.
Use only a few drops or use a
cleaner that foams less.

Error codes

Error code

Meaning

E1 The appliance is stored or charged at a temperature
below 5°C. Move the appliance to a warmer room. Do not
store or charge the appliance at a temperature below 5°C
or above 40°C.
E4 The roller brush in the motorized floor nozzle or in the
mini turbo brush has become blocked and cannot turn
freely. Switch off the appliance and check the roller brush
for obstructions.
E6 No current passes through the adapter.Check if the
adapter is inserted into the wall socket properly. If the
adapter is inserted properly and the charging disk
(magnet) is attached properly and the appliance does not
start to charge, the adapter may be defective. In that case,
please contact the Consumer Care Center or take the
appliance to an authorized Philips service center.
E7 You use the wrong adapter. Connect the correct adapter.
If the correct adapter does not work, please contact the
Consumer Care Center or take the appliance to an
authorized Philips service center.
SE Please take the appliance to an authorized Philips service
center.
简体中文

重要安全信息

使用本产品及其附件之前,请仔细阅读本重要信息,并妥善保管以供日后参考。
随附的附件可能因产品而异。
危险
- 切勿吸入水或其他任何液体。 切勿吸入易燃物质,也不要吸入未冷却的灰烬。
- 切勿将本产品或适配器浸入水或其他任何液体中,也不要将它们放在水龙头下
冲洗。
警告
- 在将本产品连接电源前,务必检查当地的电压是否与电源适配器所标电压一
致。
- 本产品包含充电电池,只能由技术人员更换。 切勿拆开本产品更换充电电池。
- 使用前,请务必检查产品。 如果产品或适配器受损,请停止使用。 请务必用
原装型号更换损坏的部件。
- 适配器中包含一个变压器。 请勿剪下适配器更换其他插头,否则将导致严重后
果。
- 产品不建议由有肢体、感官或精神能力缺陷或缺少使用经验和知识的人(包括
儿童)使用,除非有负责他们安全的人对他们进行与产品使用有关的监督或指
导。
- 请照看好儿童,本产品不能用于玩耍。
- 将产品及其线缆放在儿童接触不到的地方。
- 清洁或维护产品之前,必须先从插座拔掉插头。
- 如果在一段时期内不使用本产品,请拔下适配器插头。
- 切勿让电动刷在其它产品的电源线或其它线缆上移动,否则可能会引发危险。
- 确保宽松的衣服、毛发和身体部位远离电动刷。
- 产品运行时,切勿覆盖或堵塞通风口。
- 为防止受损,请在集尘桶中放置过滤网后再使用本产品。
- 为防止受损,切勿将香精油或类似物质放入水箱中,也不要用产品清扫它们。
- 组装水箱及水箱已满时,请勿提起或倾斜吸嘴,否则水可能会从水箱中喷出。
- 运行时,切勿堵塞产品的进风口。
- 切勿将产品存放在温度超过 40°C 或低于 5°C 的环境中。
- 切勿在温度超过 40°C 的房间中使用产品。
- 切勿焚烧、拆卸产品或者将其暴露在温度超过 60°C 的环境中。 如果过热,
充电电池可能会爆炸。
- 只有具备资格的服务工程师才能更换充电电池。 当充电电池无法继续充电或耗
电很快时,请将产品送往授权的飞利浦服务中心,以更换电池。
- 根据设计,本吸尘器仅限于家用。 切勿使用本吸尘器清理建筑垃圾、水泥灰、
灰尘、细沙、石灰和类似的物质。 切勿在没有任何滤网的情况下使用本吸尘
器。 这会损坏马达并缩短吸尘器的使用寿命。 务必按照用户手册中的说明清
洁吸尘器的所有部件。 请勿使用水和/或清洁剂清洁任何部件(如果用户手册
中未特别说明)。

Manual

View the manual for the Philips FC6908 here, for free. This manual comes under the category vacuum cleaners and has been rated by 1 people with an average of a 7.7. This manual is available in the following languages: English. Do you have a question about the Philips FC6908 or do you need help? Ask your question here

Need help?

Do you have a question about the Philips and is the answer not in the manual?

  • Receive updates on solutions
  • Get answers to your question

Question and answer

Number of questions: 0

Philips FC6908 specifications

Below you will find the product specifications and the manual specifications of the Philips FC6908.

General
BrandPhilips
ModelFC6908 | FC6908/82
Productvacuum cleaner
EAN0692341075850, 6923410758504, 6973869391722
LanguageEnglish
FiletypeUser manual (PDF), Product Brochure (PDF)
Performance
Noise level84 dB
Maximum airflow1000 l/s
Noise level84 dB
Surface coverage per tank60 m²
Noise level84 dB
Airflow1000 l/min
Cleaning typeDry
Dirt separating methodAqua filtering
Vacuum air filtering-
Airflow1000 l/s
Surface coverage per tank60 m²
Weight & dimensions
Weight2732 g
Weight2732 g
Weight2732 g
Power
Runtime75 min
Charging time5 h
Battery voltage25.2 V
Runtime75 min
Charging time5 h
Battery voltage25.2 V
Runtime75 min
Charging time5 h
Battery voltage25.2 V
Battery technologyLithium-Ion (Li-Ion)
Power sourceBattery
Runtime with motorized brush (medium speed)75 min
Runtime with motorized brush (high speed)25 min
Design
Dust capacity0.6 L
Dust capacity0.6 L
Clean water tank capacity0.28 L
Dust container typeBagless
Dirt capacity dry0.6 L
Product colorBlack, Blue
Liquid tank capacity0.28 L
Technical details
Clean water tank capacity0.28 L
Runtime (turbo mode)25 min
Other features
Surface coverage per tank60 m²
Dust capacity0.6 L
Ergonomics
Washable filterYes
Packaging content
Vacuum brushes includedTurbo brush
Vacuum wand assembly-
show more

Frequently Asked Questions

Can't find the answer to your question in the manual? You may find the answer to your question in the FAQs about the Philips FC6908 below.

My Philips vacuum is losing suction. Why is that?

Your Philips vacuum cleaner losing suction power can be due to the following causes: - The suction power is not set to maximum - The dust container or dust bag is full - The hose, brush or tube is clogged

How often should I check the filter?

A clean filter is important to maintain the vacuum cleaner's suction power. Therefore, check the filter regularly. When a filter is clogged, dust absorption decreases and energy consumption increases.

What do I do with a smelly vacuum cleaner?

A commonly used method is to put a little washing powder in the dust container or the dust bag.

How often should I vacuum my house?

For allergy sufferers, vacuuming the house at least twice a week is recommended.

What is the weight of the Philips FC6908?

The Philips FC6908 has a weight of 2732 g.

Is the manual of the Philips FC6908 available in English?

Yes, the manual of the Philips FC6908 is available in English .

Is your question not listed? Ask your question here

No results