Philips 50PFL5704 manual

Philips 50PFL5704
7.4 · 1
PDF manual
 · 79 pages
English
manualPhilips 50PFL5704

Connecting antenna or cable / satellite /

IPTV set-top box

Be sure your antenna or another device is connected properly before
plugging in the AC power cord.

If connecting to an antenna through an RF cable

Any DTV programs that are broadcast in your area can be received for
free through an antenna connection.
Cable
RF cable
Antenna
IN
OUT

If connecting cable / satellite / IPTV set-top box using an RF

cable

If the TV is connected to a cable / satellite set-top box via a coaxial
connection, set the TV to channel 3/4 or the channel specified by the
service provider.
RF cable
RF cable
Antenna
Set-top box
IN
IN
OUT

If connecting cable / satellite / IPTV set-top box using an

HDMI cable

If the TV is connected to a cable / satellite set-top box via an HDMI
cable, make sure you select the correct source by using w (SOURCE).
RF cable
HDMI cable
Set-top box
IN
IN
OUT

Connecting a cable / satellite / IPTV set-top box, Blu-

ray Disc™ / DVD recorder via composite connectors

and analog audio

Do not place your recorder too close to the screen because some
recorders can be susceptible to harmful interference from the TV.
Cable
Cable
RF cable
RF cable
Video + Audio (L/R)
cables
Video +
Audio (L/R)
cables
Set-top box
Satellite
Blu-ray Disc™ /
DVD recorder
IN
IN
IN
IN
IN
OUT
OUT
OUT
Note(s)
If you have any question about the DTV’s antenna, visit
www.antennaweb.org for further information.
Depending on your antenna system, you may need different types of
combiners (mixers) or separators (splitters) for HDTV signal. The minimum
RF bandpass on these devices is 2,000 MHz or 2 GHz.
For your safety and to avoid damage to this unit, please unplug the RF
coaxial cable from the antenna input jack before moving the unit.
If you did use an antenna to receive analog TV, it should also work for DTV
reception. Outdoor or attic antennas will be more effective than a set-top
box or inside antenna.
To turn on your reception source easily between antenna and cable, install
an antenna selector.
If you are not receiving a signal from your cable service, contact the cable
provider.

Plugging in the AC power cord

Make sure that the AC power cord must be plugged to an AC outlet
after all the necessary connections are made.
Caution(s)
Connect the analog audio signal cables from the external device to the
analog audio L/R input jacks.
If you have an amplifier, connect the HDMI cable to the HDMI input via your
amplifier.
Note(s)
Each time you plug in the AC power cord, no operations will be performed
for several seconds. This is not a malfunction.

13 .English

Continued on next page.

Manual

View the manual for the Philips 50PFL5704 here, for free. This manual comes under the category televisions and has been rated by 1 people with an average of a 7.4. This manual is available in the following languages: English. Do you have a question about the Philips 50PFL5704 or do you need help? Ask your question here

Index

Need help?

Do you have a question about the Philips and is the answer not in the manual?

  • Receive updates on solutions
  • Get answers to your question

Question and answer

Number of questions: 0

Philips 50PFL5704 specifications

Below you will find the product specifications and the manual specifications of the Philips 50PFL5704.

General
BrandPhilips
Model50PFL5704 | 50PFL5704/F7
Producttelevision
EAN0609585252165
LanguageEnglish
FiletypeUser manual (PDF)
Display
Display diagonal49.5 "
Display resolution3840 x 2160 pixels
Response time9.5 ms
Supported video modes480i, 480p, 720p, 1080i, 1080p, 2160p
Display diagonal (metric)127 cm
HD type4K Ultra HD
Display technologyLED
Screen shapeFlat
Display brightness- cd/m²
Motion interpolation technology-
Contrast ratio (typical)5000:1
Viewing angle, vertical178 °
Viewing angle, horizontal178 °
Screen format adjustments4:3, 16:9
Native aspect ratio16:9
Audio
RMS rated power10 W
Number of speakers2
Power
Power consumption (standby)0.5 W
Power consumption (typical)130 W
AC input voltage120 V
AC input frequency60 Hz
Design
Panel mounting interface300 x 300 mm
Product colorBlack
On/off switch-
VESA mountingYes
Network
Bluetooth version4.2
Wi-FiYes
Ethernet LANYes
Wi-Fi standardsWi-Fi 5 (802.11ac)
BluetoothYes
Other features
3DNo
Built-in speaker(s)Yes
TV tuner
Tuner typeAnalog
Analog signal format systemNTSC
Digital signal format systemNot supported
Smart TV
Smart TVYes
Internet TVYes
Operating system installedAndroid
Performance
Teletext functionNo
High Dynamic Range (HDR) supportedNo
Ports & interfaces
HDMI ports quantity3
PC in (D-Sub)No
DVI portNo
DVI-D ports quantity0
Ethernet LAN (RJ-45) ports1
USB 2.0 ports quantity1
USB 3.2 Gen 1 (3.1 Gen 1) Type-A ports quantity0
Composite video in0
Component video (YPbPr/YCbCr) in0
Audio (L/R) in1
Headphone outputs1
Common interface (CI)No
Common interface Plus (CI+)No
S-Video inputs quantity0
Operational conditions
Operating temperature (T-T)5 - 40 °C
Weight & dimensions
Width (without stand)1135 mm
Depth (without stand)78.7 mm
Height (without stand)660.4 mm
Weight (without stand)9298 g
Width (with stand)1135 mm
Height (with stand)685.8 mm
Depth (with stand)223.5 mm
show more

Frequently Asked Questions

Can't find the answer to your question in the manual? You may find the answer to your question in the FAQs about the Philips 50PFL5704 below.

What's the best viewing distance for my Philips television?

The ideal viewing distance for your Philips television depends on the screen size. As a rule of thumb you can assume that approximately 2.4 times the screen diagonal is the ideal viewing distance.

My television has no signal anymore, now what?

If your television has no signal, you can check the following: - Check whether your television is set to the correct source. - Check if your TV receiver is properly connected via the HDMI or SCART input.

What screen dimensions does my television have?

The size of your television is usually expressed in inches, 1 inch is 2.54 centimetres. The size is the diagonal size of your television, so you measure the screen from bottom left to top right.

What is HDMI?

HDMI stands for High-Definition Multimedia Interface. An HDMI cable is used to transport audio and video signals between devices.

Can bluetooth devices of different brands be connected to each other?

Yes, bluetooth is a universal method that allows different devices equipped with bluetooth to connect to each other.

What is the screen size of the Philips 50PFL5704?

The screen size of the Philips 50PFL5704 is 49.5 ".

What is the screen resolution of the display of the Philips 50PFL5704?

The screen resolution of the Philips 50PFL5704 is 3840 x 2160 pixels.

Is the manual of the Philips 50PFL5704 available in English?

Yes, the manual of the Philips 50PFL5704 is available in English .

Is your question not listed? Ask your question here

No results