View the manual for the Parkside PBK 4 B3 here, for free. This manual comes under the category not categorized and has been rated by 4 people with an average of a 9. This manual is available in the following languages: English. Do you have a question about the Parkside PBK 4 B3 or do you need help? Ask your question here
Parkside | |
PBK 4 B3 | |
not categorized | |
4052916007723 | |
English | |
User manual (PDF) |
Can't find the answer to your question in the manual? You may find the answer to your question in the FAQs about the Parkside PBK 4 B3 below.
Ensure that the battery is fully charged and properly inserted into the device. Check if the safety switch is engaged and make sure the power switch is turned on.
Use the speed control dial located on the handle of the device. Rotate it clockwise to increase the speed and counterclockwise to decrease the speed.
Make sure the cutting blade is sharp and properly installed. Clean any debris or residue that may have accumulated on the blade or in the cutting area. Adjust the cutting depth if necessary.
Loosen the locking lever located near the blade guard, then adjust the cutting angle to your desired position. Tighten the locking lever securely to fix the angle.
Check if the blade is installed securely. Excessive vibration can indicate a loose blade. Additionally, ensure that the workpiece is firmly secured and that the blade is not damaged or dull. If the issue persists, contact customer support for further assistance.
Yes, the manual of the Parkside PBK 4 B3 is available in English .
Is your question not listed? Ask your question here
No results
Need help?
Do you have a question about the Parkside and the answer is not in the manual? Ask your question here. Provide a clear and comprehensive description of the problem and your question. The better your problem and question is described, the easier it is for other Parkside owners to provide you with a good answer.
Bu aletin fiyatı ne kadar
Helo!How to order spare ignition coile for PBK 4 B3Also spare scythe attachment.Thank you
Number of questions: 2