Panasonic PT-MZ770EJ manual

Panasonic PT-MZ770EJ
8.9 · 1
PDF manual
 · 233 pages
English
manualPanasonic PT-MZ770EJ

Chapter 3Basic Operations — Switching on/off the projector

ENGLISH - 59

1) Confirm that the <MAIN POWER> switch at the rear of the projector is set to <OFF> side, and remove

the power plug from the outlet.

2) Remove the power cord connector from the <AC IN> terminal of the projector while pressing the side

tabs.

Attention

f Do not pull out the connector with its left and right tabs engaged with the lugs of <AC IN> terminal. If you pull it out while the tabs are
engaged with the lugs, the tip of the tabs may be damaged. If the tabs are damaged, stop using the projector and consult your dealer for
repair of the power cord.

Power indicator

Indicate the status of the power. Check the status of the power indicator <ON (G)/STANDBY (R)> before operating

the projector.

Power indicator <ON (G)/STANDBY (R)>
Indicator status Projector status
Off The main power is switched off.
Red
Lit
The power is switched off. (standby mode)
Projection will start when the power <v/b> button is pressed.
f The setting of the projector is as follows.
g The [PROJECTOR SETUP] menu [ECO MANAGEMENT] [QUICK STARTUP]
is set to [OFF]
g The [PROJECTOR SETUP] menu [AUDIO SETTING] [IN STANDBY MODE] is
set to [OFF]
f The projector may not operate when the light source indicator <LIGHT> or the
temperature indicator <TEMP> is blinking. (x page 198)
Blinking
The power is switched off. (standby mode)
Projection will start when the power <v/b> button is pressed.
f The projector is set to one of the following. Power consumption is high.
g The [PROJECTOR SETUP] menu [ECO MANAGEMENT] [QUICK STARTUP]
is set to [ON]
g The [PROJECTOR SETUP] menu [AUDIO SETTING] [IN STANDBY MODE] is
set to [ON]
f The indicator will change to a red light when the specied time has elapsed after the
projector enters the standby mode if the projector is set as following.
The specied time is a time set in the [PROJECTOR SETUP] menu [ECO
MANAGEMENT] [QUICK STARTUP] [VALID PERIOD].
g The [PROJECTOR SETUP] menu [ECO MANAGEMENT] [QUICK STARTUP]
is set to [ON]
g The [PROJECTOR SETUP] menu [AUDIO SETTING] [IN STANDBY MODE] is
set to [OFF]
f The projector may not operate when the light source indicator <LIGHT> or the
temperature indicator <TEMP> is blinking. (x page 198)
Green Lit Projecting.
Orange Lit
The projector is preparing to switch off the projector.
The power is switched off after a while. (Changes to the standby mode.)
Note
f While the power indicator <ON (G)/STANDBY (R)> lights in orange, the fan is running to cool the projector.
f For approximately ve seconds after the projector is turned off, the indicator does not light up even if the power is turned on. Turn on the
power again after the power indicator <ON (G)/STANDBY (R)> lights/blinks in red.

Manual

View the manual for the Panasonic PT-MZ770EJ here, for free. This manual comes under the category video projectors and has been rated by 1 people with an average of a 8.9. This manual is available in the following languages: English. Do you have a question about the Panasonic PT-MZ770EJ or do you need help? Ask your question here

Index

Need help?

Do you have a question about the Panasonic and is the answer not in the manual?

  • Receive updates on solutions
  • Get answers to your question

Question and answer

Number of questions: 0

Panasonic PT-MZ770EJ specifications

Below you will find the product specifications and the manual specifications of the Panasonic PT-MZ770EJ.

General
BrandPanasonic
ModelPT-MZ770EJ | PT-MZ770EJ
Productvideo projector
LanguageEnglish
FiletypeUser manual (PDF)
Projector
Projector native resolutionWUXGA (1920x1200)
Projector brightness8000 ANSI lumens
Projection technologyLCD
Contrast ratio (typical)-
Native aspect ratio16:10
Screen size compatibility40 - 400 "
Projection distance1.02 - 10.16 m
Contrast ratio (dynamic)3000000:1
Keystone correction, horizontal-35 - 35 °
Keystone correction, vertical-35 - 35 °
Multimedia
Built-in speaker(s)Yes
RMS rated power10 W
Light source
Service life of light source- h
Design
Product typeLarge venue projector
Product colorWhite
Housing materialABS, Plastic
Market positioning-
PlacementDesktop
Lens system
Focal length range26.8 - 45.5 mm
Aperture range (F-F)1.7 - 2.3
Throw ratio1.6 - 2.8:1
Display
Built-in display-
Power
Power sourceAC
Power consumption (standby)- W
AC input frequency50 - 60 Hz
AC input voltage100 - 240 V
Video
Analog signal format system-
Full HDYes
3DNo
Ports & interfaces
VGA (D-Sub) ports quantity4
HDMI ports quantity2
Composite video in0
Component video (YPbPr/YCbCr) in0
DVI portNo
USB 2.0 ports quantity1
Audio (L/R) in2
Audio (L/R) out1
S-Video inputs quantity-
BNC input ports5
DC-in jackYes
Network
Ethernet LAN (RJ-45) ports2
Smart TVNo
Ethernet LANYes
Wi-FiNo
Operational conditions
Operating temperature (T-T)0 - 45 °C
Operating relative humidity (H-H)20 - 80 %
Other features
RS-232 ports-
Weight & dimensions
Weight17100 g
Width560 mm
Depth443 mm
Height205 mm
Packaging content
Handheld remote control-
Storage
Card reader integrated-
Features
Noise level35 dB
show more

Frequently Asked Questions

Can't find the answer to your question in the manual? You may find the answer to your question in the FAQs about the Panasonic PT-MZ770EJ below.

What is the weight of the Panasonic PT-MZ770EJ?

The Panasonic PT-MZ770EJ has a weight of 17100 g.

What is the height of the Panasonic PT-MZ770EJ?

The Panasonic PT-MZ770EJ has a height of 205 mm.

What is the width of the Panasonic PT-MZ770EJ?

The Panasonic PT-MZ770EJ has a width of 560 mm.

What is the depth of the Panasonic PT-MZ770EJ?

The Panasonic PT-MZ770EJ has a depth of 443 mm.

Is the manual of the Panasonic PT-MZ770EJ available in English?

Yes, the manual of the Panasonic PT-MZ770EJ is available in English .

Is your question not listed? Ask your question here

No results