4) Enter a security password and press the <ENTER> button.
fThe [DATA CLONING] screen is displayed.
5) Press as to select [USB MEMORY].
6) Press the <ENTER> button.
fThe [SELECT COPY TYPE] screen is displayed.
7) Press as to select [USB MEMORY -> PROJECTOR].
8) Press the <ENTER> button.
fThe conrmation screen is displayed.
9) Press qw to select [OK], and press the <ENTER> button.
fThe projector automatically enters standby state and starts copying data from the USB memory to the
projector.
10) Once the copying of the data is completed, disconnect the USB memory from the <VIEWER/PAIRING>
terminal.
11) Turn on the power of the copy destination projector.
fThe copied content is reected on the projector.
Note
fThe security password is the password set in the [SECURITY] menu → [SECURITY PASSWORD CHANGE].
Initial password as the factory default: awsqawsq
fWhile data is being copied, the light source indicator <LIGHT>, the temperature indicator <TEMP>, and the lter indicator <FILTER> of the
destination projector will blink. Make sure that the indicators stop blinking before powering on the projector.
[SAVE ALL USER DATA]
Save the various setting values as a backup in the built-in memory of the projector.
1) Press as to select [SAVE ALL USER DATA].
2) Press the <ENTER> button.
fThe [SECURITY PASSWORD] screen is displayed.
3) Enter a security password and press the <ENTER> button.
4) When the confirmation screen is displayed, press qw to select [OK], and press the <ENTER> button.
f[PROGRESS] is displayed while saving data.
Note
fThe security password is the password set in the [SECURITY] menu → [SECURITY PASSWORD CHANGE].
Initial password as the factory default: awsqawsq
fData set from the computer application is not included in [ALL USER DATA].
[LOAD ALL USER DATA]
Load the various setting values saved as a backup in the built-in memory of the projector.
1) Press as to select [LOAD ALL USER DATA].
2) Press the <ENTER> button.
fThe [SECURITY PASSWORD] screen is displayed.
3) Enter a security password and press the <ENTER> button.
4) When the confirmation screen is displayed, press qw to select [OK], and press the <ENTER> button.
Note
fThe security password is the password set in the [SECURITY] menu → [SECURITY PASSWORD CHANGE].
Initial password as the factory default: awsqawsq
fThe projector enters the standby mode to reect the setting values when [LOAD ALL USER DATA] is executed.
fData registered from a computer is not included in [ALL USER DATA].
Manual
View the manual for the Panasonic PT-MZ770EJ here, for free. This manual comes under the category video projectors and has been rated by 1 people with an average of a 8.9. This manual is available in the following languages: English. Do you have a question about the Panasonic PT-MZ770EJ or do you need help? Ask your question here
Need help?
Do you have a question about the Panasonic and is the answer not in the manual?
Question and answer
Number of questions: 0