Set [ECO MANAGEMENT] to reduce the power consumption and enhance the life of the light source.
Setting [LIGHT POWER]
1) Press as to select [ECO MANAGEMENT].
2) Press the <ENTER> button.
f The [ECO MANAGEMENT] screen is displayed.
3) Press as to select [LIGHT POWER].
4) Press qw to switch the item.
f The items will switch each time you press the button.
[NORMAL]
Select this item when high luminance is required. The light power is 100 % and the estimated runtime
is approximately 20 000 hours
*1
.
[ECO]
The luminance will decrease compared to [NORMAL], but select this item to suppress the reduction in
luminance against the runtime of the light source. The light power is 70 % and the estimated runtime
is approximately 24 000 hours
*1
.
[QUIET]
Select this item to prioritize the operation with low noise. The light power is 70 % and the estimated
runtime is approximately 20 000 hours
*1
.
[USER]Select the item to set the picture brightness as desired.
*1 The runtime is an estimation when the [PICTURE] menu → [DYNAMIC CONTRAST] is set to [2].
fProceed to Step 5) when [USER] is selected.
5) Press as to select [LIGHT OUTPUT].
6) Press qw to adjust.
Operation
Adjustment
Range of adjustment
BrightnessRuntime (estimate)
Press w.
The screen becomes brighter.The runtime becomes shorter.
30 %
*1
- 100 %
Press q.
The screen becomes darker.The runtime becomes longer.
*1 It should be noted that the picture quality tends to deteriorate as the light output decreases.
Note
fUnder inuences of characteristics of each light source, conditions of use, installation environment, etc., the runtime may be shorter than the
estimation.
fRuntime is a time until the luminance of the light source to become about half when using the projector continuously. The runtime is just an
estimate, and is not the warranty period.
fIf the runtime exceeds 10 000 hours, replacement of the components inside the projector may be required. Consult your dealer for details.
fWhen anything other than [NORMAL] is set, the setting in the [PROJECTOR SETUP] menu → [LightID] is disabled, and this item is xed to
[OFF].
Setting [AMBIENT LIGHT DETECTION]
Sets if the [AMBIENT LIGHT DETECTION] function to adjust the light power depending on the brightness of the
installed location is enabled or not.
1) Press as to select [ECO MANAGEMENT].
2) Press the <ENTER> button.
f The [ECO MANAGEMENT] screen is displayed.
3) Press as to select [AMBIENT LIGHT DETECTION].
4) Press qw to switch the item.
f The items will switch each time you press the button.
[OFF]
Disables the ambient light detection function.
[ON]
Enables the ambient light detection function.
Manual
View the manual for the Panasonic PT-MZ770EJ here, for free. This manual comes under the category video projectors and has been rated by 1 people with an average of a 8.9. This manual is available in the following languages: English. Do you have a question about the Panasonic PT-MZ770EJ or do you need help? Ask your question here
Need help?
Do you have a question about the Panasonic and is the answer not in the manual?
Question and answer
Number of questions: 0