Switching the input by displaying the input selection screen
The input for projection can be selected by displaying the input selection screen using the <INPUT SELECT>
button on the control panel.
1) Press the <INPUT SELECT> button on the control panel.
fThe input selection screen is displayed.
INPUT SELECT
RGB1
RGB2
VIDEO
HDMI1
HDMI2
DIGITAL LINK
MEMORY VIEWER
Panasonic APPLICATION
MIRRORING
SELECT
SET
ENTER
2) Press as to select the input for projection, and press the <ENTER> button.
Note
f[MIRRORING] is displayed when the optional Wireless Module (Model No.: ET-WM300) is attached.
fThe input can also be switched by pressing the <INPUT SELECT> button while the input selection screen is displayed.
The input will switch each time you press the <INPUT SELECT> button.
fIf the optional DIGITAL LINK output supported device (Model No.: ET-YFB100G, ET-YFB200G) is connected to the projector, the input
selection menu for the DIGITAL LINK output supported device is displayed when the <ENTER> button is pressed while the DIGITAL LINK
input is selected in the input selection screen.
fIf the optional DIGITAL LINK output supported device (Model No.: ET-YFB100G, ET-YFB200G) is connected to the projector, the DIGITAL
LINK logo and the input name selected in the DIGITAL LINK output supported device are displayed in the display section of the [DIGITAL
LINK] in the input selection screen.
Adjusting the focus, zoom, and lens shift
Adjust the focus, zoom, and lens shift if the image projected to the screen or its position is shifted even if the
projector and the screen are set up in the correct positions.
Using the control panel
1) Press the <LENS/CANCEL> button on the control panel.
fPressing the button changes the adjustment screen in the order of [FOCUS], [ZOOM], and [SHIFT].
2) Select each adjustment item and press asqw to adjust.
Using the remote control
1) Press the lens buttons (<FOCUS>, <ZOOM>, <SHIFT>) on the remote control.
fPressing the <FOCUS> button: Adjusts the focus (adjustment of the lens focus position).
fPressing the <ZOOM> button: Adjusts the zoom (adjustment of the lens zoom position).
fPressing the <SHIFT> button: Adjusts the lens shift (vertical position and horizontal position of the lens).
2) Select each adjustment item and press asqw to adjust.
CAUTION
During the lens shift operation, do not insert your hand in the opening around the lens.
Your hand may get caught, resulting in an injury.
Note
fThe adjustment can be performed faster by holding down asqw for approximately three seconds or longer.
fIt is recommended that images be projected continuously for at least 30 minutes before the focus is adjusted.
Manual
View the manual for the Panasonic PT-MZ670LEJ here, for free. This manual comes under the category video projectors and has been rated by 1 people with an average of a 7.8. This manual is available in the following languages: English. Do you have a question about the Panasonic PT-MZ670LEJ or do you need help? Ask your question here
1024 x 768 (XGA),1280 x 1024 (SXGA),1280 x 720 (HD 720),1280 x 768 (WXGA),1280 x 800 (WXGA),1366 x 768,1400 x 1050 (SXGA+),1440 x 900 (WXGA+),1600 x 1200 (UXGA),1600 x 900,1680 x 1050 (WSXGA+),1920 x 1080 (HD 1080),1920 x 1200 (WUXGA)
Need help?
Do you have a question about the Panasonic and is the answer not in the manual?
Question and answer
Number of questions: 0