[INTERNAL]Enlarges the size within the aspect range set with [SCREEN FORMAT].
[FULL]Enlarges or reduces the size using the entire display area set with [SCREEN FORMAT].
5) Press as to select [INTERLOCKED].
6) Press qw to switch the item.
[OFF]Sets the [VERTICAL] and [HORIZONTAL] zoom ratio.
[ON]
Uses [BOTH] to set zoom ratio. Image can be enlarged or reduced vertically and horizontally at the
same magnication.
7) Press as to select [VERTICAL] or [HORIZONTAL].
f If [ON] is selected, select [BOTH].
8) Press qw to adjust.
Note
fWhen the [POSITION] menu → [ASPECT] is set to anything other than [NORMAL], [MODE] is not displayed.
f[ZOOM] cannot be adjusted when the input is MEMORY VIEWER, Panasonic APPLICATION, or MIRRORING.
[CLOCK PHASE]
You can adjust the image to achieve an optimal image when there is a ickering image or smeared outlines.
1) Press as to select [CLOCK PHASE].
2) Press qw or the <ENTER> button.
fThe [CLOCK PHASE] individual adjustment screen is displayed.
3) Press qw to adjust.
fAdjustment value will change between [0] and [+31]. Adjust the image so that the amount of interference is
at a minimum.
Note
fAdjustment may not be possible depending on the signal.
fThere may be no optimal value if the output from the input computer is unstable.
fThere may be no optimal value when the total dot number is shifted.
f[CLOCK PHASE] can be adjusted only when the YC
B
C
R
/YP
B
P
R
signal or the analogRGB signal is input to the <RGB 1 IN> terminal or the
<RGB 2 IN> terminal.
f[CLOCK PHASE] cannot be adjusted when a digital signal is input.
fThe adjustment value will change to [0] when w is pressed while it was at [+31]. Also, the adjustment value will change to [+31] when q is
pressed while it was at [0].
[REALTIME KEYSTONE]
The keystone distortion that occurs when the projector is installed tilted is adjusted automatically.
1) Press as to select [REALTIME KEYSTONE].
2) Press qw to select the item to adjust.
[OFF]The real-time keystone distortion correction function is not executed automatically.
[ON]The real-time keystone distortion correction function is executed automatically.
Note
fThe keystone distortion may not be corrected fully depending on the installation condition. In such case, adjust it with the [POSITION] menu
→ [SCREEN ADJUSTMENT].
f[REALTIME KEYSTONE] cannot be set in following cases.
gWhen the [PROJECTOR SETUP] menu → [PROJECTION METHOD] → [FLOOR/CEILING] is set to [CEILING]
Manual
View the manual for the Panasonic PT-MZ670EJ here, for free. This manual comes under the category video projectors and has been rated by 1 people with an average of a 7.5. This manual is available in the following languages: English. Do you have a question about the Panasonic PT-MZ670EJ or do you need help? Ask your question here
1024 x 768 (XGA),1280 x 1024 (SXGA),1280 x 720 (HD 720),1280 x 768 (WXGA),1280 x 800 (WXGA),1366 x 768,1400 x 1050 (SXGA+),1440 x 900 (WXGA+),1600 x 1200 (UXGA),1600 x 900,1680 x 1050 (WSXGA+),1920 x 1080 (HD 1080),1920 x 1200 (WUXGA)
Need help?
Do you have a question about the Panasonic and is the answer not in the manual?
Question and answer
Number of questions: 0