On the menu screen, select [PROJECTOR SETUP] from the main menu, and select an item from the sub‑
menu.
Refer to “Navigating through the menu” (x page 80) for the operation of the menu screen.
[PROJECTOR ID]
The projector has an ID number setting function that can be used when multiple projectors are used side by side
to enable simultaneous control or individual control via a single remote control.
1) Press as to select [PROJECTOR ID].
2) Press qw to switch the item.
fThe items will switch each time you press the button.
[ALL]Select this item when controlling projectors without specifying an ID number.
[1] - [64]Select this item when specifying an ID number to control individual projector.
Note
fTo specify an ID number for individual control, the ID number of a remote control must match the ID number of the projector.
fWhen the ID number is set to [ALL], the projector will operate regardless of the ID number specied during remote control or computer
control.
If multiple projectors are set up side by side with IDs set to [ALL], they cannot be controlled separately from the projectors with other ID
numbers.
fRefer to “Setting ID number of the remote control” (x page 77) for how to set the ID number on the remote control.
[PROJECTION METHOD]
Set the projection method in accordance with the installation status of the projector.
Change the [FRONT/REAR] setting when the screen display is inverted.
Change the [FLOOR/CEILING] setting when the screen display is upside down.
Setting [FRONT/REAR]
1) Press as to select [FRONT/REAR] of [PROJECTION METHOD].
2) Press qw to switch the item.
fThe items will switch each time you press the button.
[FRONT]Select this item when installing the projector in front of the screen.
[REAR]Select this item when installing behind the screen (using translucent screen).
Setting [FLOOR/CEILING]
1) Press as to select [FLOOR/CEILING] of [PROJECTION METHOD].
2) Press qw to switch the item.
fThe items will switch each time you press the button.
[AUTO]
Automatically detects the attitude of the projector by the built-in angle sensor.
Set [AUTO] normally.
[FLOOR]Select this item when installing the projector on a desk, etc.
[CEILING]
Select this item when installing the projector using the Ceiling Mount Bracket (optional).
Projected image is inverted upside down.
Note
fFor the range of installation attitude detected by the built-in angle sensor, refer to “Angle sensor” (x page 37).
Manual
View the manual for the Panasonic PT-MZ670EJ here, for free. This manual comes under the category video projectors and has been rated by 1 people with an average of a 7.5. This manual is available in the following languages: English. Do you have a question about the Panasonic PT-MZ670EJ or do you need help? Ask your question here
1024 x 768 (XGA),1280 x 1024 (SXGA),1280 x 720 (HD 720),1280 x 768 (WXGA),1280 x 800 (WXGA),1366 x 768,1400 x 1050 (SXGA+),1440 x 900 (WXGA+),1600 x 1200 (UXGA),1600 x 900,1680 x 1050 (WSXGA+),1920 x 1080 (HD 1080),1920 x 1200 (WUXGA)
Need help?
Do you have a question about the Panasonic and is the answer not in the manual?
Question and answer
Number of questions: 0