Chapter 3Basic Operations — Switching on/off the projector
ENGLISH - 59
Power indicator
Indicate the status of the power. Check the status of the power indicator <ON (G)/STANDBY (R)> before operating
the projector.
Power indicator <ON (G)/STANDBY (R)>
Indicator statusProjector status
OffThe main power is switched off.
Red
Lit
The power is switched off. (standby mode)
Projection will start when the power <v/b> button is pressed.
fThe setting of the projector is as follows.
gThe [PROJECTOR SETUP] menu → [ECO MANAGEMENT] → [QUICK STARTUP]
is set to [OFF]
gThe [PROJECTOR SETUP] menu → [AUDIO SETTING] → [IN STANDBY MODE] is
set to [OFF]
fThe projector may not operate when the light source indicator <LIGHT> or the
temperature indicator <TEMP> is blinking. (x page 197)
Blinking
The power is switched off. (standby mode)
Projection will start when the power <v/b> button is pressed.
fThe projector is set to one of the following. Power consumption is high.
gThe [PROJECTOR SETUP] menu → [ECO MANAGEMENT] → [QUICK STARTUP]
is set to [ON]
gThe [PROJECTOR SETUP] menu → [AUDIO SETTING] → [IN STANDBY MODE] is
set to [ON]
fThe indicator will change to a red light when the specied time has elapsed after the
projector enters the standby mode if the projector is set as following.
The specied time is a time set in the [PROJECTOR SETUP] menu → [ECO
MANAGEMENT] → [QUICK STARTUP] → [VALID PERIOD].
gThe [PROJECTOR SETUP] menu → [ECO MANAGEMENT] → [QUICK STARTUP]
is set to [ON]
gThe [PROJECTOR SETUP] menu → [AUDIO SETTING] → [IN STANDBY MODE] is
set to [OFF]
fThe projector may not operate when the light source indicator <LIGHT> or the
temperature indicator <TEMP> is blinking. (x page 197)
GreenLitProjecting.
OrangeLit
The projector is preparing to switch off the projector.
The power is switched off after a while. (Changes to the standby mode.)
Note
fWhile the power indicator <ON (G)/STANDBY (R)> lights in orange, the fan is running to cool the projector.
fFor approximately ve seconds after the projector is turned off, the indicator does not light up even if the power is turned on. Turn on the
power again after the power indicator <ON (G)/STANDBY (R)> lights/blinks in red.
fThe projector consumes power even in standby mode (power indicator <ON (G)/STANDBY (R)> lights/blinks in red). Refer to “Power
consumption” (x page 220) for the power consumption.
fThe power indicator <ON (G)/STANDBY (R)> will blink if the projector receives a remote control signal.
fThe power indicator <ON (G)/STANDBY (R)> will blink slowly in green while the shutter function is in use (shutter: closed).
Manual
View the manual for the Panasonic PT-MW630EJ here, for free. This manual comes under the category video projectors and has been rated by 1 people with an average of a 9.4. This manual is available in the following languages: English. Do you have a question about the Panasonic PT-MW630EJ or do you need help? Ask your question here
1024 x 768 (XGA),1280 x 1024 (SXGA),1280 x 720 (HD 720),1280 x 768 (WXGA),1280 x 800 (WXGA),1366 x 768,1400 x 1050 (SXGA+),1440 x 900 (WXGA+),1600 x 1200 (UXGA),1600 x 900,1680 x 1050 (WSXGA+),1920 x 1080 (HD 1080),1920 x 1200 (WUXGA)
Need help?
Do you have a question about the Panasonic and is the answer not in the manual?
Question and answer
Number of questions: 0