The following commands are used for control of the projector with a computer.(Operation commands)
CommandControl contentsRemarks
PONPower on
The PON command is ignored during lamp ON control.
z
If a PON command is received while the cooling fan is operating after the lamp has switched
z
off, the lamp is not turned back on again straight away in order to protect the lamp.
POFPower off
AVLVolume
Parameter:
000 - 063 (Adjustment value 0 - 63)
IISInput
Parameter:
VID = VIDEO SVD = S-VIDEO RG1 = COMPUTER 1 IN
RG2 = COMPUTER 2 IN NWP = NETWORK (PT-LB90NTE only)
Q$S
Lamp condition
query
Call back:
0 = Standby 1 = Lamp on control active 2 = Lamp on 3 = Lamp off control active
OSHAV mute
Turning off the projection and sound temporarily.
Send the command to switch between off and on. (
Æ
page 26)
Do not send the command consecutively.
0 = Off 1 = On
Remarks
If
z
STANDBY MODE is set to ECO, only PON and Q$S command can be used in the standby mode.
LAN terminal
Name and function of LAN terminal
J
LINK lamp (Yellow) 10 Base-T/100 Base-TX light up when connected.ACT lamp (Green)Flashing when data are transmitted or received.
Note
Do not touch the LAN terminal or the metal part of the LAN cable.
z
Otherwise, the static electricity may discharge from our hand (body) and thus cause a malfunction.
MENU LOCK PASSWORD
To initialize your password, consult your distributor.Projector
NC11NC
PC
(DTE)
22
33
NC44NC
55
NC66NC
77
88
NC99NC
Manual
View the manual for the Panasonic PT-LB90E here, for free. This manual comes under the category video projectors and has been rated by 1 people with an average of a 5.5. This manual is available in the following languages: English. Do you have a question about the Panasonic PT-LB90E or do you need help? Ask your question here
Need help?
Do you have a question about the Panasonic and is the answer not in the manual?
Question and answer
Number of questions: 0