Panasonic PT-LB90E manual

Panasonic PT-LB90E
5.5 · 1
PDF manual
 · 60 pages
English
manualPanasonic PT-LB90E

Technical Information

E

NGLISH - 55

Appendix

Serial terminal

TheserialconnectorwhichisontheconnectorpaneloftheprojectorconformstotheRS-232Cinterfacespeci-
cations, so that the projector can be controlled by a personal computer which is connected to this connector.
Connection
J
Computer
D-Sub 9-pin (male)
Serial terminal (female)
Pin assignments and signal names
J
Pin No. Signal name Contents
NC
TXD Transmitted data
RXD Received data
NC
GND Earth
NC
RTS
Connected internally
CTS
NC
Communication settings
J
Signal level RS-232C Character length 8 bits
Sync.method Asynchronous Stop bit 1 bit
Baud rate 9 600 bps X parameter None
Parity None S parameter None
Basic format
J
STX Command : Parameter ETX
Start byte
(02 h)
1 byte
3 bytes 1 byte - 4 bytes
End
(03 h)
The data streaming from the computer will start with
STX, and proceed to Command, Parameter and end
with ETX.
You can add the required parameter.
Note
The projector can not receive any command for 10 seconds after the lamp is switched on. Wait for 10 seconds
z
before sending the command.
If sending multiple commands, check if a response has been received from the projector for one command
z
before sending the next command.
When a command which does not require parameters to be sent, the colon (:) is not required.
z
Remarks
If an incorrect command is sent from the personal computer, the ER401 command will be sent from the
z
projector to the personal computer.

Manual

View the manual for the Panasonic PT-LB90E here, for free. This manual comes under the category video projectors and has been rated by 1 people with an average of a 5.5. This manual is available in the following languages: English. Do you have a question about the Panasonic PT-LB90E or do you need help? Ask your question here

Index

Need help?

Do you have a question about the Panasonic and is the answer not in the manual?

  • Receive updates on solutions
  • Get answers to your question

Question and answer

Number of questions: 0

Panasonic PT-LB90E specifications

Below you will find the product specifications and the manual specifications of the Panasonic PT-LB90E.

General
BrandPanasonic
ModelPT-LB90E | PT-LB90E
Productvideo projector
EAN5025232544400, 5025232551514
LanguageEnglish
FiletypeUser manual (PDF)
Projector
Projector brightness3500 ANSI lumens
Projection technologyLCD
Projector native resolutionXGA (1024x768)
Contrast ratio (typical)500:1
Keystone correction, vertical±30 °
Vertical scan range50 - 85 Hz
Horizontal scan range15 - 91 kHz
Other features
Aspect ratio4:3
Lens focal range1.65 - 1.93
RS-232 ports1
Dimensions (WxDxH)368 x 233 x 88 mm
Power requirements100–240 V AC, 50/60 Hz
Light source
Lamp power220 W
Lamp typeUHM
Light source typeLamp
Lens system
Focal length range18.53 - 22.18 mm
Multimedia
Number of built-in speakers1
RMS rated power1 W
Ports & interfaces
S-Video inputs quantity1
Composite video in1
Audio (L/R) in1
Audio (L/R) out1
PC Audio inYes
VGA (D-Sub) ports quantity2
Serial interface typeRS-232
Weight & dimensions
Weight2960 g
Power
Power consumption (typical)300 W
Power consumption (standby)15 W
Operational conditions
Operating relative humidity (H-H)20 - 80 %
Operating temperature (T-T)0 - 40 °C
show more

Frequently Asked Questions

Can't find the answer to your question in the manual? You may find the answer to your question in the FAQs about the Panasonic PT-LB90E below.

What is the weight of the Panasonic PT-LB90E?

The Panasonic PT-LB90E has a weight of 2960 g.

Is the manual of the Panasonic PT-LB90E available in English?

Yes, the manual of the Panasonic PT-LB90E is available in English .

Is your question not listed? Ask your question here

No results