INITIALIZE ALL operation is activated, the initial
password is set as AAAA.
Change your password regularly. Do not use a
z
simple password that is too easy to guess.
To reset the password to the initial password, see
z
“MENU LOCK PASSWORD” (
Æ
page 56).
CONTROL DEVICE SETUP
You can enable/disable the button operations of the
control panel and remote control.
Change setting
Change setting
J
CONTROL PANEL
ENABLEEnable the button operations
DISABLE
Disable the button operations
REMOTE CONTROLLER
J
ENABLEEnable the button operations
DISABLEDisable the button operations
Remarks
If
z
DISABLEisset,theconrmationscreenappears.
Select OK and press the ENTER button.
If any button is pressed when
z
DISABLE is set, the
password screen appears.
Input the password which is set in the SECURITY
menu.
The
z
PASSWORD screen will be displayed for 10
seconds.
If you set both
z
CONTROL PANEL and REMOTE
CONTROLLER to DISABLE, all the button
operations of the control panel and remote control
are disabled and you cannot turn off the power.
In the standby mode, press and hold the
z
ENTER
button of the control panel and MENU button for at
least 2 seconds. The buttons on the control panel
are enabled.
You can also enable the button operation by
pressing and holding the ENTER button of the
control panel and MENU button for at least 2
seconds while the projector is projecting.
Manual
View the manual for the Panasonic PT-LB90E here, for free. This manual comes under the category video projectors and has been rated by 1 people with an average of a 5.5. This manual is available in the following languages: English. Do you have a question about the Panasonic PT-LB90E or do you need help? Ask your question here
Need help?
Do you have a question about the Panasonic and is the answer not in the manual?
Question and answer
Number of questions: 0