If no image signal is input for the time set with the
timer, the projector will enter into standby mode
automatically.
Change setting
Change setting
DISABLENO SIGNAL SHUT-OFF is disabled
15 - 60 MIN.
Timer can be set in intervals of 5
minutes
INITIAL START UP
You can set the starting method when the mains plug
is connected to mains socket.
Change setting
Change setting
LAST MEMORY
Projector starts from the last image
before the mains plug was
disconnected
STANDBY
Projector starts in the standby
mode
ONProjector starts immediately
INSTALLATION
When installing the projector, select the projection
method according to the projector position.
(
Æ
page 18)
Change setting
Change setting
FRONT/
DESK
Settingonadesk/oorand
projecting from front
FRONT/
CEILING
Mounting in the ceiling with a ceiling
mount bracket (sold separately) and
projecting from front
REAR/DESK
Settingonadesk/oorandprojecting
from rear (Translucent screen is
required)
REAR/CEILING
Mounting in the ceiling with a ceiling
mount bracket (sold separately) and
projecting from rear (Translucent
screen is required)
HIGH ALTITUDE MODE
If you use the projector at high elevation, the HIGH
ALTITUDE MODE setting need to be ON to set the
fan speed high.
Change setting
Change setting
OFFFor use in normal environment
ONFor use at high altitude
Remarks
At 1 400 -2 700 m (4 593 - 8 858 ft) sea level, the
z
setting must be ON.
The loudness of fan noise depends on the
z
HIGH
ALTITUDE MODE setting.
Manual
View the manual for the Panasonic PT-LB90E here, for free. This manual comes under the category video projectors and has been rated by 1 people with an average of a 5.5. This manual is available in the following languages: English. Do you have a question about the Panasonic PT-LB90E or do you need help? Ask your question here
Need help?
Do you have a question about the Panasonic and is the answer not in the manual?
Question and answer
Number of questions: 0