Panasonic PT-DZ6710E manual

Panasonic PT-DZ6710E
8.2 · 1
PDF manual
 · 42 pages
English
manualPanasonic PT-DZ6710E

ENGLISH - 30

Maintenance

Replacement

Before replacing the Lamp unit
Turn off the POWER switch of the projector in proper way and disconnect the mains plug from the mains socket.
Wait for more than 1 hour and make sure the lamp unit and the surroundings are cooled enough.
Prepare a Phillips-head screwdriver.
Contact the dealer to purchase a replacement lamp unit (ET-LAD60:1 bulb unit, ET-LAD60W: 2 bulb units).
When the projector is mounted on the ceiling, do not work directly under the projector or put your face
closer to the projector.
When to replace the lamp unit
The lamp unit is consumable and the brightness decreases by duration of usage. The LAMP1/LAMP2
indicators will inform you of the replacement timing at 1 800
*2
hours, and at 2 000
*1
hours, the projector will be
turned off. Those figures are rough guidance and might be shortened by the usage conditions, characteristics
of the lamp unit, environmental conditions, and so on. You can check the duration of usage time using LAMP1
/
LAMP2 of STATUS in the PROJECTOR SETUP menu.
*1. 3 000 hours for PT-D5000E.
*2. 2 800 hours for PT-D5000E.

Replacing the Lamp unit

CAUTION:
The lamp may explode by shocks or chipping damage.
NOTE:
Prior to replacing the lamp unit, allow it to cool down to prevent the risk of burns, damage and other hazards.
Do not attempt replacement with an unauthorised lamp unit.
Both lamps must be set in a lamp unit. If only one lamp is set, the power will not work.
IndicationOn screenLAMP indicatorOver 1 800
*2
hoursREPLACE LAMP” is displayed on the upper left of the screen for 30 seconds. Press any button to clear the screen, or disappears after 30 seconds.Lights in redOver 2 000
*1
hoursREPLACE LAMP” is displayed on the upper left of the screen, and it will stay until you respond.To clear the screen, press any button.CAUTION:
If you keep using the lamp unit after 2 000
*1
hours, it cause the damage of the projector. Automatically the projector will be powered off
after 10 minutes.
NOTE:
The guide times, 1 800
*2
and 2 000
*1
hours, are rough estimates based on certain conditions and are not a guaranteed time.
For more information about the lamp unit, see the instructions which is provided with the lamp unit.
REPLACE LAMP
LAMPLAMP

Manual

View the manual for the Panasonic PT-DZ6710E here, for free. This manual comes under the category video projectors and has been rated by 1 people with an average of a 8.2. This manual is available in the following languages: English. Do you have a question about the Panasonic PT-DZ6710E or do you need help? Ask your question here

Need help?

Do you have a question about the Panasonic and is the answer not in the manual?

  • Receive updates on solutions
  • Get answers to your question

Question and answer

Number of questions: 0

Panasonic PT-DZ6710E specifications

Below you will find the product specifications and the manual specifications of the Panasonic PT-DZ6710E.

General
BrandPanasonic
ModelPT-DZ6710E | PT-DZ6710E
Productvideo projector
EAN5025232492282, 5052179605420
LanguageEnglish
FiletypeUser manual (PDF)
Projector
Projector brightness6000 ANSI lumens
Projection technologyDLP
Projector native resolutionWUXGA (1920x1200)
Contrast ratio (typical)2000:1
Uniformity90 %
Vertical scan range50 - 85 Hz
Horizontal scan range15 - 91 kHz
Screen size compatibility50 - 600 "
Projection distance- m
Other features
Aspect ratio16:10
RS-232 ports1
Dimensions (WxDxH)498 x 440 x 175 mm
Non-operating relative humidity (non-condensing)20 - 80 %
Connectivity technologyWired
Power requirements220 – 240 V AC 50/60 Hz
Video inBNC
Light source
Lamp power300 W
Lamp typeUHM
Service life of light source- h
Light source typeLamp
Features
Dot clock scanning frequency162 MHz
Noise level- dB
Video
Full HDYes
Analog signal format systemNTSC, PAL, SECAM
3D-
Ports & interfaces
VGA (D-Sub) ports quantity2
S-Video inputs quantity1
Component video (YPbPr/YCbCr) in2
DVI portYes
Composite video in-
Audio (L/R) in-
USB 2.0 ports quantity-
HDMI ports quantity-
Serial interface typeRS-232
Network
Ethernet LAN (RJ-45) ports1
Ethernet LANYes
Wi-Fi-
Weight & dimensions
Weight16000 g
Power
Power consumption (typical)800 W
Power consumption (standby)9 W
Operational conditions
Operating temperature (T-T)0 - 45 °C
Packaging content
Handheld remote controlYes
Lens system
Zoom ratio-
Focal length range- mm
Multimedia
Built-in speaker(s)-
Design
Product colorBlack
PlacementCeiling
show more

Frequently Asked Questions

Can't find the answer to your question in the manual? You may find the answer to your question in the FAQs about the Panasonic PT-DZ6710E below.

What is the weight of the Panasonic PT-DZ6710E?

The Panasonic PT-DZ6710E has a weight of 16000 g.

Is the manual of the Panasonic PT-DZ6710E available in English?

Yes, the manual of the Panasonic PT-DZ6710E is available in English .

Is your question not listed? Ask your question here

No results