the installation of the projector. If the picture is shown
upside down or in reverse, change the projection
scheme.
Select the setting by displaying the on-screen •
indications using buttons of the remote control or
the control panel on the main unit.
Press ▲▼ to select 1.
“INSTALLATION”.
PROJECTOR ID
INSTALLATION
ALTITUDE MODE
ALL
FRONT-FLOOR
ON
Press ◄► to switch 2.
“INSTALLATION”.
The setting will change as follows each time •
◄► is pressed.
REAR-FLOOR
FRONT-CELING
REAR-CELING
FRONT-FLOOR
Floor mount front projection (FRONT-FLOOR)
Ceiling mount front projection (FRONT-CEILING)
Floor mount rear projection (REAR-FLOOR)
Ceiling mount rear projection (REAR-CEILING)
Press MENU twice.3.
The on-screen indications disappear and the •
normal screen appears again.
Altitude Mode
When using the projector over 1 400 m above sea
level, set to “ON”.
Press ▲▼ to select “ALTITUDE 1.
MODE”.
INSTALLATION
ALTITUDE MODE
DIRECTION
FRONT-FLOOR
ON
HORIZONTAL
Press ◄► to switch “ALTITUDE 2.
MODE”.
The setting will change as follows each time •
◄► is pressed.
OFFON
Direction
The fan is controlled in accordance with the setup
angle.
Press ▲▼ to select 1.
“DIRECTION”.
ALTITUDE MODE
DIRECTION
LAMP SELECT
ON
HORIZONTAL
QUAD
Press ◄► to switch 2.
“DIRECTION”.
The setting will change as follows each time •
◄► is pressed.
HORIZONTALVERTICAL
HORIZONTAL:•
This is the standard setup.
VERTICAL:•
Select this if the projector is tilted at a large vertical
angle (an angle which exceeds 30° from the
horizontal).
Manual
View the manual for the Panasonic PT-DZ12000E here, for free. This manual comes under the category video projectors and has been rated by 1 people with an average of a 5.5. This manual is available in the following languages: English. Do you have a question about the Panasonic PT-DZ12000E or do you need help? Ask your question here
Need help?
Do you have a question about the Panasonic and is the answer not in the manual?
Question and answer
Number of questions: 0