This is for performing geometry correction from a PC.
Select “KEYSTONE” or 3.
“CURVED” in Step 2, and then
press ENTER.
The “GEOMETRY:KEYSTONE” or •
“GEOMETRY:CURVED” screen will be
displayed.
GEOMETRY:KEYSTONE
VERTICAL KEYSTONE
VERTICAL SUB KEYSTONE
0
0
GEOMETRY:CURVED
LENS THROW RATIO
VERTICAL KEYSTONE
0
0
Press ▲▼ to select the desired 4.
adjustment item, and press ◄►
to adjust the correction amount.
You can adjust the projection images as shown •
below.
KEYSTONE menu:
VERTICAL KEYSTONE•
VERTICAL SUB KEYSTONE•
HORIZONTAL KEYSTONE•
HORIZONTAL SUB KEYSTONE•
LINEARITY•
CURVED menu:
LENS THROW RATIO•
Set the throw ratio of the lens you are using.
(pp. 22-24)
VERTICAL KEYSTONE•
HORIZONTAL KEYSTONE•
VERTICAL ARC•
HORIZONTAL ARC•
VERTICAL BALANCE•
HORIZONTAL BALANCE•
Note
If vertical keystone correction is set, menus and •
logos may protrude out of the screen.
If both edge blending adjustment and geometry •
correction are used, set the geometry correction
to curved-surface correction or PC. If geometry
correction is set to keystone-distortion correction,
edge blending adjustment cannot be made
correctly. (p. 66)
Manual
View the manual for the Panasonic PT-DZ12000E here, for free. This manual comes under the category video projectors and has been rated by 1 people with an average of a 5.5. This manual is available in the following languages: English. Do you have a question about the Panasonic PT-DZ12000E or do you need help? Ask your question here
Need help?
Do you have a question about the Panasonic and is the answer not in the manual?
Question and answer
Number of questions: 0