Panasonic PT-DZ12000E manual

Panasonic PT-DZ12000E
5.5 · 1
PDF manual
 · 128 pages
English
manualPanasonic PT-DZ12000E

ENGLISH

43

Basic Operation

If the lens is heavy or the projector is installed so that it is tilted, the lens may be tilted, resulting in the focus
becoming unbalanced.
In such a case, refer to the figure 4 and table below, and follow the procedure below to perform adjustment.
Adjustment procedure z
1
Switch to the focus adjustment mode with the remote control, and use the button to first offset the
whole focus.
2
Use the button to stop at the place that first becomes just in focus in any of the directions of the
screen. (In this state, the just-in-focus point is at the back of the screen in the direction in which the
focus is offset.)
3
Remove the lens cover and lens.
4
Loosen by two turns the fixing screw of the direction that is opposite the direction in which the focus
is most offset (direction in which the just-in-focus point in
2
is the most offset toward the back) (see
Figure 4).
Attention
Be careful because turning a screw more than twice to loosen it will result in the spring becoming detached
and the projector needing to be repaired.
Make adjustments in up to two places, and fully turn the screw clockwise in at least one place.
5
Install the removed lens.
6
Turn the adjustment screw counterclockwise little by little and stop at the point that is in focus. Turning
the screw counterclockwise moves the lens bracket of the mounter forward (screen side), which
changes the tilt of the lens (see Figure 1) and moves the focus point in the projection image on the
screen in the opposite direction to that of the adjustment screw.
7
Changing the tilt of the lens also changes the screen position of the projection image with regards to
the screen surface, so use the remote control to switch to the lens shift adjustment mode and return the
position to the optimal position.
8
Perform refocus adjustment around the centre of the screen, and make even finer adjustments of the
rotation amount of the adjustment screws if the focus is still inadequate.
9
When adjustment is complete, remove the lens and then tighten the loosened fixing screws.
j
Install the lens and cover again to complete the focus adjustment.
Tool to be used: Allen hex socket driver or Allen wrench (2.5 mm diagonal hexagon)
An Allen wrench is supplied with the ET-D75LE6 and ET-D75LE8 optional lens.
Figure 4 : Relation between the adjustment place and adjustment screw
V up
H left
H
right
V bottom
cb
ac ab
b+c
a
c+(a) b+(a)
Projector
Screen
Adjustment place: The place where the just-in-focus point is at the back.
When optimal focus point is
at front of screen for V up
When optimal focus is at
front of screen for V bottom
When optimal focus is at
front of screen for H left
When optimal focus is at
front of screen for H right
a
Turn counterclockwise
b
Turn counterclockwise Turn counterclockwise
c
Turn counterclockwise Turn counterclockwise

Manual

View the manual for the Panasonic PT-DZ12000E here, for free. This manual comes under the category video projectors and has been rated by 1 people with an average of a 5.5. This manual is available in the following languages: English. Do you have a question about the Panasonic PT-DZ12000E or do you need help? Ask your question here

Index

Need help?

Do you have a question about the Panasonic and is the answer not in the manual?

  • Receive updates on solutions
  • Get answers to your question

Question and answer

Number of questions: 0

Panasonic PT-DZ12000E specifications

Below you will find the product specifications and the manual specifications of the Panasonic PT-DZ12000E.

General
BrandPanasonic
ModelPT-DZ12000E | PT-DZ12000E
Productvideo projector
EAN5052178257828
LanguageEnglish
FiletypeUser manual (PDF)
Projector
Projector brightness12000 ANSI lumens
Projection technologyDLP
Projector native resolutionWUXGA (1920x1200)
Contrast ratio (typical)5000:1
Projection distance1.1 - 103.3 m
Number of colors16.78 million colors
Vertical scan range24 - 120 Hz
Horizontal scan range15 - 100 kHz
Other features
Aspect ratio16:10
RS-232 ports1
Dimensions (WxDxH)578 x 320 x 643 mm
Light source
Lamp power300 W
Lamp typeUHM
Light source typeLamp
Ports & interfaces
VGA (D-Sub) ports quantity1
S-Video inputs quantity1
Composite video in1
DVI portYes
Serial interface typeRS-232
Network
Ethernet LAN (RJ-45) ports1
Weight & dimensions
Weight35000 g
Power
Power consumption (typical)1500 W
Operational conditions
Operating relative humidity (H-H)10 - 80 %
Operating temperature (T-T)0 - 45 °C
show more

Frequently Asked Questions

Can't find the answer to your question in the manual? You may find the answer to your question in the FAQs about the Panasonic PT-DZ12000E below.

What is the weight of the Panasonic PT-DZ12000E?

The Panasonic PT-DZ12000E has a weight of 35000 g.

Is the manual of the Panasonic PT-DZ12000E available in English?

Yes, the manual of the Panasonic PT-DZ12000E is available in English .

Is your question not listed? Ask your question here

No results