Panasonic PT-DZ12000E manual

Panasonic PT-DZ12000E
5.5 · 1
PDF manual
 · 128 pages
English
manualPanasonic PT-DZ12000E

ENGLISH

115

Information

Procedure of lamp unit replacement

Turn the main power OFF, following the procedures described in 1.
“Powering up the projector” (p. 38) and “Powering off the projector”
(p. 39), disconnect the power plug from the AC power source, and wait
for one hour or more. Then check around the lamp unit that has cooled
down.
Use a Phillips screwdriver to 2.
loosen the lamp unit cover screw
at the rear of the projector until
the screw turns freely.
Open the lamp unit cover and 3.
remove it from the projector.
Lamp unit cover screw
Lamp unit cover
Use a Phillips screwdriver to 4.
loosen the three fixing screws for
the lamp unit to be replaced until
the screws turn freely. Hold the
handle of the lamp unit and gently
pull the lamp unit out from the
projector.
CAUTION
The lamp unit and structural parts around the
lamp unit will be hot immediately after the
projector has been used.
You might get burned if you touch it while it is still
hot.
Lamp unit 1 Lamp unit 3
Lamp unit 2 Lamp unit 4
Fixing
screws
Handle
Install the new lamp unit.5.
Use a Phillips screwdriver to securely tighten the 3 lamp unit fixing 6.
screws for each lamp unit.
Install and close the lamp unit 7.
cover, and then use a Phillips
screwdriver to securely tighten
the lamp unit cover screw.
Caution
Firmly install the lamp unit and lamp unit cover. If not
installed firmly, a protection circuit will function and
the power will not be turned on.
Lamp unit cover screw
Lamp unit cover

Manual

View the manual for the Panasonic PT-DZ12000E here, for free. This manual comes under the category video projectors and has been rated by 1 people with an average of a 5.5. This manual is available in the following languages: English. Do you have a question about the Panasonic PT-DZ12000E or do you need help? Ask your question here

Index

Need help?

Do you have a question about the Panasonic and is the answer not in the manual?

  • Receive updates on solutions
  • Get answers to your question

Question and answer

Number of questions: 0

Panasonic PT-DZ12000E specifications

Below you will find the product specifications and the manual specifications of the Panasonic PT-DZ12000E.

General
BrandPanasonic
ModelPT-DZ12000E | PT-DZ12000E
Productvideo projector
EAN5052178257828
LanguageEnglish
FiletypeUser manual (PDF)
Projector
Projector brightness12000 ANSI lumens
Projection technologyDLP
Projector native resolutionWUXGA (1920x1200)
Contrast ratio (typical)5000:1
Projection distance1.1 - 103.3 m
Number of colors16.78 million colors
Vertical scan range24 - 120 Hz
Horizontal scan range15 - 100 kHz
Other features
Aspect ratio16:10
RS-232 ports1
Dimensions (WxDxH)578 x 320 x 643 mm
Light source
Lamp power300 W
Lamp typeUHM
Light source typeLamp
Ports & interfaces
VGA (D-Sub) ports quantity1
S-Video inputs quantity1
Composite video in1
DVI portYes
Serial interface typeRS-232
Network
Ethernet LAN (RJ-45) ports1
Weight & dimensions
Weight35000 g
Power
Power consumption (typical)1500 W
Operational conditions
Operating relative humidity (H-H)10 - 80 %
Operating temperature (T-T)0 - 45 °C
show more

Frequently Asked Questions

Can't find the answer to your question in the manual? You may find the answer to your question in the FAQs about the Panasonic PT-DZ12000E below.

What is the weight of the Panasonic PT-DZ12000E?

The Panasonic PT-DZ12000E has a weight of 35000 g.

Is the manual of the Panasonic PT-DZ12000E available in English?

Yes, the manual of the Panasonic PT-DZ12000E is available in English .

Is your question not listed? Ask your question here

No results