Panasonic PT-DZ12000E manual

Panasonic PT-DZ12000E
5.5 · 1
PDF manual
 · 128 pages
English
manualPanasonic PT-DZ12000E

ENGLISH

111

Information

Indication of monitor lamp

Five monitor lamps are provided at the top of main unit front to inform the user of the lamp replacement time and unusual internal temperature. These lamps indicate the degree of abnormality by combination of blinking and/or lighting lamps. Turn off the power and take the proper measure according to the table below.
FILTER
CLEANING
OPEN
CLOSE
LAMP 4 monitor (LAMP 4)LAMP 2 monitor (LAMP 2)LAMP 1 monitor (LAMP 1)LAMP 3 monitor (LAMP 3)Temperature monitor (TEMP)Name of monitor
lamp
Lamp indicationInformation Check point Remedial measure
TEMP
monitor
Lighting in
red
Warm-up status
Did you turn on the
power when the ambient
temperature was low
(approx. 0 °C)?
Wait about five minutes in the current status.
Install the unit in a location having an
ambient temperature from 0 °C to 45 °C.
High temperature
inside. (WARNING)
Check if the ventilation
port is blocked.
Is the room air
temperature too high?
Is the air filter blocked
with dust?
Was the temperature
warning indication
displayed?
Remove the object that is blocking the
ventilation port.
Move the projector to a temperature of 0 °C
to 45 ˚C and the humidity of 10 % to 80 %
(no condensation).
Turn off the MAIN POWER switch using the
procedure on page 39 and clean the air filter.
(pp. 112-113)
Blinking in
red
(2 times)
High temperature
inside
(Standby condition)
Blinking in
red
(3 times)
Cooling fan has been
stopped.
Turn off the main power supply (MAIN
POWER) switch in the procedure shown on
page 39 and consult the distributor.
LAMP
monitor
Lighting in
red
Indicates the time for
replacing the lamp
unit.
Did you notice a
“REPLACE THE LAMP”
message on the screen
when turning on the
projector power supply?
This lamp monitor lights up when the lamp
unit used hours have reached 1 800 hours.
Request the dealer to replace the lamp unit.
Blinking in
red
(3 times)
Error is detected in
the lamp circuit.
Did you turn the power
back on immediately
after turning it off?
Wait until the lamp has cooled off, and then
turn on the power.
Some error has arisen in
the lamp circuit.
Check for fluctuation
(or drop) in the source
voltage.
Turn off the MAIN POWER switch using
the procedure on page 39 and consult the
dealer.
Attention
Be sure to observe the procedure “Powering up the projector” (p. 38) and “Powering off the projector” (p. 39)
when performing power supply operation to take a measure to the indication of temperature monitor (TEMP) lamp and lamp monitor (LAMP) lamp.

Manual

View the manual for the Panasonic PT-DZ12000E here, for free. This manual comes under the category video projectors and has been rated by 1 people with an average of a 5.5. This manual is available in the following languages: English. Do you have a question about the Panasonic PT-DZ12000E or do you need help? Ask your question here

Index

Need help?

Do you have a question about the Panasonic and is the answer not in the manual?

  • Receive updates on solutions
  • Get answers to your question

Question and answer

Number of questions: 0

Panasonic PT-DZ12000E specifications

Below you will find the product specifications and the manual specifications of the Panasonic PT-DZ12000E.

General
BrandPanasonic
ModelPT-DZ12000E | PT-DZ12000E
Productvideo projector
EAN5052178257828
LanguageEnglish
FiletypeUser manual (PDF)
Projector
Projector brightness12000 ANSI lumens
Projection technologyDLP
Projector native resolutionWUXGA (1920x1200)
Contrast ratio (typical)5000:1
Projection distance1.1 - 103.3 m
Number of colors16.78 million colors
Vertical scan range24 - 120 Hz
Horizontal scan range15 - 100 kHz
Other features
Aspect ratio16:10
RS-232 ports1
Dimensions (WxDxH)578 x 320 x 643 mm
Light source
Lamp power300 W
Lamp typeUHM
Light source typeLamp
Ports & interfaces
VGA (D-Sub) ports quantity1
S-Video inputs quantity1
Composite video in1
DVI portYes
Serial interface typeRS-232
Network
Ethernet LAN (RJ-45) ports1
Weight & dimensions
Weight35000 g
Power
Power consumption (typical)1500 W
Operational conditions
Operating relative humidity (H-H)10 - 80 %
Operating temperature (T-T)0 - 45 °C
show more

Frequently Asked Questions

Can't find the answer to your question in the manual? You may find the answer to your question in the FAQs about the Panasonic PT-DZ12000E below.

What is the weight of the Panasonic PT-DZ12000E?

The Panasonic PT-DZ12000E has a weight of 35000 g.

Is the manual of the Panasonic PT-DZ12000E available in English?

Yes, the manual of the Panasonic PT-DZ12000E is available in English .

Is your question not listed? Ask your question here

No results