fThis is disabled when [3D SYSTEM SETTING] is set to other than [SINGLE].
[SUB CLOCK PHASE]
You can adjust the image when the image ickers or outline blurs.
1) Press as to select [SUB CLOCK PHASE].
2) Press qw or the <ENTER> button.
fThe [SUB CLOCK PHASE] individual adjustment screen is displayed.
3) Press qw to adjust.
fAdjustment value will change between [0] and [+31]. Adjust so that the amount of interference is at a minimum.
Note
fEnables during simultaneous system 3D video signal input to RGB1 and RGB2 and adjusts the images for the right eye.
fThis is disabled when [3D SYSTEM SETTING] is set to other than [SINGLE].
fThis is disabled when [3D TEST PATTERN] is displayed.
fThis is disabled when [3D TEST MODE] is set to other than [NORMAL].
[3D FRAME DELAY]
Adjust the timing of the left-right switch of an image.
1) Press as to select [3D FRAME DELAY].
2) Press qw to switch the item.
[0us] - [25000us]Allows you to set in increments of 10 us.
fThe adjustment range depends on the input signal.
[3D TEST MODE]
Set the image display system for use with 3D system adjustments.
1) Press as to select [3D TEST MODE].
2) Press qw to switch the item.
[NORMAL]Standard setting.
[LEFT/LEFT]Both the left eye image and right eye image display the left eye input signal.
[RIGHT/RIGHT]Both the left eye image and right eye image display the right eye input signal.
[LEFT/BLACK]
The left eye input signal is displayed in the left eye image and a completely black image is displayed
in the right eye image.
[BLACK/RIGHT]
A completely black image is displayed in the left eye image and the right input signal is displayed in
the right eye image.
Note
fThe [3D TEST MODE] settings return to [NORMAL] when the projector is switched off.
fThis is disabled when [3D SYSTEM SETTING] is set to other than [SINGLE].
fThis is disabled when [3D TEST PATTERN] is displayed.
[3D TEST PATTERN]
The 3D test pattern can be used to check operation and make adjustments even without a 3D signal.
1) Press as to select [3D TEST PATTERN].
2) Press qw to switch [3D TEST PATTERN].
fSelect a test pattern so that it is easy to check operations and make adjustments.
Note
fThe 3D test pattern cannot be displayed when the following inputs are selected.
gVIDEO input
gRGB1 input (only when [RGB IN] is set to [Y/C])
fThis is disabled when [3D SYSTEM SETTING] is set to other than [SINGLE].
Manual
View the manual for the Panasonic PT-DX100EWJ here, for free. This manual comes under the category video projectors and has been rated by 1 people with an average of a 6.9. This manual is available in the following languages: English. Do you have a question about the Panasonic PT-DX100EWJ or do you need help? Ask your question here
Need help?
Do you have a question about the Panasonic and is the answer not in the manual?
Question and answer
Number of questions: 0