Refer to “Adjusting desired correction amount” (x page 76) for details.
Adjusting desired correction amount
1) Press as to select [DYNAMIC IRIS].
2) Press qw or the <ENTER> button.
fThe [DYNAMIC IRIS] individual adjustment screen is displayed.
3) Press qw to select [USER].
4) Press the <ENTER> button.
fThe [DYNAMIC IRIS] screen is displayed.
5) Press as to select [AUTO IRIS], [MANUAL IRIS], or [DYNAMIC GAMMA].
6) Press qw to adjust the correction amount.
ItemAdjustment
[AUTO IRIS]
(Automatic adjustment of
aperture)
[OFF]No correction.
[1] - [255]
Allows you to set in increments of 1. The larger the value, the
stronger the correction.
[MANUAL IRIS]
(Fixed adjustment of aperture)
[OFF]No correction.
[1] - [255]
Allows you to set in increments of 1. The larger the value, the
stronger the correction.
[DYNAMIC GAMMA]
(Adjustment of signal
compensation)
[OFF]No correction.
[1]Slightly compensates the signal.
[2]Moderately compensates the signal.
[3]Strongly compensates the signal.
Note
fWhen [DYNAMIC GAMMA] is set to [3], the contrast will be maximized.
fBrightness control and dynamic iris operate simultaneously, but the iris is fully open and does not operate while a brightness measurement
is performed.
fIf [DLP Link] is set to [ON], [DYNAMIC IRIS] is xed to [OFF] while 3D images are displayed.
[SYSTEM SELECTOR]
The projector will automatically detect the input signal, but you can set the system method manually when an unstable signal is input. Set the
system method matching the input signal.
1) Press as to select [SYSTEM SELECTOR].
2) Press the <ENTER> button.
3) Press as to select a system format.
fIf inputting signals via the <SDI IN> terminal connection, select the system method by pressing asqw. (Only for PT-DZ870E)
fAvailable system formats vary depending on the input signal.
TerminalSystem format
<VIDEO IN> terminal, <G/
Y>/<B/P
B
/C> terminals
Select [AUTO], [NTSC], [NTSC4.43], [PAL], [PAL-M], [PAL-N], [SECAM], or [PAL60].
Set it to [AUTO] normally. (Setting [AUTO] will automatically select [NTSC], [NTSC4.43], [PAL],
[PAL-M], [PAL-N], [SECAM], or [PAL60].)
Switch the setting to the signal method for the TV used.
<RGB 1 IN> terminal, <RGB 2
IN> terminal
480i, 576i, or 576p signalSelect [RGB] or [YC
B
C
R
].
VGA60 or 480p signalSelect from [VGA60], [480p YC
B
C
R
], or [480p RGB].
Other movie-based signalsSelect [RGB] or [YP
B
P
R
].
<DVI-D IN> terminal
480i, 576i, 480p, or 576p
signal
Select [RGB] or [YC
B
C
R
].
Other movie-based signalsSelect [RGB] or [YP
B
P
R
].
Manual
View the manual for the Panasonic PT-DX100EWJ here, for free. This manual comes under the category video projectors and has been rated by 1 people with an average of a 6.9. This manual is available in the following languages: English. Do you have a question about the Panasonic PT-DX100EWJ or do you need help? Ask your question here
Need help?
Do you have a question about the Panasonic and is the answer not in the manual?
Question and answer
Number of questions: 0