Chapter 3Basic Operations — Switching on/off the projector
ENGLISH - 55
Note
fWhile the power indicator <ON (G)/STANDBY (R)> is lit in orange, the fan is running to cool the projector.
fFor about 75 seconds after the projector is switched off and the luminous lamp cooling is started, the lamp indicators do not light up even if
the power is switched on. After the power indicator <ON (G)/STANDBY (R)> lights in red, turn on the power again.
fThe projector consumes power even in standby mode (power indicator <ON (G)/STANDBY (R)> lit in red). Refer to “Power consumption”
(x page 183) for the power consumption.
fThe power indicator <ON (G)/STANDBY (R)> will ash if the projector receives a remote control signal.
fThe power indicator <ON (G)/STANDBY (R)> will ash slowly in green while the shutter is closed.
fIf the power indicator <ON (G)/STANDBY (R)> is ashing in red, consult your dealer.
Switching on the projector
When using the optional projection lens, attach the projection lens before switching on the projector.
Remove the lens cover rst.
2)
4)
4)
3)
1)
1) Connect the power cord to the projector body.
2) Connect the power plug to an outlet.
f(AC 120 V - 240 V 50 Hz/60 Hz)
3) Press the <ON> side of the <MAIN POWER> switch to turn on the power.
fThe power indicator <ON (G)/STANDBY (R)> will light in red, and the projector will enter the standby mode.
4) Press the power on <b> button.
fThe power indicator <ON (G)/STANDBY (R)> lights in green and the image is soon projected on the screen.
Note
fIf the projector is switched on at around 0 °C (32 °F), a warm-up period of approximately ve minutes may be necessary until an image is
displayed.
The temperature indicator <TEMP> lights during the warm-up period. When the warm-up is completed, the temperature indicator <TEMP>
turns off and the projection starts. Refer to “When an indicator lights up” (x page 157) for the indicator status.
fIf the operating environment temperature is low and warm-up takes more than ve minutes, the projector will judge that a problem has
occurred and the power will automatically be set to standby mode. If this happens, increase the operating environment temperature to 0 °C
(32 °F) or higher, turn off the main power, and then switch on the projector again.
fIf the [PROJECTOR SETUP] menu → [STANDBY MODE] is set to [ECO], it may take approx. 10 seconds longer before the projector starts
projecting after the power is turned on, compared with when [NORMAL] is set.
fIf the <MAIN POWER> switch was set to <OFF> during projection to end the projection using the direct power off function last time, and the
<MAIN POWER> switch is set to <ON> with the power plug connected to the outlet, the power indicator <ON (G)/STANDBY (R)> will light in
green and the image will soon be projected on the screen.
Manual
View the manual for the Panasonic PT-DX100EWJ here, for free. This manual comes under the category video projectors and has been rated by 1 people with an average of a 6.9. This manual is available in the following languages: English. Do you have a question about the Panasonic PT-DX100EWJ or do you need help? Ask your question here
Need help?
Do you have a question about the Panasonic and is the answer not in the manual?
Question and answer
Number of questions: 0