7) When the confirmation screen is displayed, press qw to select [OK], and press the <ENTER> button.
Note
fThe projector does not support 10BaseT Full/Half.
When the projector is connected to a twisted-pair-cable transmitter
1) Press as to select [DIGITAL LINK SETUP].
2) Press the <ENTER> button.
fThe [DIGITAL LINK SETUP] screen is displayed.
3) Press as to select [DUPLEX(DIGITAL LINK)].
4) Press qw to switch the communication method.
fThe items will switch each time you press the button.
[100BaseTX-Full]Full duplex communication method is set.
[100BaseTX-Half]Half-duplex communication method is set.
[AUTONEGOTIATION]The communication method is set automatically.
5) Press as to select [STORE].
6) Press the <ENTER> button.
7) When the confirmation screen is displayed, press qw to select [OK], and press the <ENTER> button.
[DIGITAL LINK STATUS]
Display DIGITAL LINK connection environment.
1) Press as to select [DIGITAL LINK STATUS].
2) Press the <ENTER> button.
fThe [DIGITAL LINK STATUS] screen is displayed.
[LINK STATUS]Either [NO LINK], [DIGITAL LINK], or [ETHERNET] is displayed.
[HDCP STATUS]Either [NO SIGNAL], [OFF], or [ON] is displayed.
[SIGNAL QUALITY]
[SIGNAL QUALITY] is a numerical value of the amount of error, and the display color changes to
green, yellow, or red depending on that value.
Check the signal quality level while receiving a signal from the twisted-pair-cable transmitter.
fMAX/MIN: Maximum/minimum value of the amount of error.
fGreen (
-
12 dB or lower) → Normal signal quality level.
fYellow (
-
11 to
-
8 dB) → Warning level where there is the possibility of noise introduced on the
screen.
fRed (
-
7 dB or higher) → Abnormal level where synchronization may be interrupted, or a signal may
not be received.
[NETWORK SETUP]
Perform the initial setting of the network before using the network function.
1) Press as to select [NETWORK SETUP].
2) Press the <ENTER> button.
fThe [NETWORK SETUP] screen is displayed.
3) Press as to select an item, and change the settings according to the operation instructions of the
menu.
[PROJECTOR NAME]Change the setting when using a DHCP server.
[DHCP]
Set to [ON] when obtaining an IP address automatically using a DHCP server. Set to [OFF] when not
using a DHCP server.
[IP ADDRESS]Enter the IP address when not using a DHCP server.
[SUBNET MASK]Enter the subnet mask when not using a DHCP server.
[DEFAULT GATEWAY]Enter the default gateway address when not using a DHCP server.
[STORE]Save the current network settings.
Manual
View the manual for the Panasonic PT-DX100EWJ here, for free. This manual comes under the category video projectors and has been rated by 1 people with an average of a 6.9. This manual is available in the following languages: English. Do you have a question about the Panasonic PT-DX100EWJ or do you need help? Ask your question here
Need help?
Do you have a question about the Panasonic and is the answer not in the manual?
Question and answer
Number of questions: 0