Panasonic PT-DX100EWJ manual

Panasonic PT-DX100EWJ
6.9 · 1
PDF manual
 · 190 pages
English
manualPanasonic PT-DX100EWJ
Chapter 4Settings — [PROJECTOR SETUP] menu

ENGLISH - 111

[LAMP POWER]

Switch the brightness of the lamp according to the operating environment of the projector or the purpose.
1) Press as to select [LAMP POWER].
2) Press qw to switch the item.
[NORMAL] Select when high luminance is required.
[ECO] Select when high luminance is not required.
Note
f When [ECO] is set, you can reduce power consumption and operation noise, and extend the life of the lamp.

[BRIGHTNESS CONTROL]

The projector is equipped with a luminance sensor to measure brightness and functions to correct screen brightness resulting from changes in
lamp brightness.
Use the projector when using multiple projectors to display on multiple screens to reduce changes in overall brightness of the multiple screens
due to lamp degradation and suppress variation in brightness to preserve uniformity.

Setting [BRIGHTNESS CONTROL GAIN]

Adjust the brightness when displaying multiple screens using multiple projectors.
1) Press as to select [BRIGHTNESS CONTROL].
2) Press the <ENTER> button.
f The [BRIGHTNESS CONTROL] screen is displayed.
3) Press as to select [BRIGHTNESS CONTROL GAIN].
4) Press qw to adjust.
Operation
Adjustment
Range of adjustment
Brightness
Maximum amount of
brightness correction
Press the w button.
The screen becomes brighter.
The maximum amount of
correction is reduced.
20 % - 100 %
Press the q button.
The screen becomes darker.
The maximum amount of
correction is increased.
Note
f When using only one projector, the value obtained by subtracting the value of the [BRIGHTNESS CONTROL GAIN] from 100 % is the
maximum amount of brightness correction. Brightness cannot be corrected through brightness control since the maximum amount of
correction becomes 0 % when [BRIGHTNESS CONTROL GAIN] is at 100 %.
f Luminance will be unsteady for eight minutes after a lamp is turned on. Make adjustments at least 8 minutes after starting projection.
f The result of [BRIGHTNESS CONTROL GAIN] adjustments is reected on all image signals, internal test patterns, and on-screen menus.
f The [BRIGHTNESS CONTROL GAIN] setting is enabled even if [BRIGHTNESS CONTROL SETUP] is [OFF].

Manual

View the manual for the Panasonic PT-DX100EWJ here, for free. This manual comes under the category video projectors and has been rated by 1 people with an average of a 6.9. This manual is available in the following languages: English. Do you have a question about the Panasonic PT-DX100EWJ or do you need help? Ask your question here

Index

Need help?

Do you have a question about the Panasonic and is the answer not in the manual?

  • Receive updates on solutions
  • Get answers to your question

Question and answer

Number of questions: 0

Panasonic PT-DX100EWJ specifications

Below you will find the product specifications and the manual specifications of the Panasonic PT-DX100EWJ.

General
BrandPanasonic
ModelPT-DX100EWJ | PT-DX100EWJ
Productvideo projector
EAN5025232738670
LanguageEnglish
FiletypeUser manual (PDF)
Projector
Projector brightness10000 ANSI lumens
Projection technologyDLP
Projector native resolutionXGA (1024x768)
Contrast ratio (typical)10000:1
Native aspect ratio4:3
Matrix size0.7 "
Screen size compatibility50 - 600 "
Projection distance- m
Uniformity90 %
Vertical scan range24 - 120 Hz
Horizontal scan range15 - 100 kHz
Keystone correction, vertical-40 - 40 °
Design
Product typeCeiling / Floor mounted projector
Product colorWhite
LED indicatorsYes
Housing materialPlastic
PlacementCeiling, Floor
Power
Power sourceAC
Power consumption (typical)1030 W
Power consumption (standby)3 W
AC input voltage120 - 240 V
AC input frequency50 - 60 Hz
Display
Built-in display-
Video
Full HDNo
3DYes
3D ReadyYes
Supported video modes480i, 480p, 576i, 576p, 720p, 1080i, 1080p
Analog signal format systemNTSC, NTSC 4.43, PAL, PAL 60, PAL M, PAL N, SECAM
Supported graphics resolutions640 x 480 (VGA), 1920 x 1200 (WUXGA)
Supported 3D formatsFrame packing, Side by side, Top and bottom
Lens system
Focal length range25.6 - 35.7 mm
Aperture range (F-F)1.7 - 1.9
Throw ratio1.8 - 2.5:1
Light source
Lamps quantity2 lamp(s)
Lamp power420 W
Lamp typeUHM
Service life of light source3000 h
Light source typeLamp
Features
Dot clock scanning frequency162 MHz
HDCPYes
Noise level40 dB
Noise level (economic mode)35 dB
Network
Smart TVNo
Ethernet LANYes
Wi-Fi-
Ethernet LAN data rates10, 100 Mbit/s
Ethernet LAN (RJ-45) ports1
Weight & dimensions
Width498 mm
Depth556 mm
Height200 mm
Weight18300 g
Packaging content
Handheld remote controlYes
Remote control typeWireless/Wired
Batteries includedYes
Cables includedAC
Resource CDYes
Operational conditions
Operating temperature (T-T)0 - 45 °C
Operating relative humidity (H-H)10 - 80 %
Storage
Card reader integratedNo
Optical disc player typeNot included
Ports & interfaces
BNC input ports7
S-Video inputs quantity-
Audio (L/R) in0
USB 2.0 ports quantity0
DVI portYes
Component video (YPbPr/YCbCr) in1
Composite video in1
HDMI ports quantity1
VGA (D-Sub) ports quantity1
AC (power) inYes
Serial interface typeRS-232
Other features
RS-232 ports2
Multimedia
Built-in speaker(s)-
show more

Frequently Asked Questions

Can't find the answer to your question in the manual? You may find the answer to your question in the FAQs about the Panasonic PT-DX100EWJ below.

What is the weight of the Panasonic PT-DX100EWJ?

The Panasonic PT-DX100EWJ has a weight of 18300 g.

What is the height of the Panasonic PT-DX100EWJ?

The Panasonic PT-DX100EWJ has a height of 200 mm.

What is the width of the Panasonic PT-DX100EWJ?

The Panasonic PT-DX100EWJ has a width of 498 mm.

What is the depth of the Panasonic PT-DX100EWJ?

The Panasonic PT-DX100EWJ has a depth of 556 mm.

Is the manual of the Panasonic PT-DX100EWJ available in English?

Yes, the manual of the Panasonic PT-DX100EWJ is available in English .

Is your question not listed? Ask your question here

No results