Panasonic NV-DS38 manual

Panasonic NV-DS38
7.6 · 2
PDF manual
 · 52 pages
English
manualPanasonic NV-DS38
2
Fuse CoverConnector Cover
Fuse
Movie Camera
The rating plate is on the underside of the Movie
Camera.
AC Adaptor
The rating plate is on the underside of the AC Adaptor.
As this equipment gets hot during use, operate it in
well ventilated place; do not install this equipment in a
confined space such as a bookcase or similar unit.

Caution for AC mains lead

For your safety, please read the following text carefully.
This appliance is supplied with a moulded three-pin
mains plug for your safety and convenience. A 5-ampere
fuse is fitted in this plug.
Should the fuse need to be replaced, please ensure that
the replacement fuse has a rating of 5-amperes and it is
approved by ASTA or BSI to BS1362.
Check for the ASTA mark Ï or the BSI mark Ì on the
body of the fuse.
If the plug contains a removable fuse cover you must
ensure that it is refitted when the fuse is replaced. If you
lose the fuse cover, the plug must not be used until a
replacement cover is obtained. A replacement fuse
cover can be purchased from your local Panasonic
Dealer.
IF THE FITTED MOULDED PLUG IS UNSUITABLE
FOR THE SOCKET OUTLET IN YOUR HOME THEN
THE FUSE SHOULD BE REMOVED AND THE PLUG
CUT OFF AND DISPOSED OF SAFELY.
THERE IS A DANGER OF SEVERE ELECTRICAL
SHOCK IF THE CUT OFF PLUG IS INSERTED INTO
ANY 13-AMPERE SOCKET.
If a new plug is to be fitted, please observe the wiring
code as shown below.
If in any doubt, please consult a qualified electrician.
ª IMPORTANT
The wires in this mains lead are coloured in accordance
with the following code:
Blue: Neutral
Brown: Live
As the colours of the wires in the mains lead of this
appliance may not correspond with the coloured
markings identifying the terminals in your plug, proceed
as follows:
The wire which is coloured BLUE must be connected to
the terminal in the plug which is marked with the letter N
or coloured BLACK.
The wire which is coloured BROWN must be connected
to the terminal in the plug which is marked with the letter
L or coloured RED.
Under no circumstances should either of these wires be
connected to the earth terminal of the three-pin plug,
marked with the letter E or the Earth Symbol Ó.
ª Before Use
Remove the Connector
Cover as follows.
ª How to replace the
Fuse
1) Remove the Fuse Cover
with a screwdriver.
2) Replace the fuse and
attach the Fuse Cover.

Before Use

Dear Customer,
We would like to take this opportunity to thank you for purchasing this Panasonic Movie Camera.
Please read these Operating Instructions carefully and keep them handy for future reference.
Please note that the actual controls and components, menu items, etc. of your Movie Camera may
look somewhat different from those shown in the illustrations in these Operating Instructions.

Information for Your Safety

Operating Instructions
These Operating Instructions apply to models NV-DS27,
NV-DS28, NV-DS37 and NV-DS38.
The illustrations used in these Operating Instructions show
model NV-DS38, however, parts of the explanation refer to
different models.
Depending on the model, some functions are not available.
SD Logo is a trademark.
All other company and product names in the operating
instructions are trademarks of their respective
corporations.
Still pictures recorded on a MultiMediaCard or SD
Memory Card (NV-DS37/DS38 only)
It may not be possible to play back the pictures on this Movie
Camera recorded on and created by other equipment or vice
versa. For this reason, check the compatibility of the
equipment in advance.
Pages for reference
Pages for reference are indicated with an arrow, for example:
(l 00)
ª WARNING
To reduce the risk of fire or shock hazard and annoying
interference, use only the recommended accessories
and do not expose this equipment to rain or moisture.
Do not remove the cover (or back); there are no user
serviceable parts inside. Refer servicing to qualified
service personnel.
ª Carefully observe copyright laws.
Recording of pre-recorded tapes or discs or other
published or broadcast material for purposes other than
your own private use may infringe copyright laws. Even
for the purpose of private use, recording of certain
material may be restricted.
B.book 2 ページ 2001年3月14日 水曜日 午前11時21分

Manual

View the manual for the Panasonic NV-DS38 here, for free. This manual comes under the category camcorders and has been rated by 2 people with an average of a 7.6. This manual is available in the following languages: English. Do you have a question about the Panasonic NV-DS38 or do you need help? Ask your question here

Need help?

Do you have a question about the Panasonic and is the answer not in the manual?

  • Receive updates on solutions
  • Get answers to your question

Question and answer

Number of questions: 2
W
william forsythMay 1, 2024

How do I reset the camcorder the message on the screen is saying , Please ER=OPERATE AFTER PUSHING RESET BUTTON.

How do I reset the camcorder the  message on the screen is  saying , Please ER=OPERATE AFTER PUSHING RESET BUTTON.
zoom-in
View photo
1 comment
E
Emma of manua.lsJune 10, 2024

To reset the Panasonic NV-DS38 camcorder when the message "Please ER=OPERATE AFTER PUSHING RESET BUTTON" appears on the screen, follow these steps: 1. Open the cover by sliding the [<EJECT] Lever. 2. Insert a cassette. 3. Close the cover and press the [PUSH LOCK] Button to lock the cover.

This answer is automatically generated
A
AnuMay 20, 2024

I connected batter but the video is not displaying

Panasonic NV-DS38 specifications

Below you will find the product specifications and the manual specifications of the Panasonic NV-DS38.

The Panasonic NV-DS38 is a camcorder that was released in 2003. It is a compact and lightweight device that is intended for home use. This camcorder is equipped with a 0.8-megapixel CCD sensor and a 10x optical zoom lens. It features an optical image stabilizer, which is designed to reduce camera shake when recording video. Additionally, it has a 2.5-inch color LCD display that can be used for framing shots and reviewing footage. The NV-DS38 can record video in MPEG-2 format and still images in JPEG format. It has an SD memory card slot for storing footage and images, which can be easily transferred to a computer. Other features of this camcorder include a built-in microphone, a headphone jack, and an analog input for recording from external sources. Overall, the Panasonic NV-DS38 is a decent entry-level camcorder that is suitable for those who don't require advanced features or high-quality video. Although it is quite outdated compared to modern camcorders, it is still a reliable device that can capture home movies and other casual footage.

General
BrandPanasonic
ModelNV-DS38
Productcamcorder
LanguageEnglish
FiletypeUser manual (PDF)

Frequently Asked Questions

Can't find the answer to your question in the manual? You may find the answer to your question in the FAQs about the Panasonic NV-DS38 below.

What is a megapixel?

The number of megapixels denotes how many pixels there are in the sensor. 1 megapixel equals 1 million pixels. The more pixels, the higher the potential image quality.

What does the abbreviation 'MP' stand for?

MP stands for MegaPixels.

How can I troubleshoot if the Panasonic NV-DS38 camcorder is not recording properly?

If the Panasonic NV-DS38 camcorder is not recording properly, you can troubleshoot the issue by following these steps: 1. Check the power source: Ensure that the camcorder has sufficient power supply. If using batteries, make sure they are fully charged or replace them with new ones. If using an AC adapter, ensure it is properly connected to a power outlet. 2. Verify the recording mode: Make sure the camcorder is set to the correct recording mode. Check if the Mode Selector Switch is set to "AUTO" for automatic adjustments or to a specific mode for manual adjustments. 3. Check the tape or memory card: If recording to a tape, ensure that it is inserted correctly and not damaged. If using a memory card, make sure it is properly inserted and has enough free space for recording. 4. Adjust focus and white balance: If the recorded footage appears blurry or has incorrect colors, manually adjust the focus and white balance settings. Refer to the manual for instructions on how to adjust these settings. 5. Test the recording start/stop button: Press the Recording Start/Stop Button to start and stop recording. If the button is not responding, check if it is stuck or damaged. Try cleaning the button or consult a qualified service personnel for further assistance. By following these troubleshooting steps, you should be able to identify and resolve any issues with recording on the Panasonic NV-DS38 camcorder.

What should I do if the recording pause mode is not working on the Panasonic NV-DS38 camcorder?

If the recording pause mode is not working on the Panasonic NV-DS38 camcorder, you can try the following troubleshooting steps: 1. Check the power source: Ensure that the camcorder has sufficient power supply. Make sure the battery is fully charged or replace it with a new one. If using an AC adapter, ensure it is properly connected to a power outlet. 2. Verify the recording mode: Make sure the camcorder is set to the correct recording mode. Check if the Mode Selector Switch is set to "CAMERA" mode. 3. Check the recording start/stop button: Ensure that the Recording Start/Stop Button is functioning properly. Clean the button if it appears to be stuck or unresponsive. 4. Reset the camcorder: Try resetting the camcorder to its default settings. Refer to the manual for instructions on how to perform a reset. 5. Seek professional assistance: If the issue persists, it is recommended to contact a qualified service personnel or the manufacturer's customer support for further assistance and troubleshooting. By following these steps, you can troubleshoot the recording pause mode issue on the Panasonic NV-DS38 camcorder.

How can I troubleshoot if the recorded scene is not playing back properly on the Panasonic NV-DS38 camcorder?

To troubleshoot if the recorded scene is not playing back properly on the Panasonic NV-DS38 camcorder, you can follow these steps: 1. Check the playback mode: Ensure that the camcorder is set to the VCR mode for playback. Press the Mode Selector Switch to select the VCR mode. 2. Rewind the tape: If the tape is not rewound, press the 6 button to rewind it to the desired starting point for playback. The tape will automatically stop when it reaches the beginning. 3. Start playback: Press the 1 button to start playback. The playback indicator (!) will appear on the screen. 4. Adjust the volume: If the sound volume needs adjustment, press and hold the PUSH Dial until the VOLUME indication appears. Then, turn the PUSH Dial to adjust the volume. Press the PUSH Dial again to remove the VOLUME indication. 5. Troubleshoot playback issues: If the playback is still not working properly, try the following: - Clean the tape heads using a head cleaning cassette. - Check the tape for any damage or dirt and clean it if necessary. - Try playing back the tape on a different device to see if the issue is with the camcorder or the tape itself. If the problem persists, it is recommended to seek professional assistance or contact the manufacturer's customer support for further troubleshooting.

What should I do if the LCD monitor is not rotating frontward for self-recording on the Panasonic NV-DS38 camcorder?

If the LCD monitor is not rotating frontward for self-recording on the Panasonic NV-DS38 camcorder, you can try the following steps to troubleshoot the issue: 1. Check the power source: Ensure that the camcorder has sufficient power supply. Make sure the battery is fully charged or replace it with a new one. If using an AC adapter, ensure it is properly connected to a power outlet. 2. Unlock the LCD monitor: Check if the LCD monitor is locked in a fixed position. Look for a lock/release switch or button near the hinge of the monitor. Slide or press the switch/button to unlock the monitor. 3. Adjust the monitor angle: Once the monitor is unlocked, try adjusting the angle of the LCD monitor. Gently tilt it forward towards the front of the camcorder until it reaches the desired position for self-recording. 4. Test the rotation mechanism: If the monitor still does not rotate, check if there is any obstruction or debris preventing the rotation. Clean the hinge area and ensure smooth movement of the monitor. 5. Seek professional assistance: If the issue persists, it is recommended to contact a qualified service personnel or the manufacturer's customer support for further assistance and troubleshooting. By following these steps, you can troubleshoot the issue of the LCD monitor not rotating frontward for self-recording on the Panasonic NV-DS38 camcorder.

Is the manual of the Panasonic NV-DS38 available in English?

Yes, the manual of the Panasonic NV-DS38 is available in English .

Is your question not listed? Ask your question here

No results