Programming 31
Helpli ne T el. No.: U.K. 0844 844 3898 R.O. I. 01289 83 33
L T o cancel a selected handset,
press t again. “ Q ” disappears.
4 M 5 {V}/ {^}: Select a memory location.
i M
6 Enter the phone number or area code to be restricted (8 digits m ax.).
i M i {i c}
L T o erase a restricted number ,
press ^.
Note:
L Y ou can also select a memory location
in step 5 as follows:
Press {1 } to {6 } . i M
Registering a unit Operating additional units Addi tion al ha ndse ts
Up to 6 handsets can be registered to a
single base unit.
Import ant:
L The addit ional handset model
recommended for use with this unit is
noted on page 4. If another han dset
model is used, certain operations
(handset settings, base unit settings,
etc.) may not be available.
Additional base un it s
Handsets can be registered to up t o 4
base units, al lowing you to add
additional base units and extend the
area in which your handset(s) can be
used. If a handset move s out of range of
its base unit when “Auto ” is selected on
base unit (page 32), it looks for another
base unit to make or receive calls. A
base unit and the h andsets it
communicates with is called a “radio
cell”.
Note:
L Calls are disconnected when the
handset moves f rom one radio ce ll to
another .
Registering a handset to a base unit The supplied hands et and base unit are
pre-registered. If for some reason the
handset is not r egistered to the base unit
(for example, _ is disp layed even when
the handset is near the base unit), r e-
register the handset.
1 Handset: 1 (centre of navigator key) i
{# }{ 1 }{ 3 }{ 0 }
2 {V}/ {^}: Select a bas e unit number .
i M
L This number is used by the
handset as a reference only .
3 Base unit: Press and hold {x} for about 5
seconds, until the registration tone
sounds.
L If all registered handsets start
ringing, press the same button to
stop. Then repeat this step.
L The next step must be completed
within 90 seco nds.
4 Handset: Wait un til “Base PIN ” is displayed.
i En ter the base unit PIN (default:
“0000 ”). i M
L If you forget your PIN, see page
52.
L When the handset has been
registered successfully , w is
displayed.
Note:
L While registering, “Base in
registering” is displayed on all
registered handsets.
TG8521E(e).book Page 31 Wednesday, March 17, 2010 3:39 PM
Need help?
Do you have a question about the Panasonic and is the answer not in the manual?
Question and answer
Number of questions: 0