Programming 29
Helpli ne T el. No.: U.K. 0844 844 3898 R.O. I. 01289 83 33
5 Press the desired category numbers. i M
L The selected category number
flashes.
L T o cancel a selec ted category
number , press the number again.
The number s tops flashing.
6 {ih} Changing the base unit PIN (Personal Identification Number) Import ant:
L If you change t he PIN, please make
note of your new PIN. The unit will not
reveal the PIN t o you. If you forget
your PIN, see page 47.
1 K (middle soft key) i < i
M
2 {V}/ {^}: “Base Unit PIN ” i
M
3 Enter the current 4-digit base unit PIN (default: “0000 ”).
4 Enter the new 4-digit base unit PIN. i M i {ih}
Registering a unit Operating additional units Addi tion al ha ndse ts
Up to 6 handsets can be registered to a
single base unit.
Import ant:
L The additional handset model
recommended for use with this unit is
noted on page 5. If another han dset
model is used, certain operations
(handset settings, base unit settings,
etc.) may not be available.
Additiona l base un its
Handsets can be registered to up to 4
base units, allowing you to ad d
additional base units and extend the
area in which your handset(s) can be
used. If a handset m oves out of range of
its base unit when “Auto ” is selected on
base unit (page 30), it looks for another
base unit to m ake or receive calls. A
base unit and th e handsets it
communicat es with is called a “r adio
cell ”.
Note:
L Calls are disconnected when the
handset moves f rom one radio ce ll to
another .
Registering a handset to a base unit The supplied hands et and base unit are
pre-registered. If for some reason the
handset is not r egistered to the base unit
(for example, w flashes even when the
handset is near the base unit), re-
register the handset.
1 Handset: K (middle soft key) i N i
M
2 {V}/ {^}: “Registration ” i M
2 ti mes
3 {V}/ {^}: Select a base unit number .
i M
L This number is used by the
handset as a reference only .
4 Base unit: Press and hold {x} for about 5
seconds, until the registration tone
sounds.
L If all registered handsets start
ringing, press the same button to
stop. Then repeat this step.
L The next step must be completed
within 90 seco nds.
TG8021E(e).book Page 29 Friday, June 13, 2008 1:19 PM
Need help?
Do you have a question about the Panasonic and is the answer not in the manual?
Question and answer
Number of questions: 0