Multi-unit Operation 57
Helpline T el. No.: U.K. 0 8700 100 0 76 R.O.I. 0 1289 8333
Cancelling a base unit A han dset ca n be re gist ered to a ma ximu m
of 4 base unit s. A hand set can canc el a base
unit that it is r egistered to. This a llows the
handset to “forget” th e base un it.
1 Press {j/O K }.
2 Select “Handset Setup ”, then press
{>}.
3 Select “Registration ”, then pres s
{>}.
4 Enter “335 ”.
5 Select “Cancel Base ”, th en press
{>}.
6 Enter “0000 ” (defaul t handset PIN).
L If you ch anged the PIN , enter it ( page
30).
7 Select the base unit(s) you want to cancel, by press ing the de sired bas e unit
numbe r .
L The selec ted base uni t number(s) will
flas h.
L T o canc el a sel ected bas e unit
number , press the number ag ain. The
number w ill sto p flashin g.
8 Press {j/O K }.
9 Select “Yes ”, t hen press {>}.
10 Press {ih} . Note:
L T o register the han dset to an other base
unit or to the sa me base unit agai n, see
manual registratio n (pag e 55).
Increasing the range of the base unit
Y ou can incr ease the range of t he base un it
by using a DECT repeat er . Pl ease use onl y
the Panas onic DECT repeater noted on
page 6. Co nsult your Panas onic dealer for
det ails.
Import ant:
L Before reg istering t he repeate r to this
base u nit, you m ust turn the re peater
mode on .
T urning th e repeater mod e on/off
1 Press {j/OK}.
2 Select “Base Unit Setup”, th en
press {> } .
3 Enter “0000 ” (defaul t ba se un it PI N).
L If you changed the PIN, e nter it (p age
35).
4 Select “Other Opti ons”, then press
{>}.
5 Select “Repeater M ode”, then press
{>}.
6 Select “On ” or “Off ”, then p ress {>}.
7 Press {ih} . Note:
L After t urning repe ater mode on or of f,
cert ain icon s displa yed on the base unit
will disappea r for a momen t and w will
flash o n the hand set mom entaril y . This is
normal . The handset ca n be used once w
stop s flashing .
L While the repe ater mode is turned on,
audibl e call an nouncem ents m ay not be
hear d from the handset spea ker .
Intercom Intercom calls c an be ma de between
handse ts/ base unit in the sa me rad io cell.
Between a handset and the base unit
When a ha ndset calls the base un it
1 Handset: Press {INT } and {0 } .
TCD240E(e).book Page 57 Thursday, June 9, 2005 9:14 AM
Need help?
Do you have a question about the Panasonic and is the answer not in the manual?
Question and answer
Number of questions: 0