Base Unit Settings 35
Helpline T el. No.: U.K. 0 8700 100 0 76 R.O.I. 0 1289 8333
2 Select “Base Unit Setup ”, then
press {>} .
3 Enter “0000 ” (defa ult base unit PIN).
L If you ch anged the PIN , enter it ( page
35).
4 Select “Call Options ”, then pres s
{>}.
5 Select “Call Restrict ”, then press
{>}.
L The base unit e xtension nu mber “0 ”
and the e xtension numbers of all
registere d handset s a re displa yed.
6 Select the extensions which will be restricted by press ing the d esired
numbe r .
L Flashin g numbers indicate call
restricti on is turned o n for the
correspo nding ext ension.
L T o turn c all restricti on off for an
extensi on, press the dial key
correspo nding to its ex tension
number . The number wi ll stop fla shing.
7 Press {j/O K }.
8 Select a memory location, then press {>}.
L If the memory l ocation a lready
cont ains a res tricted nu mber , the
number i s displa yed.
9 Enter the phone number or area code to be restric ted (8 dig its m ax.), then p ress
{j/OK }.
L T o erase a restric ted numbe r , press
{C/ T }.
10 Press {ih} . Turning call bar on/off This feat ure prohibit s making out side calls
with the ba se unit. W hen call bar is turn ed
on, only intercom calls a nd calls to
emergenc y numbe rs (pag e 34) can be
made. C all bar ca n be set ind ependentl y for
the hands et (pa ge 30) and the base u nit.
1 Press {j/OK } .
2 Select “Base Unit Set up”, then
pres s {>} .
3 Enter “0000 ” (defa ult ba se u nit PIN) .
L If you c hanged the PIN, enter i t (page
35).
4 Select “Call Options ”, then pre ss
{>}.
5 Select “Call Bar ”, then pres s {>}.
6 Select “On ” or “Off ”, then pre ss {>} .
7 Press {ih} . Other options Changing the base unit PIN (Personal Identification Number) For sec urity , the base un it PIN must b e
entered w hen chan ging certa in setting s. The
default PIN is “0000 ”.
Import ant:
L If yo u change the PIN, please make no te
of your new PIN. Th e unit wi ll not reveal
the P IN to you. If you forget your PIN,
consu lt your ne arest Panason ic servi ce
centr e.
1 Press {j/OK } .
2 Select “Base Unit Set up”, then
pres s {>} .
3 Enter “0000 ” (defa ult ba se u nit PIN) .
L If you c hanged th e PIN, ent er it.
4 Select “Other Options ”, then pre ss
{>}.
5 Select “Base Unit PIN ”, then pre ss
{>}.
6 Enter the new 4-digit base unit PIN, then pres s {j/OK }.
7 Press {ih} . TCD240E(e).book Page 35 Thursday, June 9, 2005 9:14 AM
Need help?
Do you have a question about the Panasonic and is the answer not in the manual?
Question and answer
Number of questions: 0