Base Unit Settings 33
Helpline T el. No.: U.K. 0 8700 100 0 76 R.O.I. 0 1289 8333
Ringer setup Night mode Nigh t mode all ows yo u to se lect a bloc k of
time duri ng wh ich t he bas e uni t will not ring
for out side c alls. This feature is useful fo r
times when you do not want to be dis turbed,
for exam ple, wh ile slee ping. Nigh t mode c an
be set in depen dently for the hands et (pag e
28) and th e base un it.
Set the d ate and time bef orehand (page 14 ).
Note:
L T o avoid disturb ances, we recommen d
turning the call screen ing feature of f (pa ge
54) in ad dition to turning the night mode
featur e on.
Setting the st art and end tim e for night
mode
1 Press {j/OK }.
2 Select “Base Unit Setup ”, then
press {>} .
3 Enter “0000 ” (defaul t base un it PIN).
L If you chang ed the PIN, enter it (p age
35).
4 Select “Ringer Setup ”, then press
{>}.
5 Select “Night Mode ”, the n press {>}.
6 Select “Start/End ”, then pres s {>}.
7 Enter the desired hour and minute you wish to s tart thi s feature b y selecting 2
digit s for e ach.
L If you use 12-hour tim e entry , selec t
“AM ” or “PM ” by pressing {*}
repeated ly bef ore entering the time .
8 Enter the desired hour and minute you wish t o end this feature by s electing 2
digit s for e ach.
L If you use 12-hour tim e entry , selec t
“AM ” or “PM ” by pressing {*}
repeated ly bef ore entering the time .
9 Press {j/OK}.
10 Press {ih}. T urning ni ght mode on/o ff
1 Press {j/OK}.
2 Select “Base Unit Setup”, th en
press {> } .
3 Enter “0000 ” (defaul t ba se uni t PIN ).
L If you changed the PIN, e nter it (p age
35).
4 Select “Ringer Set up”, then press
{>}.
5 Select “Night Mode ”, then press {>} .
6 Select “On/Off ”, then press {>}.
7 Select “On ” or “Off ”, then p ress {>}.
8 Press {ih} . Setting the ri ng delay for ni ght mode
This s etting all ows the bas e unit to ring
duri ng ni ght mo de i f the c all er wa its lo ng
enough. After the sele cted amou nt of time
passes, the base un it wi ll ri ng. If you se lect
“No Ringing ”, the b ase unit will not rin g
duri ng ni ght mo de.
1 Press {j/OK}.
2 Select “Base Unit Setup”, th en
press {> } .
3 Enter “0000 ” (defaul t ba se uni t PIN ).
L If you changed the PIN, e nter it (p age
35).
4 Select “Ringer Set up”, then press
{>}.
5 Select “Night Mode ”, then press {>} .
6 Select “Ring Delay ”, then press {>} .
7 Select the desired setting, then press {>}.
8 Press {ih} . Note:
L When the answerin g system ans wers the
call, t his featur e does no t work.
TCD240E(e).book Page 33 Thursday, June 9, 2005 9:14 AM
Need help?
Do you have a question about the Panasonic and is the answer not in the manual?
Question and answer
Number of questions: 0