LThe printer of this unit utilises a laser. Use of
controls or adjustments or performance of
procedures other than those specified herein
may result in hazardous radiation exposure.
Fuser unit
LThe fuser unit gets hot. Do not touch it.
LDuring or immediately after printing, the area
near the recording paper exit (1) also gets
warm. This is normal.
Toner cartridge
LBe careful of the following when you handle
the toner cartridge:
–Do not leave the toner cartridge out of the
protection bag for a long time. It will
decrease the toner life.
–If you ingest any toner, drink several
glasses of water to dilute your stomach
contents, and seek immediate medical
treatment.
–If any toner comes into contact with your
eyes, flush them thoroughly with water,
and seek medical treatment.
–If any toner comes into contact with your
skin, wash the area thoroughly with soap
and water.
–If you inhale any toner, move to an area
with fresh air and consult local medical
personnel.
Drum unit
LRead the instructions on page 12 before you
begin installation of the drum unit. After you
have read them, open the drum unit
protection bag. The drum unit contains a
photosensitive drum. Exposing it to light may
damage the drum. Once you have opened
the protection bag:
–Do not expose the drum unit to light for
more than 5 minutes.
–Do not touch or scratch the green drum
surface.
–Do not place the drum unit near dust or
dirt, or in a high humidity area.
–Do not expose the drum unit to direct
sunlight.
WARNING:
LTo prevent the risk of fire or electrical shock,
do not expose this product to rain or any type
of moisture.
LUnplug this unit from power outlets if it emits
smoke, an abnormal smell or makes unusual
noise. These conditions can cause fire or
electric shock. Confirm that smoke has
stopped and contact an authorised service
centre.
For best performance
Toner cartridge and drum unit
LFor optimal performance, genuine Panasonic
toner cartridges and drum units are
recommended. We cannot be responsible for
problems that may be caused by a non-
Panasonic toner cartridge or drum unit:
–Damage to the unit
–Poor print quality
–Improper operation
LIn the printing process, heat is used to fuse
toner onto the page. As a result, it is normal
for the machine to produce an odour during
and shortly after printing. Be sure to use this
unit in an area with proper ventilation.
LTo extend the life of the drum unit, the unit
should never be turned OFF immediately
after printing. Leave the power turned ON for
a minimum of 30 minutes after printing.
LDo not cover slots or openings on the unit.
Inspect the air circulation vents regularly and
remove any dust build-up with a vacuum
cleaner (2).
LWhen replacing the toner cartridge or drum
unit, do not allow dust, water, or liquids to
come in contact with the drum. This may
affect print quality.
Fuser unit
1
2
2
FLM653FX-PFQX2394ZA-en.book Page 4 Thursday, November 24, 2005 4:57 PM
Manual
View the manual for the Panasonic KX-FLM653FX here, for free. This manual comes under the category fax machines and has been rated by 1 people with an average of a 8.6. This manual is available in the following languages: English. Do you have a question about the Panasonic KX-FLM653FX or do you need help? Ask your question here
Need help?
Do you have a question about the Panasonic and is the answer not in the manual?
Question and answer
Number of questions: 0