Pacific PR-2107 manual

6.5 · 1
PDF manual
 · 12 pages
English
manualPacific PR-2107
9.
9.

九.排除故障

異常狀
馬達不轉

原 因 處理方式

1.無電源輸入(電源線燒毀)或保險絲燒毀

2.馬達溫控跳脫無法回復

3.馬達銅線燒毀

4.電容器燒毀

5.無電源輸入(電源線燒毀)或保險絲燒毀

1.更換PC板

2.更換馬達

2.更換馬達

4.更換電容器

5.三用電表測(更換電源線)

馬達轉速變慢 1.電容器變形或電量不足

2.馬達燒毀

1.馬達銅線短路

2.出風口逆風現象(倒灌風)

1.更換馬達

2.出風口或排風管阻塞清理

1.更換電容器

2.更換馬達

風葉有反轉現象

馬達無分段速度 1.電容器燒毀

2.線路脫落

1.主控PC板失效

2.開關PC板失效

1.LED燈控制線斷路

2.主控PC 板燈線斷路

1.更換主控PC板

2.更換開關PC板

1.主控PC板失效

2.開關PC板失效

1.更換主控PC板

2.更換開關PC板

1.更換LED燈控制線

2.更換主控PC板

1.更換馬達

1.更換電容器

2.重整電線

馬達時轉時不轉

1.馬達溫控125℃跳脫, 75℃回復煮食時

溫度過高造成溫控跳脫現象

1.建議使用煮食方法稍改

2.更換馬達

2.馬達溫控跳脫時有時無

1.馬達入水造成

3.更改馬達結線, 不使用溫控

Delay Off延遲失效

LED燈兩段失效

顯示器失效

IX. Troubleshooting

Problem

Motor stops running

Possible Cause Solution

1. No power (burned power cord) or burned fuse 1. Replace the PC board
Motor speed slows
down automatically
1. Distorted capacitor or low power 1. Replace capacitor
1. Short circuit on the motor 1. Replace motor
Inverted fan blades
Motor doesn’t regulate
speed
1. Capacitor over-burned 1. Replace capacitor
2. Electrical wiring is off 2. Fix the electrical wires
Motor runs on and off
2. Motor temperature regulator comes on and off 3. Change the motor electrical wiring
and de-activate the temperature
regulator.
2. Motor temperature regulator is off and can’t
be recovered
3. Motor copper over-burn 3. Replace motor
2. Replace motor
(replace power cord)
5. No power (burned power cord) or burned fuse
5. Check power meter
4. Capacitor over-burn
4. Replace capacitor
2. Motor over-burn 2. Replace motor
2. Air comes out of the air outlet instead
of sucks up
2. Air outlet or exhaust pipe is
blocked and needs cleaning
1. Motor stops running when it reaches 125
and starts again when it cools down to 75.
This is cause by temperature running too
high during cooking.
1. Recommend changing your
cooking routine slightly
2. Replace motor
Delay-Off function
fails
1. Main control PC board failed 1. Replace main control PC board
2. PC board switch failed 2. Replace PC board switch
1. Main control PC board failed 1. Replace main control PC board
2. PC board switch failed 2. Replace PC board switch
Power leakage 1. Water got in the motor 2. Replace motor
Two sections of the
LED light not working
1. Short circuit on LED light control power cord 1. Raplace LED light control
power cord
2. Short circuit on the light power cord in the main
control PC board
2. Replace main control PC board
Display unit failed

Manual

View the manual for the Pacific PR-2107 here, for free. This manual comes under the category exhaust hoods and has been rated by 1 people with an average of a 6.5. This manual is available in the following languages: English. Do you have a question about the Pacific PR-2107 or do you need help? Ask your question here

Need help?

Do you have a question about the Pacific and is the answer not in the manual?

  • Receive updates on solutions
  • Get answers to your question

Question and answer

Number of questions: 0

Pacific PR-2107 specifications

Below you will find the product specifications and the manual specifications of the Pacific PR-2107.

General
BrandPacific
ModelPR-2107
Productexhaust hood
LanguageEnglish
FiletypeUser manual (PDF)

Frequently Asked Questions

Can't find the answer to your question in the manual? You may find the answer to your question in the FAQs about the Pacific PR-2107 below.

When should I replace the carbon filter on my extractor hood?

The carbon filter should be replaced every three to twelve months.

How often should I clean the metal hood grease filters?

The metal grease filters should be cleaned every eight to ten weeks.

Where can I find the model number of my cooker ectractor hood?

The model number of the hood is usually found on a white label inside the hood.

Is the manual of the Pacific PR-2107 available in English?

Yes, the manual of the Pacific PR-2107 is available in English .

Is your question not listed? Ask your question here

No results