Name: OSD Audio IW800
Brand: OSD Audio
SKU: 786489
Rating: 75 (1 reviews)

ClosedLooseClosedLoose

.....

......

.....

......

dog ear

18AWG minimum - for distances up to ………………………. . 10 ft

16AWG - from ……………………………………………. 10 to 50 ft

14AWG - from …………………………………………… 50 to 100ft

- Where is the best place to install the speakers

- Where do the speakers sound the best

- Try to separate the speakers 6 - 10 feet apart.

- When placing the speakers in the ceiling, try to install them

so that the xed 15 angle woofer is pointed towards the main

listening area. (For LCR model only)

- If you intend to paint the grilles, try to do so before installation.

Quick installation guide

- Pencil

- Drill

- Tape Measure

- Wire cutter

- Philips-head screwdriver

- Sandpaper

Tools needed for installation

STEP 4

Tighten the dog-ear brackets by simply turning the screws on the

slowly clockwise. The quick-turn mounting system and frame will

"sandwich" or clamp around the wall to hold the speaker securely in

place. (See Diagram 4)

STEP 1

Trace along the inclusive template. Cut along the traced line using a

drywall saw or rotary drill. A simple, inexpensive drywall saw (about

$10 at your local hardware store) is the best choice for beginners.

Caution: This is the most important part of the entire installation.

If you are not certain whether any obstructions exist behind the

desired mounting area, you should start by cutting a small hole in

the center of your penciled mounting hole with a drywall saw. Use a

piece of sandpaper to sand down the cut out edge for a smoother

contour. (See Diagram 1 and Diagram 2)

STEP 2

Run the cable into the cut out location while leaving an extra two

feet to make the connection to the speaker easier. Strip back

approximately ½” inch of the speaker cable insulation and twist

the copper wires tightly for easy insertion.

On the back of the speaker, press down on the gold-plated

compression terminal to reveal the "eye" and insert the speaker

cable through the eye for secure connection. Release the compres-

sion terminal to lock each cable securely.

STEP 3

Your in-wall speakers come from the factory with the tweeter facing

response. However, you can adjust the tweeter to focus the sound at

your listening location. In order to do this, gently press on the grill (See

Diagram 3). Caution: Do not touch the tweeter dome while adjusting for

your hearing preference. (See Diagram 3)

Diagram 1:Cutout tracingDiagram 2:Cut Out

To determine the length and the gauge of speaker wire, you will need to

measure the distance between your receiver/amplifier and the speakers.

- Always buy more than you think you would need.

- Equal wire lengths should always be used to maintain an equal

balance in sound volume.

- Sound quality is lost when using thin wire gauge over a long

distance.

- Utility knife

- Safety eyewear

- Gloves

Diagram 3:Adjust the tweeter here- - - - - - - -

Tweeter

Diagram 4:

Mounting Dog Ear

Speaker wire- - - - - - - - - - ------------------Owner’s ManualIn-Wall Speakers

---------------

AUDIO

OSD

- Measure the distance from the receiver/amplifier to the speakers.

Need help?

Number of questions: 0

Do you have a question about the OSD Audio IW800 or do you need help? Ask your question here. Provide a clear and comprehensive description of the issue and your question. The more detail you provide for your issue and question, the easier it will be for other OSD Audio IW800 owners to properly answer your question.

About the OSD Audio IW800

View the manual for the OSD Audio IW800 here, for free. This manual comes under the category Speakers and has been rated by 1 people with an average of a 7.5. This manual is available in the following languages: English. Do you have a question about the OSD Audio IW800 or do you need help? Ask your question here

OSD Audio IW800 specifications

General

Brand	OSD Audio
Model	IW800
Product	Speaker
Language	English
Filetype	PDF

Performance

Recommended usage	Universal
Multi-Room Streaming (MRS) support	✗
Suitable for outdoor use	✓
Product colour	Grey,White

Loudspeakers

Speaker type	-
Audio output channels	1.0 channels
Speaker placement	Ceiling-mountable,In-wall/in-ceiling,Wall-mountable
Number of drivers	1
Tweeter	✓
Woofer	✓
Tweeter diameter (imperial)	1 "
Woofer diameter (imperial)	8 "
Tweeter diameter	25.4 mm
Woofer diameter	203.2 mm
Number of tweeter drivers	1
Number of woofer drivers	1