Oregon Scientific PE326CA manual

Oregon Scientific PE326CA
8.2 · 2
PDF manual
 · 10 pages
English
manualOregon Scientific PE326CA
1. Press DIST until the stride length is viewed on the top line
of the display.
2. Insert a thin blunt object into HR / + to increase or MIN
/ - to decrease stride length (30 to 150 cm or 11 to 60
inches)*.
If no changes are made to the Stride function, the unit
automatically returns to clock display after 5 seconds.
NOTE Individual stride-length varies. Input an appropriate
length for an average stride. To determine length of stride
walk 10 paces and divide distance traveled by 10.
CALORIES
Precise calories burned calculations require taking many
factors into account. The PE326CA uses body weight and
the number of steps taken to give a good estimate.
1. Press CALO until the body weight is viewed on the top
line of the display.
2. Insert a thin blunt object into HR / + or MIN / - to increase
or decrease body weight setting (65 to 340 lbs or 30 to
150 kg)*.
The unit automatically returns to clock display after 5
seconds.
MOTION SENSITIVITY
Follow these important procedures to adjust the Motion
Sensitivity and ensure accurate readings:
1. Correctly position and attach the unit to a belt or
waistband.
2. Reset step counter to zero.
3. Walk at a normal pace; take at least 100 steps.
4. Adjust sensitivity switch if walking speed changes.
Repeat steps 2-4 until accurate reading is obtained.
The following conditions may cause incorrect reading
of steps taken:
1. Uneven walking pace, such as walking in crowded areas

2. Frequent up and down movements, such as standing up
and/or sitting down; running, jumping, going up and down
stairs etc.
USING THE PEDOMETER
VIEWING STEPS TAKEN
Press CALO when the unit is in clock/calorie display or press
DIST when it’s in clock/distance display.
VIEWING DISTANCE TRAVELED
Press DIST when the unit is in clock/calorie display.
VIEWING CALORIES BURNED
Press CALO when the unit is in clock/distance display.
To reset the values, press RESET in any clock display.
NOTE The total distance and calories burned will be cleared
along with the total steps.
FITNESS TIPS
           
walk 10,000 steps to burn approximately 300 calories. The
following diagram will give you some basic reference to the
calorie consumption for people of various weights.
WARNINGS
This product is designed to give you years of service if
handled properly. Observe the following guidelines:
Clean the unit with a slightly damp cloth and mild
detergent.
Never immerse the unit in water. This can cause electrical
shock and damage the unit.
Do not subject the main unit to extreme force, shock, or

Do not tamper with the internal components. Doing so
will terminate the unit’s warranty and may cause damage.
The unit contains no user-serviceable parts.
Do not mix new and old batteries or batteries of different
types.
Do not use rechargeable batteries with this product.
Remove the batteries if storing this product for a long
period of time.
Do not scratch the LCD.
Read this instruction manual thoroughly before operating
the unit.
Do not dispose this product as unsorted municipal waste.
Collection of such waste separately for special treatment
is necessary.

are subject to change without further notice. Images not
drawn to scale. The manufacturer and its suppliers hold no
responsibility to you or any other person for any damage
         
using this product.
SPECIFICATIONS
TYPE DESCRIPTION
Step counter 0 to 99,999 steps
Distance traveled 0 to 999.99 km
(0 to 999.99 miles)*
Stride distance 30 to 150 cm
(11 to 60 inches)*
Calorie display 0.1 to 9999.9 kcal
Body weight range 30 to 150 kg
(65 lbs to 340 lbs)*
Operating temp -10 to 40 °C (14 to 104 °F)
Storage temp -20 to 60 °C (-4 to 140 °F)
Batteries 2 x LR43 1.5V
Battery life 1 year
Product size 64 x 30 x 40 mm
(L x W x H) (2.52 x 1.18 x 1.58 inches)
Weight 29.4 g (1.04 ounces)
NOTE *Imperial units of measure are used on US models
only and metric units of measure are used on EU / UK
models only.
ABOUT OREGON SCIENTIFIC
Visit our website () to learn more
       
MP3 players; children’s electronic learning products and

stations; and digital and conference phones. The website
also includes contact information for our Customer Care
department in case you need to reach us, as well as
frequently asked questions and customer downloads.
     
website, however if you’re in the US and would like to contact
    
please visit:

OR
Call 1-800-853-8883.
For international inquiries, please visit:

EU - DECLARATION OF CONFORMITY
Hereby,  , declares that this Pedometer
with Calorie Counter (model PE326CA) is in compliance with
EMC directive 89/336/CE. A copy of the signed and dated
Declaration of Conformity is available on request via our


Pedometer with Calorie Counter

Model: PE326CA

USER MANUAL

EN
INTRODUCTION
   
(PE326CA).
Keep this manual handy as you use your new product. It
contains practical step-by-step instructions as well as
      
about.
KEY FEATURES
FRONT VIEW
1. COVER RELEASE: Press to open protective cover
2. Battery compartment
INTERIOR
1. CALO: Calorie measurement and weight display mode
2. DIST: Total distance and stride length display mode
3.
: Turns backlight on
4. Motion Sensitivity Switch: Increases or decreases unit
sensitivity
5. RESET: Resets display mode values to zero
6. HR / +: Changes clock hour digits; increases personal
weight and stride length values
7. MIN / -: Changes clock minute digits; decreases personal
weight and stride length values
8. Belt clip
LCD
1. PM for 12 hour format
2. Stride in Cm or Inches*
3. Weight in Kg / Lbs*
4. Distance in Km or Mile*
5. Displays when calories are shown
NOTE *Imperial units of measure are used on US models
only and metric units of measure are used on EU / UK
models only.
GETTING STARTED
INSULATION TAPE
Before using the device, pull out the insulation tape
underneath the battery cover.
NOTE The unit will not work until the tape is pulled out.
BATTERIES
To change the batteries:
1. Gently press and pull the battery compartment door.
2. Insert 2 x LR43 size 1.5V batteries or equivalent.
3. Replace the battery compartment door.
NOTE Protect the environment by taking exhausted
batteries to authorized disposal stations.
To open the cover:
Holding the pedometer upright, grasp the clip with one hand
and press the COVER RELEASE button with the other.
CLOCK
Insert a thin blunt object into HR / + or MIN / - to alter the
clock time.
NOTE The unit automatically returns to clock display after
5 seconds.
ADJUSTING THE SETTINGS
DISTANCE
Total distance = steps taken x average step length. For
greater accuracy, it is recommended that a personal stride-
length is set.
If unit shows more
steps than actual
number of steps taken,
slide switch toward “-”.
If unit shows fewer
steps than actual
number of steps taken,
slide switch toward “+” .

View the manual for the Oregon Scientific PE326CA here, for free. This manual comes under the category pedometers and has been rated by 2 people with an average of a 8.2. This manual is available in the following languages: English. Do you have a question about the Oregon Scientific PE326CA or do you need help? Ask your question here

Need help?

Do you have a question about the Oregon Scientific and is the answer not in the manual?

  • Receive updates on solutions
  • Get answers to your question

Question and answer

Number of questions: 0

General
BrandOregon Scientific
ModelPE326CA | PE326CA
Productpedometer
EAN0734811405289, 4891475206211
LanguageEnglish
FiletypeUser manual (PDF)
Technical details
Pedometer typeElectronic
Maximum number of steps99999
Step length adjustmentYes
Clock functionYes
Memory functionYes
Built-in distance meterYes
Display
DisplayLCD
Power
Battery typeLR44
Number of batteries supported2
Color
Product colorBlack
Weight & dimensions
Width25 mm
Depth125 mm
Height15 mm
Weight- g
show more

Can't find the answer to your question in the manual? You may find the answer to your question in the FAQs about the Oregon Scientific PE326CA below.

What is the weight of the Oregon Scientific PE326CA?

The Oregon Scientific PE326CA has a weight of - g.

How much should I exercise as an adult per week?

As an adult, it is recommended to do moderately intensive exercise for at least 2.5 hours per week. Preferably spread over several days.

What is the height of the Oregon Scientific PE326CA?

The Oregon Scientific PE326CA has a height of 15 mm.

What is the width of the Oregon Scientific PE326CA?

The Oregon Scientific PE326CA has a width of 25 mm.

What is the depth of the Oregon Scientific PE326CA?

The Oregon Scientific PE326CA has a depth of 125 mm.

Does the Oregon Scientific PE326CA have a maximum number of steps of 99999?

Yes, the Oregon Scientific PE326CA has a maximum number of steps of 99999, which means users can track a high number of steps before resetting the pedometer.

Does the Oregon Scientific PE326CA have a clock function?

Yes, the Oregon Scientific PE326CA has a clock function, allowing users to keep track of time while monitoring their steps.

Does the Oregon Scientific PE326CA have a memory function?

Yes, the Oregon Scientific PE326CA has a memory function, which allows users to store their step data for future reference or analysis.

Does the Oregon Scientific PE326CA have a built-in distance meter?

Yes, the Oregon Scientific PE326CA has a built-in distance meter, providing users with the ability to track not only steps but also the distance covered during their activity.

What type of batteries does the Oregon Scientific PE326CA use?

The Oregon Scientific PE326CA uses LR44 batteries, with support for 2 batteries, making it convenient and easily replaceable for users.

How do I reset the step counter on the Oregon Scientific PE326CA pedometer?

To reset the step counter on the Oregon Scientific PE326CA pedometer, follow these steps: 1. Press the RESET button on the pedometer. This will reset the display mode values to zero. That's it! By following this simple step, you can reset the step counter on your Oregon Scientific PE326CA pedometer.

Why is the distance displayed on the pedometer not accurate?

The distance displayed on the Oregon Scientific PE326CA pedometer may not be accurate due to several reasons. Here are the possible causes: 1. Incorrect stride length: The pedometer calculates the distance based on the number of steps taken and the average stride length. If the stride length is not set correctly, the distance measurement will be inaccurate. Make sure to adjust the stride length according to your own walking or running style. 2. Motion sensitivity setting: The pedometer has a motion sensitivity switch that allows you to increase or decrease the unit's sensitivity to movement. If the sensitivity is set too high or too low, it can affect the accuracy of the distance measurement. Adjust the sensitivity to a level that suits your activity level and walking style. 3. Environmental factors: The pedometer may be affected by environmental factors such as uneven terrain or interference from other electronic devices. Walking on uneven surfaces or near electronic devices can cause the pedometer to count extra steps or miss some steps, leading to inaccurate distance measurement. 4. Battery life: Low battery power can also affect the accuracy of the pedometer. Make sure to replace the batteries regularly to ensure reliable distance measurement. To improve the accuracy of the distance displayed on the pedometer, adjust the stride length, set the motion sensitivity correctly, consider the environmental factors, and ensure the batteries are in good condition.

How do I adjust the stride distance on the Oregon Scientific PE326CA pedometer?

To adjust the stride distance on the Oregon Scientific PE326CA pedometer, follow these steps: 1. Press the DIST button until the stride length is displayed on the top line of the screen. 2. Use a thin blunt object to adjust the stride length. Insert the object into the HR / + button to increase the stride length or the MIN / - button to decrease it. The stride length can be adjusted between 30 to 150 cm or 11 to 60 inches. 3. If no changes are made to the stride function, the pedometer will automatically return to the clock display after 5 seconds. It's important to note that individual stride length can vary. To determine an appropriate length for an average stride, walk 10 paces and divide the distance traveled by 10. Please note that the information provided is based on the Oregon Scientific PE326CA pedometer manual.

Is the manual of the Oregon Scientific PE326CA available in English?

Yes, the manual of the Oregon Scientific PE326CA is available in English .

Is your question not listed? Ask your question here

No results