Name: Optoma 3D-RF System
Brand: Optoma
SKU: 156834
Rating: 93 (1 reviews)

manualOptoma 3D-RF System

LED Indicators

The Optoma 3D-RF Emitter uses 5 multicolored LEDs

to indicate modes of operation or other information.

The LEDs are located on the top of the emitter close

to the joystick and display red, green, or orange.

Joystick

The Optoma 3D-RF Emitter uses a joystick to allow

the user to enable various modes and change

settings. The joystick has two axes and a center

button function. Function of the axes and buttons

are dependent on the operating mode as described

in following sections.

Modes of Operation

The Optoma 3D-RF Emitter has 5 modes of operation.

 Normal

 Sync Signal Status (Strength)

 Manual Tuning of Glasses Performance

 Pairing the Optoma 3D-RF Emitter with Optoma 3D-RF Glasses

 Set Polarity

Accessing Modes

During normal operation, the joystick is used to

access different modes of operation. Press and

hold the joystick to cycle through the available

modes. Release the joystick to select a mode. In

any mode, the normal mode of operation

resumes after 60 seconds of inactivity with the

exception of Set Polarity mode. Set Polarity mode

will time out in 10 seconds.

View the manual for the Optoma 3D-RF System here, for free. This manual comes under the category Projector accessories and has been rated by 1 people with an average of a 9.3. This manual is available in the following languages: English. Do you have a question about the Optoma 3D-RF System or do you need help? Ask your question here

Need help?

Do you have a question about the Optoma and the answer is not in the manual? Ask your question here. Provide a clear and comprehensive description of the problem and your question. The better your problem and question is described, the easier it is for other Optoma owners to provide you with a good answer.

Number of questions: 0