NEC MultiSync EA271Q manual

NEC MultiSync EA271Q
6.7 · 1
PDF manual
 · 39 pages
English
manualNEC MultiSync EA271Q
English-2

Registration Information

Cable information

CAUTION: Use the attached specified cables with this monitor so as not to interfere with radio and television reception.
For DVI, please use a shielded signal cable with ferrite core.
For HDMI, DisplayPort, USB and USB-C, please use a shielded signal cable. Use of other cables and adapters
may cause interference with radio and television reception.

FCC Information

WARNING: The Federal Communications Commission does not allow any modifications or changes to the unit EXCEPT
those specified by NEC Display Solutions of America, Inc. in this manual. Failure to comply with this government
regulation could void your right to operate this equipment.
1. The power supply cord you use must have been approved by and comply with the safety standards of U.S.A., and meet
the following condition.
Power supply cord
Plug shape
Non shield type, 3-conductor
U.S.A
2. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy, and, if not installed and used
in accordance with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
• Reorientorrelocatethereceivingantenna.
• Increasetheseparationbetweentheequipmentandreceiver.
• Connecttheequipmentintoanoutletonacircuitdifferentfromthattowhichthereceiverisconnected.
• Consultthedealeroranexperiencedradio/TVtechnicianforhelp.
If necessary, the user should contact the dealer or an experienced radio/television technician for additional suggestions.
The user may find the following booklet, prepared by the Federal Communications Commission, helpful: “How to Identify
and Resolve Radio-TV Interference Problems.” This booklet is available from the U.S. Government Printing Office,
Washington, D.C., 20402, Stock No. 004-000-00345-4.

Declaration of Conformity

This device complies with Part 15 of FCC Rules. Operation is subject to the following two conditions. (1) This device may not
cause harmful interference, and (2) this device must accept any interference received, including interference that may cause
undesired operation.
U.S. Responsible Party: NEC Display Solutions of America, Inc.
Address: 3250 Lacey Road
Downers Grove, Illinois 60515
Tel. No.: (630) 467-3000
Type of Product: Display Monitor
Equipment Classification: Class B Peripheral
Model: MultiSync EA271Q (EA271Q, EA271Q-BK)
We hereby declare that the equipment specified above conforms
to the technical standards as specified in the FCC Rules.
To see a list of our TCO certified monitors and their TCO Certification (in English only), visit our website at
https://www.nec-display.com/global/about/legal_regulation/TCO_mn/index.html
CAUTION: Please confirm the distribution system in building installation shall provide the circuit breaker rated 120/240V,
20A (maximum).

Manual

View the manual for the NEC MultiSync EA271Q here, for free. This manual comes under the category monitors and has been rated by 1 people with an average of a 6.7. This manual is available in the following languages: English. Do you have a question about the NEC MultiSync EA271Q or do you need help? Ask your question here

Need help?

Do you have a question about the NEC and is the answer not in the manual?

  • Receive updates on solutions
  • Get answers to your question

Question and answer

Number of questions: 0

NEC MultiSync EA271Q specifications

Below you will find the product specifications and the manual specifications of the NEC MultiSync EA271Q.

General
BrandNEC
ModelMultiSync EA271Q | 60004303
Productmonitor
EAN5028695116214
LanguageEnglish
FiletypeUser manual (PDF), Energy label (PDF)
Display
Display diagonal27 "
Display resolution2560 x 1440 pixels
Display brightness (typical)350 cd/m²
Response time6 ms
3DNo
HD typeQuad HD
Display technologyLCD
Panel typePLS
Supported graphics resolutions2560 x 1440
Screen shapeFlat
Pixel pitch0.23 x 0.23 mm
Backlight typeW-LED
Contrast ratio (typical)1000:1
Native aspect ratio16:9
Display number of colors16.78 million colors
Adobe RGB coverage78.3 %
sRGB coverage (typical)100 %
NTSC coverage (typical)74.6 %
Viewable size, horizontal596.74 mm
Viewable size, vertical335.66 mm
Viewing angle, horizontal178 °
Viewing angle, vertical178 °
Horizontal scan range31.5 - 94 kHz
Vertical scan range56 - 75 Hz
DDC/CIYes
Contrast ratio (dynamic)7000:1
Maximum refresh rate60 Hz
TouchscreenNo
Ports & interfaces
Built-in USB hubYes
DisplayPorts quantity2
HDMI ports quantity1
DVI portYes
DVI-D ports quantity1
USB upstream port typeUSB Type-B
USB Type-A downstream ports quantity2
Number of upstream ports1
DisplayPort version1.2
USB Type-C downstream ports quantity1
USB hub version3.2 Gen 1 (3.1 Gen 1)
HDCPYes
VGA (D-Sub) ports quantity0
Power
Power consumption (typical)37 W
Power consumption (PowerSave)0.29 W
Power consumption (max)150 W
AC input voltage100 - 240 V
AC input frequency50 - 60 Hz
Power consumption (standby)- W
E
-
21 kWh
- kWh
Energy efficiency scaleA to G
Weight & dimensions
Bezel width (side)1 mm
Bezel width (bottom)17.7 mm
Bezel width (top)1 mm
Width (without stand)611.8 mm
Depth (without stand)67.2 mm
Height (without stand)361.9 mm
Width (with stand)611.8 mm
Depth (with stand)150 mm
Height (with stand)378 mm
Weight (without stand)5700 g
Weight (with stand)9100 g
Packaging data
Package weight11800 g
Package width730 mm
Package depth217 mm
Package height475 mm
Ergonomics
VESA mountingYes
Panel mounting interface100 x 100 mm
Cable lock slotYes
Height adjustmentYes
Tilt adjustmentYes
SwivelingYes
PivotYes
On Screen Display (OSD)Yes
Plug and PlayYes
Cable lock slot typeKensington
Height adjustment150 mm
Tilt up angle range0 - 35 °
Tilt down angle range0 - 5 °
Pivot angle-90 - 90 °
Swivel angle range0 - 340 °
Other features
On/off switchYes
AC adapter includedYes
TV tuner integratedNo
Operational conditions
Operating temperature (T-T)5 - 35 °C
Storage temperature (T-T)-10 - 60 °C
Operating relative humidity (H-H)20 - 80 %
Storage relative humidity (H-H)10 - 85 %
Operating altitude0 - 5000 m
Non-operating altitude5000 - 12192 m
Sustainability
Sustainability certificatesRoHS, ENERGY STAR
391424
Design
CertificationTCP 7.0
Market positioning-
Product colorBlack
Feet colorBlack
Multimedia
Built-in speaker(s)Yes
Built-in cameraNo
Number of speakers2
RMS rated power2 W
Performance
NVIDIA G-SYNCNo
AMD FreeSyncNo
Logistics data
Harmonized System (HS) code85285210
show more

Frequently Asked Questions

Can't find the answer to your question in the manual? You may find the answer to your question in the FAQs about the NEC MultiSync EA271Q below.

What screen dimensions does my monitor have?

The size of your monitor is usually expressed in inches, 1 inch is 2.54 centimetres. The size is the diagonal size of your monitor, so you measure the screen from bottom left to top right.

What is HDMI?

HDMI stands for High-Definition Multimedia Interface. An HDMI cable is used to transport audio and video signals between devices.

What certifications does the NEC MultiSync EA271Q have?

The NEC MultiSync EA271Q has the following certifications: TCP 7.0.

What is the screen size of the NEC MultiSync EA271Q?

The screen size of the NEC MultiSync EA271Q is 27 ".

What is the screen resolution of the display of the NEC MultiSync EA271Q?

The screen resolution of the NEC MultiSync EA271Q is 2560 x 1440 pixels.

Is the manual of the NEC MultiSync EA271Q available in English?

Yes, the manual of the NEC MultiSync EA271Q is available in English .

Is your question not listed? Ask your question here

No results