NEC MultiSync EA241WU manual

NEC MultiSync EA241WU
5.3 · 1
PDF manual
 · 30 pages
English
manualNEC MultiSync EA241WU
English-6

QuickStart

For box contents, please refer the printed contents sheet provided in the box.
To attach the base to the LCD monitor stand:
1. Place the monitor face down on a non-abrasive surface (Figure 1).
2. Please rotate the stand 90 degrees as shown in Figure 1.
CAUTION: Handle with care when pulling the stand.
It may pinch your fingers.
3. Attach the base to the stand, then tighten the screw at the base’s
bottom (Figure 2).
NOTE: Reverse this procedure if you need to re-pack the monitor.
To connect the LCD monitor to your system, follow these instructions:
NOTE: Make sure to read “Recommended Use” (page 3) before installation.
CAUTION: Please tighten all screws.
NOTE: The accessories included will depend on the location where the LCD monitor was shipped.
1. Turn off the power for your computer.
2. For a PC with DisplayPort output: Connect the DisplayPort cable to the connector of the display card in your system
(Figure A.1).
ForaPCwithHDMIoutput:Connect the HDMI cable to the connector of the display card in your system (Figure A.2).
For a PC with Analog output: Connect a mini D-Sub 15-pin signal cable to the connector of the display card in your system
(Figure A.3).
For a Mac or PC with Thunderbolt or Mini DisplayPort output: Connect a Mini DisplayPort to DisplayPort cable to the
video output connector on your system (Figure A.4).
For a PC or MAC with DVI digital output: Connect the DVI signal cable to the connector of the display card in your system
(Figure A.5). Tighten all screws.

Figure A.1 Figure A.3Figure A.2

DisplayPort cable HDMI cable Mini D-Sub 15-pin signal cable
DVI cable

Figure A.4 Figure A.5

Mini DisplayPort to DisplayPort cable
NOTE: • When removing the DisplayPort cable, hold down the top button to release the lock.
• Please use a High Speed HDMI cable with the HDMI logo.
• Please use a certified DisplayPort cable.
CAUTION: Use the attached specified cables with this monitor so as not to interfere with radio and television reception.
For DVI and mini D-Sub 15-pin, please use a shielded signal cable with ferrite core.
For HDMI, DisplayPort, USB and AUDIO, please use a shielded signal cable. Use of other cables and
adapters may cause interference with radio and television reception.

Figure 1

Figure 2

Screw

Manual

View the manual for the NEC MultiSync EA241WU here, for free. This manual comes under the category monitors and has been rated by 1 people with an average of a 5.3. This manual is available in the following languages: English. Do you have a question about the NEC MultiSync EA241WU or do you need help? Ask your question here

Need help?

Do you have a question about the NEC and is the answer not in the manual?

  • Receive updates on solutions
  • Get answers to your question

Question and answer

Number of questions: 0

NEC MultiSync EA241WU specifications

Below you will find the product specifications and the manual specifications of the NEC MultiSync EA241WU.

General
BrandNEC
ModelMultiSync EA241WU | 60004676
Productmonitor
EAN5028695116504
LanguageEnglish
FiletypeUser manual (PDF), Energy label (PDF)
Display
Display technologyLCD
Panel typeTFT/IPS
Backlight typeW-LED
Display diagonal24 "
Native aspect ratio16:10
Pixel pitch0.27 x 0.27 mm
Screen shapeFlat
Display brightness (typical)300 cd/m²
Contrast ratio (typical)1000:1
Contrast ratio (dynamic)5000:1
Viewing angle, vertical178 °
Viewing angle, horizontal178 °
Response time5 ms
Display number of colors16.78 million colors
Digital horizontal frequency31.5 - 95 kHz
Digital vertical frequency56 - 75 Hz
Display resolution1920 x 1200 pixels
Supported graphics resolutions640 x 480 (VGA),800 x 600 (SVGA),1024 x 768 (XGA),1280 x 1024 (SXGA),1280 x 960,1366 x 768,1400 x 1050 (SXGA+),1440 x 900 (WXGA+),1600 x 1200 (UXGA),1680 x 1050 (WSXGA+),1920 x 1200 (WUXGA)
DDC/CIYes
3DNo
Display surface-
HD typeWUXGA
Maximum refresh rate60 Hz
TouchscreenNo
Ports & interfaces
DisplayPorts quantity1
DVI-D ports quantity1
HDMI ports quantity1
Built-in USB hubYes
USB hub version3.2 Gen 1 (3.1 Gen 1)
Number of upstream ports1
USB Type-A downstream ports quantity3
VGA (D-Sub) ports quantity1
Headphone outYes
DVI port-
Power
Power consumption (typical)15 W
Power consumption (max)47 W
Power consumption (standby)0.3 W
C
12 kWh
Energy efficiency scaleA to G
Operational conditions
Operating temperature (T-T)5 - 35 °C
Operating relative humidity (H-H)20 - 80 %
Ergonomics
Height adjustment150 mm
Height adjustmentYes
Tilt adjustmentYes
Tilt angle range-5 - 35 °
SwivelingYes
Swivel angle range-170 - 170 °
PivotYes
Pivot angle-90 - 90 °
Panel mounting interface100 x 100 mm
VESA mountingYes
Cable lock slotYes
Cable lock slot typeKensington
On Screen Display (OSD)Yes
Weight & dimensions
Bezel width (side)0.8 mm
Bezel width (top)0.8 mm
Width (without stand)531.5 mm
Width (with stand)531.5 mm
Height (with stand)515.4 mm
Depth (with stand)250 mm
Weight (with stand)6700 g
Height (without stand)- mm
Depth (without stand)- mm
Design
Product colorBlack
Market positioningHome
CertificationCE; EAC; EnergyStar 7.0; ErP; Flicker-free; ISO 9241-307 (pixel failure class I); Low Blue Light; PSB; RoHS; TCO 7.0; TÜV Ergonomics; TÜV GS; UL/C-UL or CSA; WEEE
Multimedia
RMS rated power2 W
Number of speakers2
Built-in speaker(s)Yes
Built-in camera-
Packaging content
Cables includedAC, DisplayPort, USB
Quick start guideYes
Performance
Flicker-free technologyYes
Low Blue Light technologyYes
NVIDIA G-SYNC-
AMD FreeSync-
Sustainability
Sustainability certificatesRoHS, ENERGY STAR
391609
Other features
TV tuner integrated-
On/off switch-
Logistics data
Harmonized System (HS) code85285210
show more

Frequently Asked Questions

Can't find the answer to your question in the manual? You may find the answer to your question in the FAQs about the NEC MultiSync EA241WU below.

What screen dimensions does my monitor have?

The size of your monitor is usually expressed in inches, 1 inch is 2.54 centimetres. The size is the diagonal size of your monitor, so you measure the screen from bottom left to top right.

What is HDMI?

HDMI stands for High-Definition Multimedia Interface. An HDMI cable is used to transport audio and video signals between devices.

What certifications does the NEC MultiSync EA241WU have?

The NEC MultiSync EA241WU has the following certifications: CE; EAC; EnergyStar 7.0; ErP; Flicker-free; ISO 9241-307 (pixel failure class I); Low Blue Light; PSB; RoHS; TCO 7.0; TÜV Ergonomics; TÜV GS; UL/C-UL or CSA; WEEE.

What is the screen size of the NEC MultiSync EA241WU?

The screen size of the NEC MultiSync EA241WU is 24 ".

What is the screen resolution of the display of the NEC MultiSync EA241WU?

The screen resolution of the NEC MultiSync EA241WU is 1920 x 1200 pixels.

Is the manual of the NEC MultiSync EA241WU available in English?

Yes, the manual of the NEC MultiSync EA241WU is available in English .

Is your question not listed? Ask your question here

No results